How do I clean a fountain pen nib? How do I clean the nib of a fountain pen?

After rinsing, wrap the tip of the pen in a paper towel or handkerchief, shake out the remaining water, spin it off and let it dry in a ventilated place. Therefore, it is best to do the pen washing work before going to bed, and the time is just right for one night. For other pens where the ink tube cannot be plugged out, a method similar to "gargling" is used to fill the pen with empty ink and then empty it, and so on.

The trouble with this method is that it is difficult to clean thoroughly. You can soak the pen in clean water and wait for the residual ink to diffuse. Well, it's another night, get up early tomorrow morning, take the pen out of the water, and repeat the "shake the pen" and "blow the wind" in the previous paragraph.

Get some sleep and you're ready to use it at noon. Or another way to save time and effort but burn money, buy an ultrasonic cleaner and throw the pen in.

If you are using dye ink, then dip the tip of the pen in warm water and pinch the ink gall repeatedly, and then drain the water in the pen when the water is black, change to a glass of warm water and repeat the above steps. Until the water is clear. Then soak it in water for two days, and then wash it again according to the above method.

Then drain the pen and let it dry. If the pen is not removed, it will take several days to dry. If you have used carbon ink or other pigment ink, you should disassemble it and clean it with a double-sided blade and toothbrush.

Of course, it is better to use an ultrasonic cleaner. Because the precipitate produced by the pigment ink is insoluble in water, the pen must be disassembled. A treasure can buy special tools, and the seller will provide tutorials.

I provide a more partial method here, when I was in junior high school, I had a fountain pen, but I didn't use it every day, and I used carbon ink, sometimes I will find that there is a black solid in the gap between the pen head, my solution is to remove the pen head, and then scratch my head desperately, find a thinner hair loss, and then carefully pull it out through the gap, so that it will be very clean in the future, and this method will probably have two more serious consequences, the hair may be broken and then left a little in it, If you have thicker hair, you may find that the amount of water you produce from your pen has increased after a few times.

If it's just the marks on the nib after cleaning the ink, I usually remove the ink applicator and pour ink directly into the ink applicator, and the nib is generally relatively clean. Remove the ink sac, find a thin towel or thick paper towel, wrap the nib and tongue of the pen, pull it forward, and the whole achievement is out. Remove the nib, if you can't get it out, you can take a small blade and pry it, if there is ultrasound is the best, throw it into the ultrasound piecemeal; If you don't have an ultrasound, you can also soak it in water overnight.

It acts like a sponge, cushioning and stabilizing the ink between the ink sac and the nib, and balances the internal and external air pressure. It must be disassembled to be cleaned, and the method of disassembly is different for each pen, but the pen in Figure 1 is visually a petit from Baile or a preppy from platinum, in short, it is not an expensive fountain pen, then this is easy to do: grab the nib and the body of the pen with both hands, rotate tentatively in the opposite direction, pull it out, and under normal circumstances, you will be flown into a body of ink, and then see 3 parts:

Metal nib, plastic tongue and capillary reservoir in one, as well as the body. Wash it well, dry it and plug it back in.

Soak in warm water for half an hour, generally on the line, hero 100 to be disassembled, can not be disassembled directly, or disassemble and wash the best, of course, what is the washing liquid, ultrasonic cleaning machine is better. Generally, just soak in water, and the pen water is water-based, and it can't be dried.

I will talk about my own habits, generally broken ink, not the problem of the pen or the problem of ink, so I will generally use the elimination method, first clean the pen as a whole, fill it with water mixed with a little ink, try to write to see if there is a fault, if it is good, change the ink, see if other brands have this problem, if it is other inks are also like this, it means that the place where the pen head comes out of the water is too fine, generally I will use the pen a little heavier, and the head will be slightly opened, and then it will be written more smoothly. However, remember that every time you change the ink, you must wash the original one, and there can be no residue, remember.

Dismantle the pen, soak, wash, cool and dry.

Try it overnight in warm water, and there is also a special pen cleaning solution. If you really can't clean it and you are confident enough in your own hands-on ability, you can try to disassemble and clean it, but there is a risk of breaking it. You can also go to the counter and ask if there is a cleaning service.

