I hit a horizontal racket and the opponent gently lifted the ball that I had rubbed over, and I was

Slap him, or backhand.

You gently lift it up again and sprinkle it.

The commonly used rubbing techniques are: (1) Slow rubbing 1, the characteristics and use of slow rubbing action amplitude, in the descending period of the ball, the return speed is slow, but it is conducive to increasing the spin strength of the rubbing ball. Slow rubbing is generally suitable for catching back the ball with strong rotation and a slightly longer line.

In the counter-rub, the combination of fast and slow rubbing can change the rhythm of the shot and contain the opponent. 2. Key points: The tilt angle of the paddle surface should be controlled according to the specific situation of the incoming ball.

When hitting the ball, the forearm should be forced, and the wrist turning action should not be too large. Rub and rotate the ball, and at the same time exert downward force, you should increase the amplitude of the forward delivery. (2) Fast rubbing 1, characteristics and use of small range of action, fast return speed, borrow the forward force of the ball to rub the ball back, often used to receive the ball or cut over the net downspin ball, in the rubbing, the use of fast rubbing to change the rhythm of the ball, shorten the preparation time of the opponent's return ball.

2. Key points: The center of gravity of the body moves forward, and the body is close to the incoming ball. The forearm actively extends forward to the middle and lower part of the ball.

Fast rubbing generally uses force to fight back, and if the ball is weakly spinned, you can use force to cut down. (3) Rubbing and not turning the ball 1. Characteristics and use similar techniques to rub out the ball and not to turn (relatively speaking), so that the opponent makes a mistake in judgment and scores directly, or creates conditions for the attack. In the dueling, the clever combination of spin change and landing point change can get more offensive opportunities, and when dealing with chipping, you can free yourself from the situation of being controlled.

2. Key points: The addition of rotation is the premise, and the greater the difference between rotation and non-rotation, the more powerful it is. When rubbing and turning, the wrist is mainly used with explosive force.

When you can't spin, pay attention to the arc of the return ball. (4) Rubbing the ball of rackets with different performance 1. Characteristics and application: the reverse racket action is fast, and hitting the ball with different performance racket surfaces completely changes the rotational nature of the return ball, making it difficult for the opponent to adapt.

It is often used when you can score directly in a match or when there is a chance ball. 2. Methods and key points: master the proficient backshot technique, choose the timing of the change of racket surface to rub the ball, so that the opponent is unprepared, make mistakes, and prepare for the next cricket.

The reverse arc circle is also a good method, twisting can make the other party uncomfortable, causing a sense of surprise Note: It is best not to skim, so it is easy to be re-plated by the other party, and it will be dead.

You're talking about table tennis. I'm also a beginner, just like you. I have two professional table tennis player friends around me, they have taught me, there are two main reasons for this situation, one is that the standard basic movements are not in place, and the other is that the timing of hitting the ball is not well mastered, and it is very important for the ball to bounce when it comes.

The key is to practice more. There are no shortcuts.

Don't think that the high ball is very easy to play, on the contrary, the higher the ball is more difficult to play, pay attention to the rising period of the ball, the high point period, the falling period of several aspects, as well as the shape of the racket, the lead of the racket are related, I remember that there is a special lesson in Tang Jianjun's teaching video, you can take a look.

The horizontal board attack is very cheap, the main spin and arc are relatively large, but it is more difficult to control.

Dealing with a straight partner is mainly about eating the ball.

Eating the ball, that is, the stay time of the ball on the racket, when staying, the ball can be accelerated and controlled, and the amateur is generally too short to complete the forward acceleration and rotation acceleration and control of the arc.

1.Equipment.

In the past, I have been using some high-elastic rackets and some high-elastic rubber, because the time to eat the ball is too short, the feeling of friction is too weak, and I have no feeling for eating the ball.

2.Swing speed.

For the upspin of the incoming ball, everyone will not have any feeling of not being able to eat the ball, but when the incoming ball is downspin, if the speed of the swing is lower than the rotation, it will not be able to eat the ball, and when the national hand is facing the chipper, there will also be a situation where the ball cannot be eaten, so the speed of the swing of the racket cannot be lower than the spin of the downspin ball.

3.Beat shape.

For the straight board with a strong downspin ball, the national player should also pull it with his back, of course, such a "support" ball is easier to hit and is very difficult to pull But the backhand will be a little easier You can experiment with it!

The rotation of the long glue is the opposite of the reverse glue. The ball is generally topspin. The ball that is pulled over is generally downspin. Be improvised.

Anyway, pay attention to observe the opponent's movements, if the opponent is pulled over, do not apply the anti-glue hard block, otherwise it will lead to the net, there are two countermeasures, 1, pull the ball straight over, causing the opponent to be unable to defend, 2, if you can't reach such a level, then stand the racket a little bit and gently block the ball up a little bit to the near platform, so as not to go to the net, but also for the next board to do a good foundation.

