What method can be used to wash walnuts clean and healthy

If walnuts need to be cleaned, the main purpose is to clean up the remaining green skin residues and dust in the walnut texture. The residue of the green peel remains in the texture due to the incomplete treatment at the time of initial peeling, and after a period of drying, it adheres to the outer skin of the walnut. Here's how to clean it up:

Depending on the amount of dirty things, soak the walnuts in clean water (natural temperature) for 30---100 minutes, just soak in the water is to brush the walnuts with a toothbrush first, so that the water can completely contact the bottom of the walnut texture, otherwise due to the tension of the water, the bubbles will separate the water. After the residue in the texture is softened, first use a needle to pick out the residue one by one, and then clean it repeatedly with a toothbrush dipped in water until the surface of the walnut is clean. Remember:

Do not use things such as detergent and detergent 84, these chemicals are extremely penetrating and can easily cause walnut cracking!! After cleaning, immediately use a paper towel to absorb the water, just cleaned walnuts can not be played with in the hand immediately, must be thoroughly dried, at least three days, preferably a week! The way to dry in the shade is to put it in an unsealed envelope or other bag, and then put it in a drawer, the key is not to see the wind!

This is very important, if it is a freshly washed walnut, even if it is played with in the trouser pocket with your hand, if it is outdoors in a windy environment, it will crack! Therefore, you must wait for the moisture of the walnuts to completely dissipate before starting to play. The purpose of this is to prevent the walnuts from cracking!

1. Dry brushing: Do not use water, use wild boar bristles and steel brushes, and use steel brushes to thoroughly clean the dirt on the peach pit first. The disadvantage is that the peach pit will be blackened; If the brush is heavy, there will be scratches, and the wear marks will disappear soon after a long time (similar to the wear marks of Xingyue dry grinding) The steel brush needs to shake the peach pit, and then clean it rhythmically.

Finally, use a wild boar bristle brush to clean up the residue, which is equivalent to polishing.

2. Water brush: Use warm water to reduce a temperature difference (reduce the cracking factor), there is a possibility of peach pit cracking (in fact, the peach pit will be covered by small cracks). Use a stiff brush with less water for quick brushing.

It is best not to soak the peach pit, then quickly dry it with a towel, wrap it in a towel or newspaper and dry it in the shade, and then dry brush.

1. Soak the walnuts in clean water for 10 minutes to soften the dirt on the surface and facilitate subsequent cleaning.

2. Use a pick-up needle to pick out the dirt in the groove, the dirt in the groove is more difficult to clean, and use the pick-up needle to gently remove the harder pollutants.

3. There are many pollutants on the surface, and the dust on the surface can be directly removed by using a stiff brush, and the fine pollutant dust in the hook is cleaned with a slender soft brush.

4. There is no special brush, you can use a toothbrush, use a dry paper towel to wipe the moisture on the surface of the walnut, and you can use a cotton swab to wipe the moisture in the groove.

5. Place it in a ventilated place for drying, natural drying, and cannot be directly irradiated in the sun to avoid cracks caused by heating of walnuts.