There are many ways to knot coat belts, which ones do you know?

The knotting method of the coat belt, many people have seen but will not tie it, in fact, it is super simple Social life hacks Tips Tips Tips Belt tying method.

The first is the versatile bow tie method, which looks gentle; Secondly, there is the cross-tie method, which is both simple and trendy; Finally, there is the eight-character system, which is a very unique system.

There are many ways to knot the coat belt, first of all, the common bow method, and then the tie knot, which is more handsome, and the cross buckle method, which is simple and easy to use.

The first is that the bow is very beautiful and fashionable, and it is very simple and atmospheric, the second point is the kind of rose, which is also very individual, and very distinctive, and the third is the kind of simple button that we prefer, so it is very individual.

1. First of all, make the length of one of the two ropes a little longer, as shown in the figure below

2. Tie two knots, as shown in the figure below

3. Pull the left rope back a little bit, and then pass through the hole in the middle to form a circle, as shown in the figure below

<>6. Finally, wear back to the middle, leave the fifth circle, for the sake of beauty, hide the rope end, as shown in the following figure:

7. Finally, the chrysanthemum knot is completed, as shown in the figure below

1. Bow tie method.

Steps: The belt is crossed up and down, with the side with the buckle a little shorter in length and placed underneath. The belt placed on the top bypassed the shorter belt and was tightened, and the upper belt was still on top.

Go down the upper belt, tie a knot around the lower belt, pull out the upper belt, and the knot is finished.

2. Unilateral tying method.

This method is generally placed on the left or right side, and the coat belt is made into different lengths, gently crossed and circled, and finally smoothed out.

3. Rose fancy system.

Pull the two ends of the belt in a two-to-one ratio, fold the short end in half, and then take the short end that has been folded in half as the center point, wrap the long end as a petal, and finally tie the remaining little with the short head lightly, and the beautiful and chic rose belt tie method will come out.

Here's how to tie the coat belt:Tool: One coat.

1. Two lines intersect, located on the upper floor, Line 1 is slightly longer than Line 2, and Line 1 is folded in half at 1 3.

Wear the number on the line, and pay attention to the position where the hand needs to be balanced.

Turn the line down, and pay attention to the parallelism of the labels.

4. Roll up the line 2 in parallel, and fold back a part of it, the length of which is slightly longer than the length of the line 1.

5. Bypass the No. 1 baseline around the folded No. 2 line, and fold it at an angle parallel to the No. 2 line to form a bow shape. Pay attention to keep the line flat when passing down, and the line is fit between the lines, and you must not tighten it.

6. Finished bow finish.

The various knotting methods for clothing belts are as follows:

There are 6 ways to tie the coat belt: flat knot buckle method, bow knot buckle method, diamond knot method, catfish buckle method, reverse knot method, and tie knot method.

1. Flat knot buckle method:

Fold the belt up and down, then tie a flat knot and repeat twice for more aesthetically pleasing and firmness. In this way, the good-looking flat knot buckle is not difficult to operate, and such a flat knot is not easy to spread because it is tied with two buttons.

2. Bow buckle method:

After folding, you can tie a nice bow when you cross it.

3. Diamond knotting method:

After folding the belt up and down, wrap the shorter side with the longer side, and then reverse the inner side to intersperse, so that you can tie a more beautiful diamond knot, which is more beautiful and neat, and is more suitable for girls with elegant temperament.

4. Catfish buckle method:

On both sides of the waist, tie a good-looking catfish buckle, which is more beautiful and a more unique belt tie. It can make an ordinary coat more personalized and advanced, and it is also very foreign to wear.

5. Reverse tying method:

Reverse knotting is a way to tie knots in reverse, which is more fashionable than conventional ties. Sometimes with the conventional tie method, it will really give people a novel feeling, so the appropriate choice of reverse knot tie is also a good way to match.

6. Tie knot tie method:

Tying a coat belt like a tie will have a simple and neat sense of luxury. Tie the belt of your coat as you would with a tie. This kind of puja will be extraordinarily simple and high-end, and the whole coat is also very stylish to wear.

The easiest way to tie the coat belt cross knot: cross the belts together, and insert one strap on the outside into the inside of the other belt. Then put the strap up from the left side of the other strap, fold the strap in half, pull it through the hole and tighten it.

The simplest way to tie a coat knot is as follows: first cross the belts together. Insert one of the outer straps into the inside of the inner strap.

A simple side-tie bow is done, this tie method is simpler than the traditional bow, dignified and elegant. Tie the belt in a knot, with the higher belt being A and the other being B. Pass belt A under belt B.

Pass a through the gap between the two sap belts. Tighten the belt and adjust it slightly, and it's a cross knot.

Coats

The coat is an outer garment worn outside the general clothes with the function of defending against wind and cold, and the clothes are buried in the long coat to the waist and below. Coats are generally long-sleeved, open at the front and can be buttoned, zipped, felt, or belted. It has a warm or aesthetic effect.

In ancient times, the coat referred to the dress of women in ancient times, and the noun originated in the Tang Dynasty and was used until the Ming Dynasty. Western-style coats were introduced to China around the same time as suits in the mid-19th century.

Knotting method of clothing straps: single tail type, double tail type, tight type, bow tie type.

1. Single tail type

Slip the belt into the buckle. Make a loop and thread the initial end of the belt through the buckle from bottom to top. Go through the freshly made circle from top to bottom. After completion, you can freely adjust the length of the sag by passing it through the loop you just made several times.

2. Double tail type

The belt starts with one end at the top and the buckle at the bottom and crosses each other. The initial end is threaded from the bottom up through the belt that clings to the part of the garment and tied in a knot. Make a circular motion and let the starting end go down from top to bottom again through the belt that clings to the part of the garment.

Let the initial end pass through the circle you just made, adjust the shape and you're done.

3. Firming type

Buckle the belt to the last hole. Let the initial end pass through the hole on the left side where the belt is secured. Go through the part that was originally close to the innermost layer of the garment. Once again, go through the hole on the right to secure the belt and you're done.

4. Bow tie type

The belt starts with one end at the top and the buckle at the bottom and crosses each other. The initial end of the belt is wrapped around the end with the buckle and made a circle. Wrap the initial end of the belt around the back of the cross and run it through the loop from the bottom up.

Adjust the shape of the knot to the bow tie and you're done. In this way, the clothes are tied with simple and stylish straps.

The steps for knotting coat straps are as follows:Material preparation: coat belt.

1. The belt is crossed up and down next to the base, and the length of the side with the buckle is slightly shorter, and it is placed below.

2. The belt placed on the top bypasses the shorter belt.

3. Wrap it around the inside and tie the first knot.

4. Then pull the left belt and wrap it around the short belt on the right.

5. Pull the head of the left belt of the oak and pass it through the knot.

6. Tie the second knot of the liquid reputation, and the belt has been tied at this time. Isn't it pretty.