If the opponent rubs over, then give him a pull ball directly, and if he is close to the table, he will pick it up, and it will be hard anyway, because it is a ball that is overspinning. (The same goes for the balls).

And so on and so forth. Remember that a ball that comes from the reverse is treated as if it were spinning against it.

Oh, in fact, it's because of your hand, for straight players, the serve is basically more or less with a little side spin component (this is caused by the grip of the racket, I have been playing straight shot since I was a child), in fact, to be honest, the larger the side spin component of your own hair belt, if the opponent comes back to the ball will be very awkward, you must control the side spin ball you must control the plate type to catch, the plate type to the opposite direction of rotation. Do you know why you always feel "empty" on the serve of this foreign friend? You said that when you pick up, you control the angle to "bounce" him back, proving that you don't take the initiative to exert force, so it is easy to eat the serve, in fact, you have to control the plate type to take the initiative to exert force, after this hanging, the opponent is also very awkward to pick up, you don't bounce over, of course, it will be a tragedy.

Then you see if his backhand is stable or forehand stable when you practice, and if you feel that his forehand is weak, you can directly hang his forehand and send him to play! Then press the backhand. If he has a weak backhand, hang his backhand directly, press the backhand position, and find an opportunity to skim a forehand!

In fact, to deal with this style of play players, the main thing is not to be afraid of receiving the ball, must take the initiative to exert force, rather than borrowing force to bounce past, which is very important, and then is optimistic about the opponent's weakness, the straight pace is very important, the holding is generally not as good as the horizontal version, you can take the strategy of pressing the backhand to adjust the forehand. If you really have doubts about your current feel and don't dare to exert your own force, then teach you a little more, that is, don't go to the rising point of the ball when receiving the ball, but the falling point of the ball, so as to control the plate type, and it is very safe to rub the ball

Oh, in is upstairs friends said that you can use a piece of long glue or raw rubber to kill the other party, if he has not touched this kind of rubber much, it will be tragic, you don't have to use how to force when you catch the ball, just gently knock a board past, the other party is very uncomfortable, if you want to win he can try, immediate results! Considering the improvement of your long-term skills, it is still not recommended to use it, and once you use it, for amateurs, there is very little room for basic improvement! I hope you can help, we are worthy of any foreigner in the national ball, you must be confident when you play, I wish you to abuse him next time!

I'm a newbie. When I receive the downspin ball, if the opponent's power is not very large, I will pull the arc ball back, and if the opponent's side of the downspin is very strong, I will choose to rub the ball and rub it long. The explosiveness of squatting is very important, and I am a newbie and want to learn and communicate together.

First of all, it is necessary to judge whether the side spin is side spin or side spin, because if the side spin is downspin, it may be more difficult to pull, so it is better to cut it back, if the side spin is then pulled up with the backhand, it is not necessary to pull it very turned, you can gently pull a board transition, but pay attention to the landing point, wait for him to return the ball to the opportunity to whip again, the forehand and backhand are the same, if the ball to the middle, given that your backhand is stronger, you can gently pull up with your backhand sideways. The more you pull the ball like this, it can also help you find the ball feeling, and slowly you can directly pull the high-quality ball.

If the opponent rubs the short ball close to the tennis ball, he will not turn the ball to the bottom line of the opponent's backhand, and his return will generally be long, you can wait for the opportunity to pull up the hanging arc circle and rotate with him, waiting for the opportunity to smash; If the opponent rubs the ball that is not long or short, you should use the method of turning, not turning, rubbing the side spin and its circumference, once the opponent returns the ball to the high point, change the line and push or dial, disrupt the opponent's rhythm, and then turn to the arc circle to attack!

I've played sideways shots, and I've had this type of difficult opponent, so I just rubbed the ball, picked up the long ball, and then got into the arc track that I was good at, and dealt with him. To deal with this kind of opponent who has a strong attack and a weak attack, you should make a long ball as much as possible, pull the ball in a higher arc (reduce the error rate), force the opponent to retreat, see the opportunity and then smash, and you can't 'die attrition' with the opponent's table, otherwise it is difficult to get rid of passivity.

For those who don't pose much of a threat to the attack, sometimes hang the ball a little higher so that the spin of the ball he rubs is not so strong, and you can pull the ball.

The ball must be hard to rub in the big knife table. Not only should the rub be low, but the angle should be good, and the direction of the forehand should be rotated so that the ball returns to the forehand. If the backhand is good, rub the backhand and rotate it in the direction of the backhand. That's the opportunity to go on, not the chance to keep.

It is best to pull the ball to deal with it, and at the same time to combine it with sling and pulling, and move the opponent's position to change suddenly.