How to use Telecom ADSL to access the Internet and want to access the Internet on two computers at t

1.Buy a cat with a function to lead the way, (if the telecom gives it, it will save trouble), and then read the manual, configure it, so that the cat can automatically dial, and set the username password into. Usually your two machines are set to automatically get the IP and that's fine.

2 The cat is connected to host 1 The host 1 is connected to the host 2 through a network cable.

Host 1 to the Control Panel, select Broadband Connection, Properties Advanced, Internet Connection Sharing, tick, Home Network Connection, select the network card connected to Host 2. Are you sure.

The NIC that hosts 1 connects to host2. On host 1, leave the IP mask gateway blank.

Host 2, IP Mask Gateway.

You need to use the routing function.

I'm just using the router, ** offline connected to adsl modem and then connected to the router. The router can be divided into several computers in parallel. Now a 5-port router costs 180 yuan.

The specific breakout and setting methods are described in the manual of the router.

With a router, ordinary routing is OK, TP-Link or D-Link is recommended, **100 or so, and then two network cables, the length is determined according to your actual situation (but not more than 100 meters, too long signal attenuation), connect the router to the power supply, and then connect a network cable to a computer, according to the operation manual, set the ADSL account and password to the router.

After the setting is completed, connect the ADSL cat and the router with a network cable (you can use the network cable that comes with the cat, which is the one that the cat was connected to the computer before), and then use another purchased network cable to connect the router to the second computer.

In this way, two computers can surf the Internet at the same time without affecting each other.

One switch, one router.

Connection: ** Wire Broadband Modem Route Switch Computer.

Settings: Open IE, enter, username and password are admin, enter router settings, IP address settings, subnet mask, gateway. You can access the Internet when you turn it on, you can log in to the Internet, or you can use a local area network.

Hello! There is no need to use two routes, but the cable drawn out of the LAN port can be hung up for multiple computers to share, if it is a neighbor, it is enough to use a wireless router!

Two wireless routers can be connected.

The first router is set up as shown below.

The second router is set up as shown below.