What causes mold and blistering on the wooden floor at the door of the bathroom, and how to solve it

The wooden board at the door of the bathroom was moldy and blistered, and I analyzed that it was because I usually wore wet slippers, so that the water remained on the floor for a long time and did not dry it in time. Solution: Replace the moldy and blistered floor and place an absorbent foot pad on the floor.

The wooden floor at the door of the toilet is very easy to mold, and the water that often drips in, and the people who come in and out will cause the wooden floor to mold and bubbles, and the best solution is to replace all the wooden floors near the toilet with floor tiles, which can well avoid this problem.

There is water on the toilet door and it will flow to the floor, but it will not flow into the restroom, it will cause soaking on the floor at the door, which will cause mold, the solution is to change the slope of the floor so that the water will flow naturally into the floor drain.

The main cause of mold on wood floors is water, such as mopping the floor but not drying it. Over time, the moisture content of the floor will increase, leading to mold growth, and the floor will become moldy and black. There is also the wooden floor is soaked, but only the surface water stains are cleaned, and the floor is not dried, so that although there is no water on the surface, there will still be a lot of moisture left under the wooden board, and you need to take out the baseboard for ventilation or remove the wooden board to dry.

The wooden floor is black and moldy. In addition to moisture, the main cause is mold. Wood floors may not have mold.

Airborne mold can also attach to the floor and multiply when it reaches a humidity suitable for its growth. Therefore, it is also very important to sterilize and prevent mildew in time. The floor can be diluted with a mild disinfectant solution, taking care to carefully clean the yin and yang corners and baseboards.

Moldy is generally found in the corners of the wall.

Treatment: If the surface layer is simple and moldy, you can mix it with warm bleach and water in a ratio of 1:3, and the moldy area can be wiped with soft tweed and detergent.

If the surface is severely moldy, you need to sandpaper the moldy part to remove the moldy spots before repainting. If there's mold in there, you'll have to replace the floor.

How to deal with it, let me briefly say that:

First, remove all the baseboards of the wooden floor to expose the edges of the wooden floor, which will be moldy and damp. Removing the baseboard facilitates the release of damp water vapor from the inside of the wooden floor. If the weather is good, open the windows for ventilation to speed up the evaporation of water vapor.

If you can, you can buy some quicklime, spread newspaper on the wooden floor, and spread quicklime, which has a strong ability to wash away the tide. If you have a dehumidifier at home, or you can turn on the dehumidification mode of the air conditioner and lock the doors and windows, you can also get rid of moisture well.

Second, if you have a vacuum cleaner at home, use a vacuum cleaner to suck up all the wood floors, you can suck up most of the flying dust and some water vapor in the cracks of the wood floor, and then wipe the wood floor with some detergents, such as warm bleach diluted with water, or special wood floor mold remover. Remember to twist as much as possible when wiping. After wiping, wipe again with a clean rag.

Third, buy some air fresheners and put them in a musty room. You can also go to the tea shop and ask them for some tea leaves, which are spread around the room. They have a strong taste absorption capacity, such as activated charcoal or something, orange peel, grapefruit peel and so on.

I think it's best to replace the floor with a new one, because if it gets moldy, the floor will arch and cause damage to the floor, so it's better to replace it all.

The water on the floor should be cleaned first, then dried with a hair dryer, and the moldy area should be repeatedly scrubbed with floor cleaner, and dried.

1.If the wooden floor is not particularly soaked in water, you only need to basically clean the water on the surface of the floor, and you can use a vacuum cleaner.

The problem of mold on the wooden floor in the bedroom can be caused by dampness and lack of ventilation. If not treated in time, mold will not only destroy the beauty of the floor, but also threaten the health of the family. Here are a few ways to deal with mold on your bedroom wood floor.

1.Maintain ventilation: Regularly open windows for ventilation can allow air to circulate quickly, reduce the accumulation of water vapor and moisture in the room, and facilitate dehumidification.

2.Dehumidification: Use dehumidifiers or moisture absorbers to effectively remove moisture in the air and dry the indoor air, thereby reducing or avoiding mold on the wooden floor.

3.Cleaning the wooden floor: Wipe the existing moldy wooden floor with a damp rag, and then sprinkle disinfectant or bleach on the floor, which can effectively kill mold. However, when using bleach, you need to pay attention to the amount and concentration to avoid damage to the wooden floor.

4.Replace the wooden floor: If the wood floor is already very moldy, the damaged floor needs to be replaced to avoid further spread.

5.Adjust the indoor temperature: If the room temperature is too low, it is easy to cause moisture to accumulate, resulting in mold on the wooden floor. Proper heating can reduce moisture and thus reduce the risk of mould on wood floors.

In short, mold on the wooden floor in the bedroom not only affects the appearance, but also affects the health. Therefore, it is necessary to pay attention to indoor ventilation, moisture-proof and dehumidification, and regular cleaning of the wooden floor to avoid the appearance of mildew on the wooden floor.

Because it is in a damp state for a long time, it will become moldy, and only need to replace the floor to solve the problem.

The floor at the door of the bathroom is moldy, because the water in the bathroom splashed at the door, and the water at the door was not cleaned up in time, causing the floor to be soaked in water for a long time and moldy.

The floor at the door of the bathroom is moldy This is because the bathroom is very damp and not ventilated in time, so there is mold.

Because it is too humid, open the windows frequently for ventilation, and keep the floor dry and clean!