The refrigerator is plugged in and there is electricity, but the starting compressor is out of power

Reason 1: When the refrigerator compressor does not start, first check whether the refrigerator power supply is plugged in or whether the power supply of the refrigerator is loose, the refrigerator is not well connected to the power supply, and the refrigerator compressor cannot be started.

Solution: If the problem is in the power supply, plug the power cord of the refrigerator back into the power plug to ensure that the refrigerator can fully receive power.

Reason 2: The reason why the refrigerator compressor does not start may also be that the motor unit of the compressor is burned out, and the problem that will occur at this time is that the fuse of the compressor is blown out, which is a common problem that the compressor does not start.

Solution: The refrigerator compressor fuse blows and the compressor does not start, so you need to purchase a new fuse and replace it.

Reason 3: The controller circuit of the refrigerator is faulty, and the general phenomenon is that the contacts are overheated, burned, worn and other phenomena, which will lead to poor contact of the refrigerator compressor contact.

Solution: Remove the contacts of the refrigerator for repair or replace the contacts of the refrigerator.

Reason 4: Check whether the circuit voltage of the refrigerator is normal, when the circuit voltage of the refrigerator is lower than the rated value, the motor of the refrigerator will not be easy to start, and at the same time make a "buzzing" sound.

Solution: Use a voltmeter to measure the voltage first, if the voltage is low, you need to buy a power regulator to increase the voltage value to make the refrigerator run.

Reason 5: A mechanical failure of the compressor will also cause the refrigerator compressor to not start. The problem of holding the shaft of the compressor is generally caused by the lubricating oil, the lubricating oil circuit is blocked or the oil supply is interrupted, and the dirt in the lubricating oil increases the viscosity of the lubricating oil; The compressor cylinder is stuck because of the small gap between the piston and the cylinder or the thermal expansion relationship.

Solution: If the fault caused by the lubricating oil, the lubricating oil is not enough to add lubricating oil, and the viscosity of the lubricating oil pipe and lubricating oil increases, the lubricating oil should be replaced. If the problem is that the compressor is jammed, it is necessary for professionals to repair it.

The refrigerator is plugged in and there is electricity, but there is no electricity when the compressor is started, and it may be a failure of the compressor, so it will not be able to use normally.

It's going to be plugged into the hotel, but there is no power as soon as it starts, which means that somewhere is a virtual connection, and it is not good to plug it in, so it is only connected to let it, but as soon as it runs, the current is large, so it is disconnected.

The refrigerator is plugged in and has electricity, but there is no power when the compressor is started, indicating that the compressor may have a circuit short-circuit problem and needs to be repaired after sale.

Judging from your description, it is that the compressor has appeared, and the factory may also be out of time with the wires, and there is something wrong, not that the compressor is broken.

It may be that the line is in poor contact, please check the line.

It may be that there is a problem with the compressor and you need to find an after-sales professional for inspection.

What is the controller you are talking about, is it an external refrigerator or other thermostats? If it is an external thermostat, it is equipped with a delay protection function, and the power supply will be turned on after a few minutes.

So it must be that the line of the compressor ** is out of order? Find after-sales service to help you overhaul and take a serious look at what the fault is.

You check whether the line is uh has a power outage caused by a ** surface connection error.

After the refrigerator is plugged in and started with electricity, the compressor runs out of power. It should be an issue with the power settings.

1. There is no voltage in the power supply. Check whether there is voltage in the external power supply and the compressor input. 2. The ambient temperature is too low.

When the ambient temperature is too low (below 0 degrees), the starting time of the thermostat control compressor will be very short, and the compensation switch needs to be turned on. 3. Improper adjustment or failure of the thermostat. Check whether the thermostat gear is in 0 gear, 0 gear is the shutdown, adjust the thermostat to 3-4 gear.

If it still does not work for a long time, it may be a malfunction of the thermostat. 4. Initiator failure. When the compressor starter fails, the compressor fails to start.

5. Compressor failure.

Hope it helps!

Hello, it is an honor to answer the service for you, and I am inquiring about the relevant information, please wait a while. It takes a little time to type, dear.

Hello, first determine whether the socket has electricity, if the socket is powered on normally, it may be a problem with the refrigerator itself, there are the following points:1The internal circuit of the power cord is disconnected, resulting in the refrigerator not starting, and whether it is a problem with the power cord can be judged by whether the light in the refrigerator is shining or not, 2

If the compressor fails, the internal circuit of the compressor is damaged, and the compression and refrigeration cannot be carried out, the three terminals of the compressor can be detected by the voltage tester to distinguish 3If the thermostat line is faulty, resulting in the compressor not working, several terminals of the thermostat can be detected with a voltage tester4The thermostat line is not tightly contacted, which also directly causes the compressor not to work, you can try to reconnect the thermostat connection from the 5

The internal circuit of the box is broken, which is difficult to identify, and the refrigerator needs to be planed open to view the internal circuit of the refrigerator 6The solenoid valve is broken, and several terminals of the solenoid valve can be detected with a voltage tester 7The overload protector is open circuit, which is usually caused by the long working time of the compressor, which can be judged according to the actual situation.