1. Disassemble the pen. First, open the pen cover and remove the nib part (also known as the pen grip part) from the barrel. This step is usually done by unscrewing directly from the junction between the barrel and the grip.

If the pen uses an ink sac or inking applicator, remove it from the grip of the pen. To save, the ink in the ink sac or inking applicator can continue to be used after cleaning, and the opening of the ink sac or inking applicator can be sealed with tape to prevent the ink from evaporating.

2. Rinse the grip of the pen in a stream of water for a few seconds, so that you can wash away the ink that is easy to remove and prepare for the next step. To clean a fountain pen, use cold or room temperature water, as hot water may deform or damage some parts.

3. Prepare a glass of clean water and soak the pen grip in it. When the known color of the water is darkened by the ink, change to a glass of water. Repeat until the water is still clear after soaking for one hour.

Note that some inks, especially those that are highly saturated or waterproof, take longer to clean completely.

Generally speaking, soaking in tap water is fine, but if the mineral content of tap water is high, it may be safer to use distilled water.

4. Take the pen grip part out of the water and let it dry for 12-24 hours. For best results, place the nib facing down in a soft, smooth cloth or tissue cup to draw the water out of the nib.

5. After the grip of the pen is dry, install the ink sac or ink applicator (if any) and rotate it back to the pen barrel.

As the most important part of the fountain pen, regular cleaning and maintenance can maintain the good use of the fountain pen

Remove the nib: Gently remove the nib by hand, if it is a daily cleaning, you don't have to remove the nib every time, just clean it directly;

Rinse with clean water, and if the pen is left for a long time, you can also soak it in alcohol to remove the solidified ink;

Wrap the nib of the pen with a paper towel or handkerchief, leave a finger gap in the middle, shake out the residual water, and put it in a ventilated place to dry after spinning.

Expensive cleaning method: If you have an ultrasonic cleaner at home, you can clean it directly.

Note: When the nib is difficult to remove, do not forcibly disassemble it, otherwise it is very easy to damage the nib;

Do not wash the fountain pen with boiling water or overheated water, otherwise it will cause damage to the fountain pen.

Soak the nib of the fountain pen in vinegar, suck it up and then squeeze it out, repeat it many times, and then suck and squeeze it several more times with water to wash the dregs in the nib of the fountain pen.

Cleaning the fountain pen with a small, soft-bristled brush will do. Soak the pen in clean water for 10 minutes and pull the nib out. Gently brush the tip with a small bristle brush. Suck and spit out the gallbladder, and repeat it a few more times.

The steps to clean the nib of a fountain pen are as follows:

Step 1: Clean your hands to avoid dirt staining the nibStep 2: Empty the ink in the ink sac and inhale the water.

Step 3: Empty the water in the membranous sac and reciprocate several times.

Step 4: Place the pen under the tap to rinse.

Step 5: Wrap the nib of the pen with a paper towel or handkerchief and shake out the remaining waterStep 6: Place the spun pen in a ventilated place to dry.

Note: It generally takes one night to dry the pen, so it is recommended to clean the pen at night before going to bed.

Use vinegar, preferably aged vinegar, or alcohol.

Here's how to clean the nib of a fountain pen:

1.Remove the nib: Remove the nib first to make it easier to clean.

2.Rinse with water: Place the nib of the pen in warm water and rub gently. You can wipe the nib with your fingers or a soft-bristled brush until the surface of the nib is clean. If there are stains on the nib that are difficult to clean, you can add a small amount of mild detergent.

3.Rinse well: Rinse the nib with clean water, making sure there is no detergent or stain left on the nib.

4.Wipe dry: Gently dry the nib with a soft paper towel or absorbent cotton cloth, then blow dry with a hair dryer to ensure that the surface of the nib is completely dry.

5.Install the nib: Attach the cleaned nib back to the pen body to ensure that the installation is secure.

Notes:1When cleaning the nib of a fountain pen, do so gently to avoid damaging the nib.

2.Do not wash the nib with overheated water, so as not to affect the life of the nib.

3.After cleaning, the nib needs to be dried thoroughly to ensure that the surface of the nib is dry, otherwise it may affect the smoothness of the pen and ink.

