What should I do if the wall socket is short circuited due to moisture?

The wall socket is short circuited due to moisture, reinstall the new socket of the same specification or applicable, and recheck whether there is a short circuit at both ends of the power supply.

There are many reasons why sockets are burned out, generally the following: (1) Short circuit: check whether there is a short circuit phenomenon at the accident point or each power terminal, such as socket and electrical equipment, and the instantaneous high current generated by the short circuit is the main reason for the socket to be burned; (2) Overload:

Check and count the total power of all electrical equipment, whether it exceeds the load of the circuit breaker and overloads; (3) Line aging: check whether the power supply line wires are aging. (4) Check whether the short circuit occurs due to the quality problem of the socket itself, resulting in damage.

Accident handling and power supply restoration (1) Eliminate problems such as short circuit and overload that have been checked; (2) Replace the burned socket, and wire and install it according to the specifications; (3) After confirming that the problem has been eliminated, close the upper circuit breaker or the main circuit breaker to complete the power transmission.

Cut off the power first, then remove the socket, check whether there are water stains inside, clean it up, and then use a hair dryer to dry it thoroughly before installing and resetting.

If water seeps into the power line from the wall, and then flows through the power line into the socket, causing leakage or short circuit, the wall needs to be repaired to solve the water leakage problem.

Short circuit in the wall socket due to moisture solution:

1. Remove the socket and insulate the wire;

2. Find the source of moisture and dry the wall socket.

3. Reinstall the new socket of the same specification or applicable, recheck the insulation resistance at both ends of the power supply, and it can be used normally after passing the qualification.

In this case, it is best to find a professional maintenance master to do it, because it involves the initial design of the wall.

Reinstall one and install a moisture-proof and waterproof box.

I think it's okay to replace it, I don't know why you're asking.

If the insulation layer is damaged, it is recommended to replace the wire, if there is no problem with the wire insulation, but the socket is damp, you can use a hair dryer to remove the moisture.

What can I do Disassemble and blow dry.