Is the flat tail plug changed to the DC connector? How is this DC connector wired? How to pick up th

Unless the tail plug of the tablet computer has high circuit knowledge and hands-on ability, it cannot be changed to a DC plug, and there are no third-party products.

Hello friend tablet pen plug in the DC connector this change is also possible, change the address and connector is also very convenient to use, I hope to help you.

Didn't you disassemble and change the DC connector at work, I think this should be able to be plugged in the DC connector, this should be able to make it better and more convenient for him to charge.

The most important thing is what exactly you use in this machine, the socket of this machine, can you make this clear.

Is the flat tail plug changed to the DC connector? Regarding this problem, it should be the most ideal and safest to use the original configuration to ensure the effect in your use.

If you want to change this plate, you can't change this joint, this is all original, if you want to change it, you must change this original one.

He still needs to change this joint after that, this is a must.

Ping Pong weft changed DC screenshot back. Do you have a screenshot? Follow me. I don't think so. Back to Return. If that's the case, ask the staff.

I think if you want to change the plug, of course you can, it's very good.

The current interface of the tablet is micro, and the mobile phone is also charged, and the data is transmitted with an interface, how convenient = =

It's not safe, the DC interface is dedicated to charging, and the micro transmits data.

The one with rivets can be connected to the DC positive pole, and the other two heads can be connected to the negative pole.

If you're not afraid of burning, you can, but it's not going to burn, it's okay in the short term, don't use it in the long term.

There is no problem with the power supply, just the same voltage.

Of course, the output of the charger is DC DC and then output after rectification, if you don't believe it, you can also disassemble it to see if there is a rectifier tube inside!!

There are two situations, one is that the protection board is broken, and the whole line is in an open circuit state, which should be understood, and the other situation is overshoot or overdischarged, the method of judgment, when charging, if there is an indicator light when calling the attack, see if the indicator light is on, or use a multimeter to see if there is any current through, if there is, there are two situations, see how much the current is, if the current is less than or equal to the overcharge nominal current of the protection board, Hand shield is overcharged, such as Bilian Zhouguo has no current at all, that is, the protection board is broken, just change the protection board.