Question 5 about computers not being able to access the Internet

Me too: Access Violation, General Protection Fault, or Invalid Page Fault, although they are not the same, are always caused by the same kind of error. Access Visualization is often encountered when a program running by a computer user attempts to access a store that is not intended to be used.

access violation at address Hexadecimal Value

in module Application Name

read of address Hexadecimal Value

access violation at address of adress 00000000 means: In address 00000000 access violation, the reading of address 00000000 is prohibited.

Access violation at address 00000000 read of address 00000000.Here's why:

There is no server-side software running, so the client will prompt"access violation at address 00000000, read of address 0000000", open the server program or check the network cable to solve the problem.

In addition, the reason why this problem may occur is because you are running the program in a WinRar window and the program cannot find the main file.

Workaround :)

Try to run the program in a compatible way. Right-click on the icon - Properties - Compatible - check the box below "Run this program in compatible mode" - you can choose to run it in , or 2000 mode. It is recommended to choose 98 to give it a try.

Check your network cable.

See if the local connection is working.

If suddenly the computer can't access the Internet, and it's still at the beginning of the month, then you should consider whether it is the inability to access the Internet due to the arrears of the broadband network.

Generally speaking, the ** card is bound to broadband, when the mobile phone is in arrears, the broadband is naturally unable to access the Internet, because the operator has forcibly shut down the network, and it will return to normal immediately after payment.

When the network cable or router connected to the computer is loose, it is natural that you can't go to the network, which is also a very common phenomenon, and sometimes accidentally touching the network cable will cause the network cable to loosen.

At this time, you only need to replug the network cable to strengthen the connection.

The solution to the problem that the computer cannot connect to the Internet.

What network are you, how is the IP set up, can you not access the Internet or can you not open the web page to get on Q.? The question is not specific?

If you determine that the network is normal, but the software cannot connect to the network, the following reasons may occur.

First, the software server failure causes the software to be unable to connect to the Internet, which can only be networked normally after the official repair is completed.

Second, it may be caused by the instability of the local network, try to power off and restart the modem and router, and it is also possible that the device often does not shut down and causes it to crash.

Third, there may be a problem with the network configuration of the system, which can be fixed by command.

netsh int ip reset

netsh winsock reset

Restart your computer, then open the software to see if you can use it online.

Fourth, it may be that you have LAN enabled**, just turn it off.

Open the Control Panel, Internet Options, Connections, LAN Settings, Server Settings, and remove the checkmark below, as shown in the image below.

Generally, it can be repaired by going to the third step, and you can try it.

First, it can be repaired through the computer manager network repair function.

1.Open PC Manager and click Toolbox.

2.Locate the Network Repair Tool.

3.Click "Fix Now".

2. You can also use commands to reset the network.

1.Find "Run" in the Start menu

2.Then enter cmd in it

3.In the command prompt that appears, type "netsh winsock reset.""Press the "Enter" key.

It takes effect after restarting the computer.