How to add Protel 99SE resistor?

POT1 adjustable potentiometer (denoted by a wavy line).

POT2 adjustable potentiometer (denoted by a long rectangle).

Resl resistance (denoted by a wavy line).

res2 resistance (denoted by a long rectangle).

res3 adjustable resistance (denoted by wavy lines).

res4 adjustable resistors are represented by long rectangles).

respacki One of the eight in-package integrated resistors (denoted by wavy lines)respack2 One of the eight in-package integrated resistors (denoted by a long rectangle)respack3 One of the complete eight-cell in-package integrated resistors (denoted by wavy lines)respack4 One of the complete eight-cell in-package integrated resistors (denoted by long rectangles) Fixed resistor: res

Semiconductor resistance: ressemt

variable resistance; rvar

Slip resistance dwq

In the dialog box where the component is placed, enter the appropriate ** and press Enter. Only if you add a component library, the corresponding component graphic will appear. If no library is added, an error is displayed.

You can search first, then add the library, and you can directly find the model you want. I don't know if it's too easy, but it's been a long time since I found it.

On the left side, there is the component library of the company, you look for the letter r that starts with the letter, you can see the component graphic below, double-click the resistor component, the component library of the company is the default library, you don't need to add it separately!

Go to the component library to find it, first look at its number and enter it directly.

Many friends who learn design are inseparable from the software protel99se, because it is very convenient, but there are also some users who have just come into contact and do not know how to operate, the following brings the introduction to the installation and use of protel99se, come and take a look.

1. PressG keyThe menu will pop up, and then select the appropriate movement distance size, and you can change the size of the mouse movement grid on the PCB.

2. Use the drop-down menu of tools and selectanaotate, you can number the part in the schematic.

allpartsAll updated numbers.

partsWhat is the original Nazi Li diagram? of automatic numbering.

resetAll component numbers are changed to r?c?。

3. Operate in turn".designoptionssnapon and visibleto set the size of the grid in the schematic.

4. Change the position of the original eggplant type.

Click on the component and pressX keyPerform a horizontal mirror flip and press Crash GuessY keyTo make a vertical mirror flip, pressSpacebarTurn counterclockwise to change the position of the original in the schematic.

Protel99SE is an electric Yingyu road design software, the basic operation methods of its spine lifting section include starting the software, creating a new schematic, drawing a schematic, and searching PCB from the schematic.

It is used by electronic and electrical software to make circuit diagram packaging.

Protel99SE is an EDA design software applied to Windows9X 2000 NT operating system, using design library management mode, can be networked design, has strong data exchange capabilities and openness and 3D simulation function, is a 32-bit design software, can complete circuit schematic design, printed circuit board design and programmable logic device design, etc., can design 32 signal layers, 16 power supply - ground layer and 16 machining layers.