If you have a simple problem such as a simple outlet, it is recommended that you have a professional to inspect and repair it for safety and reduce losses.

Is it broken, find a person who repairs the refrigerator to see what the cause is, maybe there is a problem inside or you need to wait for half an hour to see if you plug it in

1.It may be that the ice temperature control of your refrigerator is not accurate due to the inaccurate temperature measurement caused by the use of time, and the machine starts to work again when the temperature rises to a certain temperature.

2.It may be that there is a problem with your machine itself (not the thermostat) that makes the temperature too high during operation and protects it, and then starts again when the temperature drops to a certain temperature.

3.It may be that there is ice on the wall in the refrigerator, which causes the temperature measured by the machine to reach the set temperature earlier.

The operation of the refrigerator compressor is intermittent, when the temperature in the refrigerator rises, the internal contacts of the thermostat are closed to make the compressor energized; When the temperature in the refrigerated chamber drops to the set temperature, the internal contacts of the thermostat are separated and the compressor stops working, and the cycle repeats.

If the compressor does not work for a long time, perhaps it is caused by the low indoor temperature in winter, either the temperature compensation switch of the refrigerator in winter is not opened, or the compensation circuit is faulty, and the after-sales service should be contacted for maintenance.

In addition, clogged pipes in the refrigerator system can also lead to this phenomenon.

This must be the failure of your refrigerator compressor, or the CNC display screen, so the refrigerator is a little, but the compressor does not start.

In this case, it means that the compressor has failed and is not working, so it should be repaired if it does not start.

In this case, the compressor is faulty and does not work, so the repair does not start the unit.

Summary. Hello, it is caused by compressor overheating protection or inaccurate refrigerator temperature measurement.

Hello, it is caused by compressor overheating protection or inaccurate refrigerator temperature measurement.

Plugged in and only worked for less than half a minute before it stopped, what is this broken?

There are many reasons why the compressor will not work for a while after the refrigerator is energized, please refer to the following points: 1. It may be a problem of voltage, the voltage is high and low, and it cannot be caused by the normal use of the refrigerator compressor. 2. It may be caused by the failure of the compressor itself.

3. It may be that the refrigerant in the ice box is not enough or is used up, which will also cause the compressor to not work. 4. It may be that there is a problem with the temperature control device of the refrigerator, and the temperature measurement is not accurate, resulting in the compressor shutdown. 5. The compressor malfunctions and heats up, starts the thermal protection, and then stops.

Dear, your situation is more in line with the fifth article, the compressor failed to heat up, started the protection function, and shut down.

Dear, try to lower the temperature of the refrigerator, turn on the machine and see if it is still stopped, touch the temperature of the compressor, whether it is normal.

It's been a long time, and the temperature has stopped, and it will stop in half a minute.

Dear, it's overload protection.

This fault requires checking whether the compressor's starter capacitor or compressor starter coil is burned out.

There is also a check whether the compressor is stuck, and in serious cases, the compressor needs to be replaced. The problem lies in the motor part of the compressor: a, the motor winding in the compressor is open or short circuit (both faults are caused by high current to protect the thermal relay for 5 seconds) b, the compressor starter is broken due to the failure of starting, or the high current causes the thermal relay to protect the circuit in 5 seconds.

Abstract 1: The power supply voltage is too low, resulting in the compressor being unable to start normally and the thermal protection shutdown.

2. The compressor starter or thermal protector is faulty.

3. There is a fault inside the compressor itself.

4. You should contact the after-sales service department in time to come for maintenance.

The refrigerator was plugged in and started for a while and then stopped.

1. The power supply voltage is too low, resulting in the compressor being unable to start normally and the thermal protection shutdown. 2. The compressor starter or thermal protector is faulty. 3. There is a fault inside the compressor itself. 4. You should contact the after-sales service department in time to come for maintenance.

Hope it helps.

1. There may be a problem with the control, and the thermostat or main control board of the refrigerator is faulty, which will lead to the problem that the refrigerator is plugged in and the compressor does not work. 2. If the compressor coil of the refrigerator is broken, the compressor will fail and cannot be started normally. 3. It is also possible that the sensor of the refrigerator is damaged, resulting in the refrigerator not being plugged in.

4. The refrigerator compressor protector has an open circuit, which causes the compressor to not work normally, and the refrigerator will not start when plugged in.

Suggested workaround:

1. Check whether the thermostat or the main control board is faulty, if there is a fault, then you need to replace the new thermostat and the main control board, which can solve the problem that the refrigerator cannot be powered on. 2. In addition, you need to check whether the compressor coil of the refrigerator is open, if this situation occurs, you need to contact professional maintenance personnel for maintenance, and at the same time, you need to see if the compressor has other faults, and if the compressor fault is solved, you can solve the problem that the refrigerator is plugged in and does not start. 3. See if the sensor of the refrigerator is faulty, if the sensor is faulty, you need to replace the new sensor to solve this problem.