Why can t school outlets be replaced with high power outlets? 5

That's a matter of assumption. The cost of changing to a high-power socket will not be much higher, but there is a voltage limit for school electricity.

If the high-power socket is used, the voltage of the school is 220V, which will affect the overall electricity consumption and even affect the lighting.

Only some industrial electricity can meet the needs of many people with high-power electrical appliances. And it is clear that the school does not meet this requirement.

Then there is 220 volts of electric voltage, which is enough for daily use, and has a certain degree of danger, and then increase the voltage, the potential safety hazards will increase exponentially. For schools, the safety of students is the first priority, and the daily electricity needs of students, that is secondary again.

There are several main aspects of the dormitory of the school with boarding students not to install high-power sockets, one is the reliability of electricity, the voltage of single-phase electricity is relatively safe between 170 volts and 230 volts, and it will not cause damage to electrical appliances. Second, the use of high-power sockets has an impact on the trunk line and switch, which increases the amount of maintenance, and it is difficult to select the appropriate line and switch, resulting in waste and no protection measures. Third, and most importantly, the potential safety hazards of electricity use are increasing, and most of the students do not understand electricity management and safety knowledge, which is prone to personal and property safety accidents.

Answer: The number of students in the school is large, if there is a high-power socket, the number of charges will rise in a straight line, and there will be potential safety hazards.

I remember when I went to college, we were charging in the classroom, and a classmate charged a hot water bottle, but it exploded, fortunately, the hot water bottle was not big, and it was filled with water, which did not cause danger, but it also scared classmates, teachers, and even the school limited the charging time at that time.

Nowadays, there are more and more electrical equipment, although the quality of sockets has improved, but it also means that there are more sources of danger. Thank you.

The school's socket is for students to recharge. Or if you use a little small electrical appliance, how can you allow the use of high-power electrical appliances? If all the high-power electrical sockets are replaced, wouldn't it be permissible for everyone to use high-power electrical appliances?

Wouldn't all the wires in the school have to be replaced? You know how big the load is -- there are so many students in the school, and everybody uses high-powered appliances. How can the school's circuit withstand it?

That's going to be a fire at every turn, you know?

This is because in the school, for the safety of everyone's life and the stability of the living environment, the school restricts the use of electrical appliances in the dormitory building!

This setting should be for safety reasons, and the use of high-power electrical appliances is not allowed.

If the school bar replaces the socket with a high-power one, the safety hazard will be greater, everyone has an induction cooker The power consumption is greater, and it is easier, I hope it can help you.

The dormitories in the school are relatively concentrated, so the trickle flows into the sea, and each dormitory adds 1000 watts, so what will happen to the 100 dormitories? What happens to 1000 dormitories? This kind of waste of resources is huge, even if you don't consider it from a safety point of view, such a large capacity is not a production unit for a school, and from the management of the national grid, you are not allowed to do so.

For the sake of safety, if they are replaced with high-power sockets, the previously designed lines will be overloaded and easy to cause disasters.

There are too many people in the school, all of them use high-power sockets, and the capacity of the lines and transformers is not enough, and it is easy to have accidents.

The load capacity is limited, and the rated current of each wire and switch has been determined, and increasing the load indiscriminately will cause tripping and potential safety hazards.

The higher the power, the higher the current, and the higher the risk of fire short circuit. The school must keep the risk to a minimum.

No matter how small the school socket capacity is, it will not be less than 10A, and the maximum power consumption of electrical appliances in the home kitchen is also 10A socket. Will the number of electrical appliances used in school be greater than the number of colors?

Avoid starting a fire.

Reduce unnecessary electricity bills.

It can be said that college students go to school to learn knowledge, the school has a canteen, bathroom, etc., has provided us with a convenient learning and living environment, there is no need to use high-power electrical appliances in the dormitory, if you want to use it, you can rent out the house, that is, convenient for yourself, and do not violate the dormitory regulations.

