The drum washing machine is dirty after moving, how do you clean it?

The inside of the washing machine looks very clean at first glance, but there is a sleeve outside the washing cylinder, and the laundry water flows back and forth between these two mezzanines, and over time, a large amount of dirt will be attached to the mezzanine. These dirts not only seriously pollute the clothes during laundry, but also endanger human health. Therefore, we need to wash the washing machine frequently and disinfect it.

Generally speaking, a newly bought washing machine should be cleaned and disinfected every two or three months after it has been used for half a year.

The cleaning procedure is as follows:

1.Unplug and turn off.

2.After the sponge is dipped in neutral detergent, wipe off the limescale inside and outside the sink, and then scrub it with a rag, and the thin seam edges can be brushed with an old toothbrush.

3.Gently remove the batting filter, reverse the inner surface, and brush it with an old toothbrush under the faucet.

4.The shell and operation keyboard part of the body should be wiped with a wrenched rag and an old toothbrush diluted with neutral detergent, then wiped clean with clean water, and dried as soon as possible.

5.Remove the plastic hose that connects to the faucet and wipe the nozzle and surface with an old toothbrush.

Cleaning precautions for washing machines.

1. Store in a relatively ventilated and dry place, avoid storing in the bathroom.

2. The lower drain must be higher than the drainage pipe, and the water cannot remain in the drainage pipe.

3. When not in use, take off the filter bag and dry it outside, so that it can be fully dried.

4. Take out the clothes to dry immediately after washing, and don't get stuffy in them.

5. After washing clothes, be sure to drain the water in the washing machine and open the lid to dry, so as to avoid the residual water forming a breeding ground for microorganisms in the machine.

6. It is best to flush the drainage pipe with clean water after each use.

7. After the washing machine with the top door is used, the water inside it should be wiped dry with a dry rag, and the washing machine with the side door should also be wiped dry with the water embedded in the gasket at the door to avoid breeding mold.

Details: An An: Pick this.

1. Use bleach.

Fill the washing machine with more than half a bucket of water and mix it with about 400ml of bleach. Unscrew the washing machine, let it turn, and start wiping. Half an hour later, the bleach had cleaned the dirt out of the inner bucket.

The washing machine drains, because there is still some bleach left in it, so it needs to be stored once, and then drained thoroughly.

2. Use special cleaning agent for washing machines.

With this specialized cleaning agent, the damage to the washing machine itself is not too great. Find a large bucket, pour water and descaler, and mix it in the ratio of descaler to water = 1 2. Then pour in the prepared special detergent and stir well.

After the washing machine has been running for about 20 minutes, find a bucket to drain the water. The drained water is then poured into the washing machine, and it is discharged repeatedly - pour it in, and it can be stopped when it feels clean. Finally, rinse the inside of the washing machine, put the drain back in place, and drain the water.

3. Soak in hydrogen peroxide.

You can go to the pharmacy and buy 1 bottle of hydrogen peroxide, which is the kind of ** that is about 1 yuan. Mix the hydrogen peroxide with water and pour it into the washing machine, then add an appropriate amount of washing powder, let the washing machine start stirring, and stop turning when the foam comes out. Then soak for about 3 hours, which can be a good antivirus and bacteria.

Rinse it off at the end.

4. Use disinfectant.

It can be cleaned with a disinfectant mixed with water, and the specific ratio is stated on each bottle of disinfectant. Soak the washing machine in water mixed with disinfectant for about 30 minutes, the disinfectant has a certain corrosiveness, so it should not be too long. Then one last wash is done, and it's done.

1. Unplug and turn off the power.

2. After the sponge is dipped in neutral detergent, wipe off the scale inside and outside the sink, and then scrub it with a rag.

3. Gently remove the cotton wool filter, reverse the inner surface, and brush it with an old toothbrush under the faucet.

4. The shell and operation keyboard part of the body should be wiped with a wringed rag and an old toothbrush with diluted neutral detergent, and then wiped clean with water and dried as soon as possible.

5. Remove the plastic hose connected to the faucet, and use an old toothbrush to wipe the nozzle and surface clean.

Wipe it with a rag, preferably without rinsing it with water.

