How to replace the silicone pad for the old Yijianeng solar bucket overflow noodle?

The old billion home can solar bucket overflow level, want to replace the silicone pad, you want to buy this silicone pad, go to ** buy online, take a look at the model before buying, and then there is a manual inside, follow the manual.

Solar water heater is our most widely used hot water equipment, and if there is a failure of not using water when using, it will definitely affect our use, and the failure of solar water heater is caused by many reasons, so today I will introduce to you some reasons why the solar water heater is not on water for you to understand.

Billion home energy energy.

The vacuum tube is damaged.

The main reason for the damage of the vacuum tube is to water the solar water heater in the morning, because the temperature in the vacuum tube is already very high at this time, it can reach more than 200 degrees Celsius, and if the cold water at this temperature is very low, it will **. Therefore, the water supply of the solar water heater must be carried out before sunrise or 1 hour after sunset. Damage to the vacuum tube will cause water to flow out of the broken hose and the water will not go up.

Problems with the upper and lower sewer pipes.

If there are upper and lower water pipes in the outdoor insulation measures are not done well, it will cause the water pipe to freeze and the water will not be able to get on, so pay attention to the warmth of the water pipe; If the water pipe is frozen and cracked or the connection head of the water pipe is loose, it will cause all the water to go up and leak out, resulting in the illusion that the water cannot be entered.

Problems with the automatic controller.

The failure of the automatic controller of the solar water heater will transmit the wrong signal or the signal cannot be transmitted, resulting in the inability to supply the water. At this time, the control panel and sensors should be replaced in time.

Product design issues.

If your home is an old-fashioned solar water heater, such as the float water supply method, the kind that does not have a controller indoors. Then there is also the possibility that the float is bad and cannot be watered. Then it is necessary to replace the float type water supply valve or float type water supply valve.

It is recommended that you change to a new type of solar water heater automatic water shut-off device, which does not need to change the original solar pipeline, and it is also very cheap.

Check the control panel.

First of all, if the control panel shows that there is no water, you can put hot water to see if it is actually empty, because sometimes the sensor will fail to send an error signal to your control panel, which looks like there is no water, but there is actually water.

Check the solenoid valve.

If the actual water is not released, it must be that the water tank has been emptied, and the water has not gone up, then it may also be a solenoid valve failure, and the solar water must pass through it to get on the water, and it will not be on the water if it does not work. Inspection method: press the water, and then turn on the shower head to adjust to the direction of hot water, there is water out to prove that the solenoid valve is working normally, if not, it is broken.

Changing the solenoid valve is very simple, only two wires, 12V DC, and it is very safe. **It's also cheap, 20-30 yuan is a good quality. (Note:.)

The solenoid valve is generally installed indoors, a white mass with two thin wires entering, which is easy to identify. )

Check the environment outside the window.

If you find that the solenoid valve is good after the water, you can suspect that there is a leakage, and stick your head out of the window to see if there is a waterfall first, because it is estimated that your situation is not on the water, either it is a huge leak (the cause of the waterfall), or the solenoid valve is not on the water at all.

If you want to change it, you need to close the main valve, and then this position can be unscrewed, and then replace it with a new one for him, and then tighten it for him.

If you replace the old Yijia energy bucket with a new one, you have to remove the old one, and install the new one to stick it tightly.

Jump the faucet of a bucket, and if you replace the silicone parts, just use a clip to jam it, and then replace it with another silicone pad.

Turn the water tank first (the exhaust hole is in the direction of the rear), if the fixing screws of your solar water tank have rusted, first loosen a few hammers, and use a wrench to loosen if it is not rusty.

If this solar water is unified with water, in the process of replacing the silicone pad, you can buy an original one, and then replace it yourself.

The old family solar water lychee water can't be changed to a focal point, as long as it doesn't leak.

The boss has a family of solar buckets all the time, if you replace the silicone, you can directly look for the manual or check it on the Internet, or directly find a professional.

If you want to replace this solar water, then it is quite troublesome, you can find a professional repairer.

If the old billion billion solar bucket overflows to a level, you can go to his after-sales service and ask.

Solar bucket, spilled water can replace the rubber pad inside can solve the problem.

If you don't know how to replace it, if you have a silicone pad, you should find some related technology, or read the relevant book manual.

The old solar strip can be replaced directly.

If the solar bucket is water, the intersection must be changed with good airtightness, and it should be noted that it should be particularly quiet.

The same solar bucket 19 should not be verified at all, it should be more binding, and it will only enter after makeup to engage in that**.

Including billions of solar buckets, you should pay more attention to some of his news, and find a professional to tell you.

The old e-home can solar bucket overflow nozzle, if you want to hang a replacement rubber pad, if you want to replace the silicone pad, then you can teach others to help you change it.

The old family can solar water bucket, and the water can replace the silicone pad.

How to replace the silicone pad with a water faucet for the old family solar bucket This personal suggestion is that you call the **after-sales service to show you.

Start by draining the water in the water heater.

Scrub the glass tube clean.

Hold the glass tube tightly with both handsClockwiseand turn it counterclockwise so that the glass tube is loose, mainlySealsAdhesion to glass tubing after exposure to heat.

After the glass tube is loosened, insert a section of the glass tube into the bucket to make the lower head of the glass tube come out of the base, and then slowly pull the glass tube out of the bucket.

Solar water heaters.

is the sun's rays.

The branch trembling heating device that can be converted into heat energy heats water from low temperature to high temperature to meet the hot water use of people in life and production. Solar water heaters are divided into vacuum tube solar water heaters and flat panel solar water heaters according to their structural form, mainly vacuum tube solar water heaters, accounting for 95% of the domestic market share.

The vacuum tube household solar water heater is composed of heat collector tubes, water storage tanks and brackets and other related spare parts, and the conversion of solar energy into heat energy mainly relies on vacuum collector tubes, which use the principle of hot water liquid imitation floating cold water sinking, so that the water produces microcirculation.

And get the hot water you need.