The Nikon S2500 can t turn on the machine, and after taking the battery, it can be turned on after t

Why is your problem exactly the same as mine, my 2500 has also been in the drawer for about a month, and when I take it out and use it, I can't turn it on, and it's fine from the installation board. Not only is the key to view ** useless, but even the lens is retracted after a standby time of more than one minute. It doesn't work anymore.

I rely on, my S2500 is also like this, after the 1-year warranty period, it has become like this, the mud pit maintenance department said that the motherboard is broken, and it costs 150 yuan to repair it.

It is very likely that you played back that key failed, and it kept touching, which caused other keys to not work properly, so it couldn't turn on, you try to see if you can fix the playback key. I'm pure speculation, but it's not nonsense.

If you can use [i] battery, [i] it is no problem, [i] no[ i] can use it, and then put a good [i] battery [i] into your [i] machine [i] and wipe it to see if it can [i] no [i] can [i] turn on [i]. 3. The problem of [i] on the [i] motherboard [i] of the phase [i] machine, this [i] must be [i] solved after [i] is sold[i]. Hopefully, your camera [i] will be repaired soon.

Nikon S2500 uses EL19 battery, because the two ends of the battery are symmetrical, so it is easy to install errors, when the owner of the building installs the battery, pay attention to the electrode lift of the fuselage!! The first problem you report should be this situation, the battery is installed upside down!!

The second problem, it may be that you unintentionally pressed the playback button, resulting in booting (digital camera can also be turned on by pressing and holding the **playback button), since you have entered the playback state, at this time pressing the playback button will definitely not respond, the normal situation should be to press the shutter button to enter the shooting mode! The landlord can try it as I say!

On the metal sheet of the battery connector, sandpaper it or scrape it a few times with a razor blade.

Same question, same question, nnd, asked, everyone's questions are like this.

This situation is caused by leakage of the operating key thin film circuit, which is caused by moisture, water ingress and other reasons. You can put more desiccant and dry it in a sealed drying oven for a week to see if it has any effect.

The camera is a precision optical electronic device, and its density is very high, if you can't repair it yourself, you should send it to a professional shop for repair.

It's a southerner, try it with a hair dryer on a slightly hot setting for ten minutes.

If there are no other prompts, check if the battery is charged.

Hello. Sorry, but considering the particularity of each model, it is recommended that you go to the MIUI forum.

Post a post in your model area for help, and the enthusiastic players will help you solve it!

Battery failure bar! You can change the battery to try! Your battery is only enough to turn on once!

It could be a memory card issue. Try a different card. As if you had asked the question.

Nikon P5100P6000VS is a good civil machine.

Yes, just like your other hands.

The machine replaces the battery, there is no difference.

The power is out.

There is also a broken battery.

Let's see if there is any problem with the charger.

This has just been charged for a few seconds, and if you look at this picture, he is full? It should be a battery problem, you buy the battery of the Nikon CoolPixS3200 camera in Gome, Suning, and JD.com, and replace the battery to solve it!

You can't solve it yourself! To the professionals.