Here's how to clean up dirt in a front-loading washing machine:

1. Clean with a special detergent for washing machines.

Fill the laundry bucket with clean water to the highest water level, then pour the detergent into the laundry bucket, run for five minutes to fully dissolve the detergent, if the washing machine can be heated, it can be heated to 40 degrees, then turn off the power of the washing machine, soak for about an hour, and then wash according to the daily washing mode, when the washing machine stops, a large number of dirt fragments will float on the water surface.

2. Use drifting agent to clean the washing machine.

Add an appropriate amount of chlorine-containing bleach to the washing machine, then fill the washing machine with water, stir it evenly after the water is filled, and the dirt can be thoroughly cleaned after 20 minutes.

3. Use household white vinegar to clean the washing machine.

First fill the washing machine with more than half of the water, then let it soak for more than three hours without putting any washing items, then start the washing machine switch to rinse a few times, then release half of the water, and finally pour the white vinegar into the washing machine bucket, put the water away after leaving it overnight, and then wash it with clean water again, and then open the lid of the washing machine and let it dry naturally.

Precautions for the use of drum washing machines:

1. When the "Wash" or "Rinse" program is selected, the roller will not run until the selected water level.

2. During the dehydration procedure, the cover must be closed, and the cover should not be opened from time to time.

3. Never touch the washing and dehydration bucket with your hands, so as not to get your hands involved and cause danger.

4. Do not wash or dehydrate clothes containing volatile substances (solvents, alcohol, etc.) to avoid accidents.

5. When the dehydration is unbalanced, the computerized automatic washing machine can be corrected for dehydration imbalance, if the imbalance problem is not solved after 2 corrections, it will stop and alarm, at this time, the cover should be opened, the clothes that are squeezed on the side should be placed evenly, and then the cover should be closed, and the "start pause" button can be pressed.

6. When using hot water washing, do not use more than 50 hot water, and pay attention to the fact that the water can not splash the control board, so as to avoid the internal electrical parts from being burned due to water.

7. Before washing, check whether there are matchsticks, hairpins or coins and other sundries in the washed clothes, and if so, take them all out.

1. Pour a bag of washing machine detergent and an appropriate amount of laundry disinfectant into the drum. Note: It is inside, not poured into the laundry detergent separator box.

2. Press the normal washing start function, and it is best to start hot washing. Wait for about 5 minutes in the washing machine, press the pause button to allow the detergent and disinfectant to soak in the bucket for 1 to 3 hours, then unplug the power after the pause continues to clean normally. 3. Prepare a small basin and pour hot water, add clothes disinfectant and baking soda to mix together.

Turn on the washing machine and dip a sponge in water to clean the plastic gasket on the edge of the barrel. 4. Remove the laundry filter, wash it in a small basin and put it on. 5. Remove the faucet, soak it in the cleaning water in a small basin for a while, and then clean it with a small toothbrush before installing it.

6. Turn on the power supply, press the start button without adding anything to the barrel and clean it normally again. 

Hello! The rubber ring of the washing machine is prone to mildew, and the feeding box, groove, and inner barrel are easy to hide dirt. You can choose our mold stain remover to clean mildew stains, which has the characteristics of removing mold roots, inhibiting regeneration, and effective sterilization

Step 1: Clean the feeding box: take out the feeding box, spray our mildew stain remover to the groove, spray the mildew stain remover to the feeding box, and install it in place;

Step 2: Clean the rubber ring: open the rubber ring, spray mold remover, let it stand for 30 minutes, and wipe off the dandruff;

Step 3: Clean the inner bucket: pour in 1 cap of bleach, select the standard program, run for 5-10 minutes, turn off the power, and soak for 2-4 hours;

Step 4: Turn on the power, run the standard program once, clean it and turn it off.

If you only clean the feeding box and rubber ring, you can skip step 3; If you only need to clean the inner barrel, you can start directly from step 3;

Before cleaning, the filter bag and filter box can be removed, the dirty stains such as dander can be cleaned, and then put back with clean water;

If the filter bag and filter box breed mildew, you can spray mold remover, let it stand for 30 minutes and rinse it with water;

If the washing machine has not been cleaned for a long time, the amount of bleach used is 4 times the daily amount, and the soaking time is doubled.

Front-loading washing machines are easily contaminated and need to be cleaned regularly, here are the steps to clean a front-loading washing machine:

First, add half a bucket of water to the washing machine and add 400 ml of bleach.

Turn on the washing machine and let it run for half an hour.

After half an hour, the sewage is discharged.