Because there are many college students living in university dormitories, electricity is very tight, so you must not use high-power electrical appliances, otherwise it will be very dangerous.

Physically, shunt, series and parallel, voltage and the like, it is difficult to hit, that is, the high-power wires that you connect yourself are easy to burn, and the wires of the school may also be burned. The school's wires are buried, very thick, very expensive, and it is troublesome to put it together, and it is not safe. Don't make a lot of power, I really want to go out and rent it myself.

High-power electrical appliances are prone to short circuits. Affect electricity consumption. Then it is easy to cause fires and affect personal safety.

Because the use of high-power electrical appliances may increase the burden of certain objects, it is easy to cause fires.

Prone to misfire, the electrical socket bought is not qualified.

It is prone to overload and cause other accidents. Even a very small curling iron can cause accidents, so be cautious.

Because it is easy to overcurrent high-power electrical appliances can easily cause electricity, it is very unsafe, so high-power electrical appliances are generally not allowed.

Hello, this can be used with high-power electrical appliances, but there are potential safety hazards when you secretly use them, in case the products used are unqualified, and the consequences of causing a short circuit are unimaginable, he is equipped with a socket is used with high-power electrical appliances when conditions permit, such as air conditioners.

Okay. But you are responsible for yourself.

The power limit in the school dormitory is for the safety of your students, why can't you understand it? If there is no limit, everyone uses high-power electrical appliances, the line is overloaded, and it burns, which is fatal! You are all outstanding young people, and you should have a certain sense of civilization and safety in order to be worthy of the title of college student.

Therefore, I still recommend that you follow the school's regulations and use safe electrical appliances with less power. You don't have the socket that can reduce the power, and the law of energy conversion has been taught in middle school, so you won't forget it, right?

Yes, the school limits the power only to limit the heat, that is, the current, just find a way to improve the small current, 1000w can use the heater.

Children's shoes,It's a matter of common sense.,How did you get into college.。。。

The circuits of the dormitory buildings are all powered by a three-phase four-wire system (while the dormitory only has a 220V single-phase power supply, that is, there is only a single power supply in the three-phase middle line.

version phase), and the power supply balance in the three-phase circuit is the basis of the circuit. If a dormitory uses high-power electrical appliances, it will cause an imbalance in the power supply of the three-phase circuit, which will cause serious consequences such as circuit burning, switch burning, and even single-phase burning of the distribution transformer.

The importance of three-phase circuit balancing is seen.

If the current in the circuit is too large, the circuit will be too hot (modern floor circuits are all dark lines, that is, they are arranged in the wall), and it is dangerous if the heat dissipation is not timely.

If the quality of the power strip is poor, it is easy to burn out and trip with high-power electrical appliances, and it is quite dangerous to trip, and there is also a school that is afraid of accidents.

Do you mean using electrical appliances with this plug-in board? If so, such a large power must not be used, if this socket board is 3kw15a, of course available, as long as the power of the electrical appliances does not exceed the regulations.

Generally speaking, when the original wiring, the line of the lamp is relatively thin, and the switch of the lamp is also limited by current, so it is not suitable for high-power electrical appliances after the change, but the specific situation depends on the line to know, if it exceeds the square, you can use electrical appliances with a power of about 2000w. There is no problem with about 1000w squared.

What kind of old campus is your school? The circuit is aging all kinds, and it is not easy to rectify and repair. . . Once the same is the end of the world fallen people passing by, the landlord's day mourning. . . Other ways to help the landlord think of ideas.

Go directly to the corridor to find the emergency light and connect it directly to the electricity, and you're done.

You can buy a transformer socket, and we used to boil hot water with that.

It used to be the passing by of the fallen people at the end of the world.

All schools have regulations, not afraid of danger, electricity danger, be cautious, you can't use hand warmers, just use hot water bottles, it's the same, it's man-made.

Go to the electrical appliance seller and buy a small transformer socket, and then use it to stop powering.