How to adjust the drift of the fishing trip? How to adjust the stroke drift

Many fishing friends ask, what should be paid attention to when playing the itinerary, how to achieve better results, and today I will share with you the matters that need to be paid attention to when playing the itinerary. Mainly start with these points!

The method of adjusting the drift of the fishing stroke is as follows:

When adjusting the drift, adjust the eye. Regardless of fine tail drift or coarse tail drift. The best way is to drift with a hook 0 1 mesh. If the set mesh is too high when adjusting the drift, it is not easy to distinguish the fish signal. When small fish chase bait, due to the large buoyancy of the float and the high fishing eye, the reaction is not obvious.

How to fish the course:

1. Reduce the specific gravity of bait fishing stroke. This method is easy to understand, the bait is lighter, the fall will naturally be slower, and it is more conducive to the fish to feed. At this time, it is a better choice to pull the bait, because the specific gravity of the pull bait is significantly smaller than that of the rubbing bait.

It is better to add some atomization, but do not atomize too much, otherwise the fish mouth will be more messy.

2. Extend the long line fishing stroke. This method is mainly to achieve the purpose of fishing stroke by increasing the secondary hem time of the subline. Use alone for fish that are 1 to 2 strands long from the bottom of the fishing layer.

If the strand is too long, it will lose a certain sensitivity, so it is advisable to fold the strand in half at 60 to 70 cm.

3. Fly lead fishing itinerary. The so-called flying lead is to push the lead seat and the two space beans that fix the lead seat to the floating direction, which is actually similar to the effect of the extended strand line. As for how much to push up, try to determine it during the actual fishing process.

Because the lead seat moves in the direction of the float will bring inconvenience to the casting rod, it is necessary to consider the convenience of throwing the rod comprehensively.

4. Long-tail floating fishing itinerary. There are many types of long-tail floats. To put it simply, there are long-legged long-legged long-tailed floating, short-legged long-tailed floating, long-legged short-legged long-tail floating, and short-legged short-legged long-tail floating.

The drift of the fishing itinerary is as follows:

First, suitable floating. The fishing itinerary should have a very compatible float, it is best to use the "jujube kernel type Shoubi" long drift, the tail of the drift should reach more than 15 meshes, and the drifting feet are also very long, only this kind of drift has a very ideal "stroke" when falling in the water.

Second, the correct drifting. The drift of the fishing itinerary is relatively easy, because we don't need to pay attention to the problem of fishing purpose, how much the fishing mesh is, and directly hang the bait to find the bottom after adjusting the drift, this is because we only fish the process of falling, once the hook bait has fallen to the bottom, the rod has been raised.

Three, different drift phases. The fishing itinerary has its own unique drifting system, and with the stroke fishing method, forget about the drifting phase such as Datonkou and black drift. In fact, once the hook bait is in the water, the angler's empty journey begins, and its loss of drift should be paid attention to at any time, although the float is not yet standing.

So what is the drift phase of the fish drift in the itinerary? The first is the sudden acceleration of the float, the second is the sudden pause and fall, and the third is the phenomenon of the top when falling.

The fishing stroke is also called the fishing interface, or intercept, which is mainly used for two kinds of fish. The first is that the fish situation is a bit messy, the water layer where the fish is in a mess, and the water layer where it is unstable is used. The second is the situation that the fish float up due to weather reasons, such as hot and humid weather, or the water temperature and dissolved oxygen in the middle and upper layers are more suitable, resulting in changes in the water layer where the fish are located.

For example, good weather in mid-spring, light rain in summer, fine weather in late autumn and early winter, etc., there may be weather reasons that cause fish to float. Fishing stroke is a dynamic fishing technique, and the signal appears at the time when the float turns over and the float is in place.

Here's how to properly tune the drift for fishing

First of all, it is necessary to understand the working principle of drifting, that is, the gravity of the bait, hook, plumb, space bean, fishing line and the buoyancy of the fish float form a state of equilibrium in the water. This equilibrium is upset by the bait, and the fish behaves accordingly on the float.

Therefore, the adjustment of drift is to change the state of the bait and strand in the water by adjusting the weight of the plumb sinker and the depth of the float, so as to tune out the "spirit" or "ton" fishing method.

Level the water. First, first hang the heavy lead skin to sink the bottom, test the water depth, adjust the float out of the water, and then check whether the bottom is flat before and after, and try to find a flat position to facilitate the nesting of fish. Then adjust the float to be flush with the water surface.

At this point, the length of the line is the depth of our fishing.

2. Pull the float down for a distance (need to exceed the length of the strand to ensure that the double hook is off the bottom), and gradually reduce the weight of the lead skin until the top of the float is level with the water surface again. Keep in mind that the lead skin needs to be cut slowly and gradually, as too much of the float will expose too much of the water.

At this time, the hook must be in a state of sinking to the bottom, which is a more blunt fishing method, or you can level the water without a hook, and the plumb sinker is more abrupt to the bottom. Of course, there are advantages and disadvantages of fishing, which need to be used reasonably according to different situations:

Advantages: 1. The wind and waves on the water surface are too large and the water flow of the river is urgent, so you can fish the bottom and float.

2. Apply the grain and wheat grain fishing method, and the heavy lead sinks to the bottom to reduce the vigilance of big fish, which is convenient for slight teasing fishing in the horizontal direction of the bottom water, and can filter the action of small fish touching the bait.

3. In waters with too many small trash fish, heavy lead fishing can speed up the sinking speed and prevent trash fish from chasing bait. And at the bottom of the water, filter some trash fish to make a nest of drift phases.

<> "How to adjust the drift of wild fishing?

1. The purpose of drifting.

There are many states after the hook is hung with bait, such as one hook touching the bottom, one hook returning to the bottom, double hook off the bottom, etc., but in the real fishing process, the water conditions, fish conditions will continue to change.

2. Adjust the drift of the fishing mesh.

Therefore, when adjusting the fishing target, it can be decided according to personal habits, for example, other anglers like to fish high mesh, and we are not good at this way of fishing, so we still decide the final fishing target according to our own personal characteristics.

3. How to accurately adjust the drift.

First, find the bottom first.

After selecting the fishing spot, use heavy lead to find the bottom until the float is out of the water or flat water. Starting from the center of the fishing spot, continuously test the water depth within 1 meter of the surrounding area to fully understand the best position of the fishing spot, which is more conducive to later fishing.

Second, roughly find the fishing eye.

Once you know the depth of the water, pull the float down beyond the length of the float's drain, and now start to trim the lead skin in earnest. In the early stage, you can cut a little bigger, wait until the float slowly sinks, and then cut little by little when trimming the lead skin, which can greatly reduce the drifting time, and stop trimming the lead skin when the float floats to the number of meshes that the angler wants.

3. Accurate bottom-up.

After remembering the weight of the "base bait", hook the base bait, pull up the float 7-8 mesh and throw it into the fishing point, at this time the number of eyes exposed by the float is the distance between the lower hook and the upper hook, such as the float exposed at this time.