Do water dispensers need to be sterilized? 10. Should the water dispenser be disinfected?

Water dispensers are susceptible to contamination, and research has long confirmed this. The reason for this is that once the lid is opened, the bottled water is exposed to the air all the time, and no amount of water is used, the same amount of air and bacteria will enter the barrel. In addition, if the water dispenser is heated to about 90, it is easier for bacteria to multiply than at room temperature.

In fact, it is not difficult for families to clean the water dispenser by themselves, and you can follow the following steps:

First open the sewage pipe behind the water dispenser and drain the remaining water (the remaining water in the sewage pipe is usually the key to the secondary pollution of the water dispenser);

Turn on all drinking switches to drain the remaining water;

Dissolve 1 tablet of "Shu Yikang Decontamination Effervescent Tablets" specially used for disinfection of water dispensers in about 2 liters of clean water, and use part of its disinfectant to scrub the inner tank and the inside and outside of the lid of the water dispenser;

The rest of the disinfectant fills the entire cavity, and after leaving for 10-15 minutes, turn on the switch of the water dispenser, including the sewage pipe and drinking water switch, and drain the disinfectant;

Continuously rinse the entire cavity of the water dispenser with 7-8 liters of clean water, and then turn on all switches to drain the flushing liquid;

Finally, the back wall of the switch is scrubbed with disinfectant to complete the entire disinfection process.

The water dispenser should be disinfected, and it is best to find someone to clean it after using it for about half a year. The water dispenser will also have sediment and dirt after using it for a period of time, although boiling water can kill the bacteria inside, it is recommended that you should clean it for about half a year.

If there is a problem, the water dispenser should be disinfected regularly, generally twice a month, and bacteria will breed under the bucket, which is not good for the body.

Of course, it needs to be cleaned. Generally speaking, washing once every six months is a small cleaning, just clean the inlet and outlet water, and once a year to clean the inside of the water dispenser. Because after using it for a year, a lot of dust and microorganisms will enter, but we can't see it, and if it is not cleaned in time, it will produce mold and other health hazards.

So be sure to wash it. There are several ways to clean: first, use warm water and vinegar to clean it; Second, open the body and soak it in vinegar first, and then wash it with alkaline water (note that you must wear rubber gloves when washing with alkaline water to avoid burning your hands, because alkali is a corrosive chemical); Third, regularly require the water dispenser manufacturer to come to the door for professional care, including parts inspection, performance inspection and professional cleaning.

Manufacturers have professional equipment, which is safer and more secure. The times are developing, and society is progressing. High-tech has flown to the homes of ordinary people, and we must fully enjoy happiness and learn to protect ourselves at the same time, so that high-tech can fully serve ourselves.

I wish you and your family a long and healthy life! Don't forget to wash it

It is best to disinfect the water dispenser regularly, and the new water dispenser cannot be used immediately after buying, it should be filtered with clean water several times before drinking

Yes. Generally, once a month, there are water stations, which should be provided free of charge, and should be rinsed after disinfection.

<> "People drink bottled water, the water is pure, and it is good for health. However, if the water supply link of the water dispenser is not completely disinfected, it will also lead to secondary pollution of water quality. Even if some manufacturers are equipped with professional staff, the disinfection process may not be fully qualified.

Specifically, the disinfection of water dispensers should be divided into the following steps:

One. Unplug the power plug, remove the bucket, open the sewage pipe behind the water dispenser, and drain the remaining water, because the remaining water in the sewage pipe is the key to the secondary pollution of the water dispenser. Then, turn on all the drinking switches and drain the water.

Two. Hold the alcohol cotton with tweezers and carefully scrub the inner tank of the water dispenser. The inner liner of the water dispenser is prone to the accumulation of bacteria due to direct contact with the air. Scrubbing with alcohol can remove dirt from the top and prepare for the next step of disinfection.

Three. Dissolve 300ml of disinfectant into about 2 liters of water, fill the entire water dispenser and leave it for 10-15 minutes.

Four. Turn on all the switches of the water dispenser, including the sewage pipe and drinking water switch, and drain the disinfectant.

Five. Rinse the entire cavity of the water dispenser continuously with 7-8 liters of clean water, and turn on all switches to drain the rinse liquid. For some people, rinsing with just 1 litre of water is not enough, leaving the disinfectant solution in the water dispenser.

Six. Use alcohol cotton to scrub the back wall of the switch, when you use a cup to hold water, it is easy to touch the back wall of the water dispenser switch, and you can't just use a rag to scrub it.

