When Hongqi 5 Linux is installed, the screen is not fully displayed, and some content cannot be seen

Blind operation, tab to switch the focus of the button, press enter to confirm, you need to be familiar with the installer.

There is a compromise solution is that the VMware virtual machine mounts a real hard disk, so that the display should be complete during installation, but pay attention to the hardware settings to choose the real computer, the default automatic recognition is basically the hardware of the virtual machine, can not drive the real machine.

update: You need to do it yourself. When setting up a new virtual machine, VMware can select the physical hard disk when setting up the hard disk, and pay attention to selecting the driver of the hardware when installing, and the default settings cannot be used.

It's best to choose the most versatile device, such as a standard scroll wheel mouse with a PS 2 port, and a VESA for the graphics card. (Note doesn't always work).

Also pay attention to the choice of hard disk, your physical hard disk is SATA, just choose the virtual disk method of SCSI port in the VM, if it is an IDE hard disk, the virtual hard disk chooses ATAPI IDE, otherwise your Linux system will have problems when starting on a real computer.

nohup plus the command you run and you're good to go! Once you're done running, go inside to see the results of those runs.

Wrong. To install Linux, you must first make sure that there is no unallocated space on your computer's hard drive. The hard disk of Linux is different from that of Windows, and there is no Hunger C, D, E, F, and disk.

In addition: when installing Linux, the partition can be divided before installation (with software, such as PQ) or at the time of bridge installation.

Remember.

Let's see if you have a graphics driver!

If you install it, you can change the resolution.

Hehe......This graphics card may be a little lower for the current Linux......It is recommended to install it in the form of characters.

Enter text mode, don't turn on x, set the graphics card driver and then start x

Wrong driver selected during installation, right?

It's all here, and there's a tool tray or something.

ctrl + shift +f7

Or type a command.

sudo)startx into xwindows

Instructions don't support your graphics card.,Try other Linux distributions.,Windows blue screen,Linux's stripes,It's a problem with the lack of graphics card drivers.,Linux drivers are concentrated in the kernel.,Unless you can compile the kernel yourself--Of course, it's also possible that your installation package is broken.,I've also seen the kernel can't start due to the broken installation package and so on.,Did you check it before installing it?

The second case - each distro is its own optimized kernel, maybe Hongqi does not have the driver of your graphics card, like ubuntu and other popular distros, in terms of hardware support are good, you can also try

Switch to a better distro and make sure it's not your problem before you take the next step.

Other versions include Ubuntu, SUSE, Fedora, Redhat, etc.

The steps are as follows: 1. Move the mouse to the top of the middle of the screen. 2. Then a window will pop up. 3. Click the full-screen button on the window to exit the full-screen and return to the host.

Install the Virtual Machine Enhancement driver and you're good to go.

If you want to install the enhancement package directly from VB, execute the script in the package and restart it.