What is the little eye on the side of the ignition switch for

The power is insufficient, the ignition is affected, and it is easy to catch fire.

1. Whether the steering wheel is in a state of deadlocking. The solution is simple, as long as you hit the steering wheel hard and twist the key at the same time, you can generally unlock the steering wheel lock quickly, and the ignition is an instantaneous thing.

2. Did you not return the gear to P gear when you parked? Think about it, if the D or R gear can be ignited, the jump of the vehicle at the moment of ignition is undoubtedly a huge safety hazard. Therefore, for automatic transmission vehicles (AT, CVT, AMT), manufacturers will preset this mode, and repeatedly inform in the manual:

Make sure the gear is in the P position when ignition.

3. One-button start sometimes encounters the trouble of power loss of the smart key, obviously the key is in the car, but the instrument always shows 'key matching error', this situation is likely to be the power loss of the smart key, and the start system can not sense the weak radio waves emitted by the key. Therefore, it is recommended to pick up the smart key and put it on the start button, and then press the button to start.

4. Check whether the battery has electricity. If the ignition is not ignited, it may be due to the loss of power or the expiration of the battery life due to the long-term headlights have not been turned off, and the battery is generally replaced in time according to the maintenance manual.

5. See if there is oil. If the fuel gauge shows that it is below the red line, it will not ignite. At the same time, pay attention to the quality of the oil. There have been car owners who found that there was water and mud in the fuel tank after disassembling the car, and with such oil, it is impossible for the car not to break.

6. No antifreeze is added.

Some car owners add water or inferior antifreeze to the car, resulting in a particularly cold winter, causing the entire waterway to be frozen, the engine to be frozen and cracked, resulting in the car water pump can not operate, can not catch fire, and injure other parts of the engine.

There are signs for Engstat and EngStop on it, one near the gear lever and one near the ** air outlet.

It is estimated that it is the sound transmission hole of the microphone, so let's take a picture.

Of course not, the small mouth is just a channel, and it will only pass when the source (gas tank) is opened, and if it is not ignited after opening, it will be dangerous, and after ignition, a chemical reaction will occur to consume the gas discharged.

Return to Lumen Mountain Song at night (Meng Haoran).

Are you a rescuer brought in by the monkeys? If the switch is not turned on, how can it leak.

The small hole of the pressure reducing valve mated to the liquefied gas cylinder is balanced atmospheric pressure and cannot be blocked, and it is not connected with the liquefied gas (closed with a diaphragm).

If the small eye on the PS layer plate is displayed, it means that the layer is visible, and if the eye in front of the layer is not visible, it means that the layer is hidden. As shown in the figure, the layer of the eye shown in the figure is the visible layer part on my **. What is invisible to the eye in front of the layer is the hidden layer.

Beautify your eyes, you can make your eyes bigger, and so on.

If the dot is gray, it means that it is not displayed.

If the dot is black, it means that it is displayed.