After the water dispenser is disinfected, there may be a trace amount of disinfectant residue and cannot be drunk immediately. You should put a glass of water in the first place and smell for chlorine. If there is, you should put the water again until you can no longer smell the chlorine before you can drink it safely.

Water dispensers can be disinfected with alcohol.

Use tweezers to hold the alcohol and cotton and carefully scrub the inner tank of the water dispenser. The inner liner of the water dispenser is prone to the accumulation of bacteria due to direct contact with the air. Scrubbing with alcohol can remove the dirt on the banquet and prepare for the next step of disinfection.

Note that after the water dispenser is disinfected, there may be a trace amount of disinfectant residue and cannot be drunk immediately. You should put a glass of water in the first place and smell for chlorine. If there is, you should put the water again until you can no longer smell the chlorine before you can drink it safely.

1. First of all, cut off the power supply of the water dispenser, and then wet it with a clean cotton towel dipped in water, clean the surface of the fuselage and tray, etc., if you encounter dirt that is difficult to clean on the surface, you can use neutral dish soap to clean, you can not use dish soap inside, you should use a cotton swab dipped in alcohol to clean.

2. After cleaning the appearance, prepare a bucket of special disinfectant water, put the water dispenser into the bucket and soak it fully for half an hour.

3. After soaking, open the two faucets of the water dispenser, and put the disinfectant water inside to clean Wang Hong.

4. Unscrew the drain valve at the base or behind it, and drain the disinfectant water in the water dispenser.

5. Rinse several times with boiled water, and finally close the valve and two faucets, and the disinfection water dispenser is completed.

As for whether to buy a water dispenser with a disinfection function, I personally think that there are several factors to consider. First of all, see if your drinking water needs are disinfected. If you have clean drinking water or other disinfection equipment, such as a filter, you may not need to choose a water dispenser with a disinfection function.

However, if your drinking water source is not clean, or you have higher requirements for water quality and drinking water hygiene, buying a water dispenser with disinfection function can be very helpful to ensure the safety of your drinking water.

Secondly, you need to consider the convenience of daily maintenance, cleaning and disinfection of the chain tour. Water dispensers with disinfection function need to be cleaned regularly to ensure the disinfection effect. If you're busy or don't want to do the tedious task of cleaning your water dispenser, you may want to consider choosing a model that's easier to clean and maintain.

Finally, you also need to consider your own budget. Water dispensers with disinfection function are relatively more expensive on **, so if you have a good budget and need to disinfect, then you can consider buying this type of product. But if you're price-sensitive, you may want to research different brands and models** and choose one that suits you better.

Water dispensers are electrical appliances that we often use in our lives and work, and it is very important to ensure water safety and hygiene. When buying a water dispenser, whether you need to choose a water dispenser with disinfection function, you can consider the following points:

1.Whether you need a disinfection function: If your water environment is relatively complex, such as poor water quality and old water pipes, it is recommended to choose a water dispenser with disinfection function, which can effectively sterilize and disinfect and avoid the reproduction of bacteria.

2.Use scenario: If it is a water dispenser for household use, you can generally choose the ordinary model, if it is used in a public place or commercial environment, due to the large flow of people, it is recommended to choose a water dispenser with disinfection function to ensure the safety and hygiene of water.

3.Economic budget: The water dispenser with disinfection function will be slightly higher than the ordinary model**, if your economic budget is not sufficient, or the water source environment is better, you can choose the ordinary water dispenser.

If possible, it is recommended to choose a water dispenser with disinfection or Chang hood function, which can better protect the safety of our drinking water.

If you have an area where the water source you need to drink is tap water, your own well, or the water quality is poor, then it is a good idea to consider purchasing a water dispenser with a disinfection function. Water dispensers with disinfection function can kill bacteria, viruses, algae and other microorganisms through ultraviolet disinfection or filtration and jujube core disinfection, improve the safety and hygiene level of drinking water, ensure the safety and hygiene of water quality, and protect the health of you and your family.

Even if you buy a water dispenser with disinfection function, it needs to be cleaned and maintained regularly to ensure the disinfection effect and the quality of drinking water. In addition, the price of disinfection function water dispensers is generally higher than that of the water dispensers, and it is necessary to weigh the pros and cons according to their own needs and economic strength.

Buying a water dispenser with a sanitizing function mainly depends on your budget and personal needs. In the current epidemic situation, for some people who attach great importance to family hygiene, water dispensers with disinfection function can effectively kill bacteria and viruses and ensure the safety of drinking water. However, this feature will increase the cost and maintenance of the equipment, and many factors such as water quality and frequency of use need to be considered.

In short, if you have a sufficient budget and have high requirements for drinking water safety, you may wish to choose a water dispenser with disinfection function.