It may be that the nib of the pen is blocked, and you can use a razor blade to scratch the fine slit on the nib; Or the gap between the nib is too tight, so you can insert the blade into the gap in the nib and pry it gently – be careful not to use too much force to avoid breaking the nib.

If you want to clean the nib thoroughly, first distinguish between the two types of nibs. If your pen is a wrap-tip type – the kind where the nib is smaller, mostly wrapped in it, and the roots are almost rolled into a small metal tube – you can pull it out with a nail clipper gently holding the nib – note: not every nib can be pulled out like this, but most of the ones I've tried do.

If your fountain pen is an open-pointed type – that is, the one with a larger nib that is exposed, some of which can be pulled out with nail clippers, and some of which are fixed with screws – can be easily identified if you look closely.

Warm water is sucked into the fountain pen and rubbed at the hose of the fountain pen to remove the ink sediment attached to the hose.

If your pen is a tip type, you can also try this method, but this step requires a little trick: pinch the small plastic tube inside through the hose, then push the tip of the pen in the direction of the nib, and eject the tongue out to clean. This method is not suitable for all pens either, and if you are not sure or do not succeed the first time, it is best not to try again to avoid breaking the small plastic tube.

Remember to soak your new fountain pen in hot water before using it, as most nibs are coated with a layer of wax to protect the nibs at the factory.

After using the steel notes, you must cover the cap, otherwise the ink will settle on the nib after evaporation.

Try not to use carbon ink, because this ink has glue added to it, probably to allow the carbon particles to be better suspended, so it is also easier to clog the nib. If you want to change the ink, you should clean the pen first to avoid the reaction of different inks and precipitation.

1. Step 1: Dismantle. First, separate the head and bottom of the fountain pen, and the general fountain pen only needs to be unscrewed directly from the connection between the pen barrel and the pen grip part.

2. Step 2: Rinse. Cha Huchun rinsed the part of the pen under the faucet with water for a few seconds, so that it is easier to wash off the ink.

3. Step 3: Soaking. Take a glass of clean water, soak the pen grip part in it, and when the color of the water is stained, change another glass of water and repeat several times until the water does not change color.

4. Step 4: Dry. Prepare a thicker piece of toilet paper, then place the pen tip down on the toilet paper and let it rest.

It can be seen that the cleaning of the fountain pen is not so troublesome, and the whole set of steps can be completed within half an hour, and the most time spent is the soaking process.

In case of the situation that the fountain pen is not smooth, the fountain pen can be broken down and disassembled. Be sure to decompose according to the actual situation of your own pen, and don't force it to decompose.

Soak the disassembled fountain pen in warm water. The pen water that remains precipitated on the pen and solidifies can be wiped clean after soaking and softening, and the pen water can be re-added.

There are several reasons why the fountain pen is not good for launching:

1. The reason why the fountain pen is not smooth.

The reason why the fountain pen does not run smoothly is because there is a blockage between the refill and the nib, so when writing with the pen, the water does not run smoothly.

2. The reason why the pen is not smooth and blocked.

The pen water is not smooth and blocked, generally because the quality of the pen water is not good and there is too much sediment. In particular, the use of some ink and other fountain pen water is more likely to cause blockage between the nib and the refill.

3. Caused by air drying.

Sometimes when using a fountain pen, you must buckle the cap in time after use. Often do not buckle the cap, resulting in air drying at the nib, and the pen water often solidifies on the nib, which will also cause the pen to run unsmoothly.

There are five steps to how to clean a fountain pen. Preparation: appropriate amount of water, water glass. The following are the specific steps to clean the fountain pen:

Steps.

Remove the pen and remove the nib from the bucket.

Remove the pen, remove the nib part from the barrel of the pen, and do it by rotating the nib to make contact with the barrel of the nib.

The nib part of the pen is placed in tap water.

Place the nib section in a tap water cup for a few seconds.

Soak the nib in water.

Soak the nib part in clean water. Replace the water when the ink is saturated. Repeat until the water remains clean.

The nib is dry for 12-24 hours.

Remove the nib from the water and let it dry for 12-24 hours.

Attach the cartridge nib and screw it back into the barrel.