Add half a bucket of water again, add detergent, turn on the washing machine, and let it run again for half an hour.

The cleaned sewage is discharged.

Leave the washed drum washing machine to dry.

In addition, there are some other cleaning methods, such as:

Clean the inner tank of the washing machine: You can use salt water or white vinegar solution, pour the salt or white vinegar solution into the water, soak the inner liner of the washing machine for about 20 minutes, and then rinse it off with clean water.

Clean the drain pipe: You can soak the waste towel in hot water, then wring it out and use it to wipe the drain.

Clean the filter: You can put the filter in warm water, add a small amount of neutral detergent, soak for about 10 minutes, and then rinse with clean water.

It is important to note that when cleaning a front-loading washing machine, you should pay attention to safety and do not use sharp tools to scratch the surface of the washing machine or block the drain.

The washing machine has a long time to brighten the celery wheel to make respect, the drum and the cleaning room will accumulate dirt and bacteria, so it is necessary to clean regularly, the current washing machine generally has a separate drum cleaning program, you can add effervescent tablets in the drum before cleaning, you can only achieve the effect of cleaning and sterilization.

1.Clean the inside and outside of the drum washing machine with clean water;

2.Wipe the inside and outside of the drum washing machine with dish soap;

3.Use a rag to wipe the inside and outside of the drum washing machine;

4.Wipe the inside and outside of the drum washing machine with a damp rag;

5.Use a rag to wipe the inside and outside of the drum washing machine;

6.Use a rag to wipe the inside and outside of the drum washing machine, then use a dry rag to wipe the inside and outside of the drum washing machine, and finally wipe the inside and outside of the drum washing machine with a wet rag to ensure that the inside and outside of the drum washing machine are clean and stain-free.

Buy Dr.'s cleaning block, put water without clothes, wash it normally once, and you can clean it up.

1.Wash with a detergent for washing machines. Fill the laundry bucket with clean water to its highest level, then pour the detergent into the laundry bucket and run for five minutes until the detergent is completely dissolved.

If the washing machine can be heated, it can be heated to 40 degrees, then turn off the power of the washing machine, soak for about an hour, and then wash according to the daily washing mode. When the washing machine is shut down, a large amount of dirt and debris floats on the water. 2.

Use a bleach agent to wash the washing machine. Add an appropriate amount of chlorine bleach to the washing machine, then fill the washing machine with water, fill it with water and stir well. After 20 minutes, the dirt can be thoroughly washed away.

If there is still dirt remaining at the bottom of the bucket in the washing machine, add water and remove the dirt thoroughly. 3.Wash the washing machine with household white vinegar.

Start by putting more than half of the water in the washing machine, then soak it for more than three hours without any washing items, turn on the washing machine switch several times, and drain half of the water. Finally, pour the white vinegar into the washing machine bucket, leave it overnight, drain the water, wash it again with clean water, then open the lid of the washing machine and dry it naturally.

In daily use, there will be washing residues, bacteria, stains and other substances left inside the washing machine, if not cleaned in time, it will affect the washing effect, and even lead to yellowing, mold, odor and other problems. Therefore, front-loading washing machines need to be cleaned regularly.

The cleaning method is as follows:

1.Wash the inside of the wash tank and the drum.

Take out the washing liquid tank, clean the inside of the liquid tank and the silo, and use a brush or cotton swab to clean the dirt around the silo. Put the washing liquid tank back in place, add white vinegar or sodium bicarbonate solution, select the washing mode, start the washing machine, and wash it again.

2.Wash the strainer.

Take out the filter from the inside of the washing machine, clean the filter with clean water, wipe the dirt off the filter with a rag, and then install the filter back into the washing machine.

3.Wash the drum.

Make a solution of white vinegar and sodium bicarbonate, put it inside the washing machine, select the washing mode, start the washing machine, and clean it in the drum, which can effectively remove the deep dirt in the drum.

4.Wash the washing machine casing.

The case of the washing machine in use also needs to be kept clean, which can be wiped clean with a damp cloth and remove stains and dust.

The above nonsense is the basic way to clean the washing machine, which can be cleaned regularly, and it is recommended to do a deep cleaning every three months to keep the washing machine hygienic. At the same time, pay attention to the frequent cleaning of the pump and inlet pipe of the pump to ensure the normal operation of the washing machine.