Which Zenith watch is made in China and what movement is Zenith

Swiss-made, in-house movements.

Zenith Watch After-Sales Service Center: 400-659-0877

The watch uses an extra-large fluorescent material dial to ensure correct reading. The sturdy case with a diameter of 45 mm is made of bronze and is equipped with a wide watch crown and fluted adjustment buttons, which can be adjusted even with gloves on. The natural patina is made of a domestic alloy with high wear resistance and strong wear resistance, providing a unique retro style of the watch.

If your watch suddenly does not go, then it is likely that the table has no output signal due to the following reasons, and all other aspects of the inspection are normal, check the circuit board with a multimeter without output signal, most of the reasons are due to the damage of the quartz oscillator or the failure of the integrated circuit, if the replacement of the quartz oscillator is invalid, then the entire circuit board needs to be replacedGear train faults, most of them are dust or foreign matter between the gear teeth, so that the gear train teeth are stuck with each other. There are also some tables where there is too much or very little oil, and too much oil causes adhesion between the wheels, wheels and splints.

Too little oil makes the rotation wheel train too resistant, which will make the electronic watch go badly. In case of these faults of the stepper motor and wheel train, they should be cleaned, removed from foreign matter, and refueled.

Coil breaking, due to oxidation or man-made reasons, so that the coil is damaged, can be checked by multimeter testing, and generally needs to be replaced. The meter battery is not charged or the capacity is insufficient, and a new battery needs to be replaced. However, the watch often finds that the battery is dead in a short period of time, which is generally caused by high power consumption or the low quality of the battery itself.

In this case, you should first find out the cause, troubleshoot, and then replace the battery with a new one. The contact is not good, most of them are dirt on the positive and negative electrode contact reeds, and the contact with the battery is poor. Poor contact can also occur when the signal output point on the board is in contact with the lead point of the coil tip.

These will cause the circuit not to be turned on, so that the watch does not go or does not go well, and it is found that the circuit is not open due to poor contact, first clean the contact surface sufficiently, and then reassemble it. The stepper motor can not rotate, and the rotor of the stepper motor is a permanent magnet, which often cannot rotate due to the adsorption of iron filings and the stator is stuck, causing the watch pointer to stop or stop when walking.

Zenith Elite 685 calibre28800 frequency, power reserve of about 50 hours, power reserve, date, small seconds dial display, I personally think the power reserve display is quite practical. The Zenith Calibre 670 is thinner than an automatic movement and has a unique two-way date adjustment function.

The ELPRIMERO is the most well-known movement in watchmaking and the most accurate serial production movement in the world. The world famous watch, Hong Kong used to use the name "Zenith", now Chinese mainland and Hong Kong are called "Zenith". "Zenith" is the official Chinese name.

Founded in Switzerland in 1865, Zenith has been around for 146 years and is one of the four true watchmakers in Switzerland.

The Eiprimero chronograph movement is the world's most accurate and highest-frequency active meter, with a drain movement of 36,000 revolutions per hour, accurate to 1 10 seconds and a kinetic energy stored for more than 50 hours. 1969: A legend was bornOn January 10, the new calibre 3019PHC "Elprimero" was unveiled, with a diameter of millimeters and a thickness of millimeters.

It is the first of its kind and has been unparalleled for 40 years. Thanks to the scheme of the mid-rotor running on ball bearings, it is the only integrated motor movement that achieves bi-directional active winding. This one-of-a-kind movement beats at a frequency of 36,000 vibrations per hour, making it accurate to tenths of a second.

The movement oscillates at a very high frequency and generates very high centrifugal forces, which make it impossible to use traditional lubrication essentials for its components. As a result, Zenith's engineers developed a special dry lubrication system to ensure a high degree of stability in the movement. In addition, despite the limited space available for the barrel and the high energy consumption of 36,000 vibrations, Zenith is still an innovative generator with a power reserve of more than 50 hours.

Elprimero writes a new chapter in watchmaking.

Zenith was founded in Switzerland in 1865. It is a watch manufacturer with a long history of 150 years. Now Chinese mainland and Hong Kong are called "Zenith", and Hong Kong used to use "Zhenlishi", but "Zenith" is the official Chinese name of Rangzhen.

On July 12, 2021, Zenith announced that Xiao Qingyingzhan, a well-known Chinese actor and singer, will be the brand spokesperson, and jointly release a new advertising campaign, conveying the brand spirit of "Dream with Stars, Walk with Truth" (timetoreachyourstar) on the road to building dreams and winning stars.

Born in 1969, the Emiletro chronograph calibre is the world's most accurate and highest-frequency automatic chronograph movement, with 36,000 revolutions per hour, accurate to 1 10 seconds and a kinetic energy reserve of more than 50 hours, and in 2017, Zenith launched the Defyelprimero 21 watch, which has achieved a leap from 1 10 seconds to 1 100 seconds, opening up a new dimension in the field of mechanical watch precision.