Can pine hair soil grow flowers directly? Can pine needle soil grow flowers directly?

You can plant flowers directly. Because it has been fermented and rotted, it is a slightly acidic soil, suitable for rhododendron, jasmine, and iron trees.

Camellia and other slightly acidic flowers are planted. There is no need to mix other substances, and fermented organic fertilizer should be added to ensure soil fertility.

Cultivation methods. 1. Scorching method: After the end of the flower branch is burned on the candle flame, it is immediately soaked in alcohol for one minute, and then rinsed in clean water. Hydrangea, cloves, woody.

Peony, moon, chrysanthemum, ivory, etc. can all be treated with this method.

2. Blanching method: immerse the base of the flower branch in boiling water for about ten seconds to block the incision and prevent the sap in the flower branch tissue from overflowing.

3. Deep water first aid method: when the flower hangs its head, you can cut off a small section of the end of the flower branch, and then put it in a container filled with cold water, leaving only the flower head exposed on the water surface, and after one to two hours, the flower branch will wake up. This method is applicable to both herbaceous and woody flowers.

4. Use preservative method: add an appropriate amount of flower preservative to the container of flower arrangement, which can prolong the time of flower arrangement. In addition, with aspirin in one thousandth.

Aqueous solution or 1/2000 potassium permanganate.

Aqueous solution can prolong the flowering period by three to five days, and add an appropriate amount of boric acid, sulfur, carbolic acid, and salicylic acid.

Salt, vitamins, etc., all have the effect of prolonging the flowering period.

5. Enlarged incision method: generally the base of the flower branch is obliquely cut; Or cut the base into two to four parts, embed small stone particles to support the crack; It can also hammer the crack base to expand the water absorption surface. Among them, the bevel cutting method is the most commonly used, and the latter two are mainly used for woody flowers, such as magnolia, hydrangea, lilac, and wisteria.

6. Sterilization method: put alcohol, KMNO4, camphor, boric acid and citric acid in the water.

Salt, alum. and so on can play a sterilizing role, only the water does not rot, the plant can absorb water and keep fresh. Note: It must be prepared into a solution before use, not directly put into water without dissolving, and pay attention to the concentration when using salt.

7. Nutrition method: After the flowers are cut from the mother, they lose their nutrient source, and sugar, beer, aspirin, and vitamin C can be added

and other nutrients.

8. Spray body and injection method: For many flowers with hollow stems, the flower feet can be placed under the faucet to forcibly irrigate.

Notes:1Keep the water clean: change the water every day, cut the roots every day to reveal new crops. Remove excess leaves from the soaked area.

2.Stay away from heat-boosters Ethylene: Stay away from vegetables and fruits, as they release large amounts of ethylene, which can cause flowers to decay, and at the same time, remove fallen flowers and fruits in time.

3.Freshness temperature: about 5 degrees for ordinary flowers and about 10-12 degrees for tropical flowers.

4.Location: Keep away from direct sunlight in summer and away from wind outlets in winter.

It's okay to plant sour-loving plants, but it's not good to grow jade.

1. Can you plant flowers, pine needle soil can be used directly to grow flowers, but not all flowers are suitable for planting with pine needle soil. Growing directly with it may cause insects to grow because the soil may contain a large number of eggs, and small insects will grow after planting, but they will not regenerate after fermentation.

Second, what kind of plant is suitable.

It is more suitable for planting orchids, which can promote them to grow more vigorously, if it is used to plant plants that love alkaline soil, it may be out of place, resulting in weak plant growth, so before use, it is necessary to distinguish the characteristics of the plant to avoid bad effects.

3. Benefits. 1. The water absorption capacity of this soil is particularly good, and the air permeability effect is not bad, which can make the water penetrate quickly, which is mainly because its soil quality is relatively loose.

2. It contains more nutrients, which can meet some needs of plants, and for some plants, its existence is crucial and unshakable.

1. The soil around the pine tree is now only permeable and breathable, and it has not reached the conditions for raising flowers.

2. Because the flowers are planted on it, on the one hand, the water permeability is too good, and the water retention is not retained, on the other hand, the root system of the flower can not contact the soil well, because the gap is too large, so the soil next to the pine tree is permeable, permeable, and acidic, but it is not in contact with the root system, so it should be used after treatment.

3. The effect of soil on plants: most plants are difficult to grow in the case of pH > or ". Plants can grow normally in a wide range of air punches, but each plant has its own suitable pH.

Acid-loving plants: Rhododendron, Bilberry, Camellia, Cunninghamia, Acacia pine, Rubber tree, Pyrolia; Calcium-loving plants: alfalfa, rhinoceros, southern Tianzhu, cypress, linden, elm, etc.; Likes saline plants:

Tamarix, sand dates, wolfberry, etc.

4. Plant diseases and pests are directly related to soil acidity and alkalinity, and underground pests often require a certain range of pH environmental conditions, such as bamboo locusts like acid and beetle likes alkali; Some diseases occur only within a certain pH range, such as macularity, which tends to occur on alkaline and neutral soils.

5. Soil active aluminum: exchangeable aluminum adsorbed on soil colloids and aluminum ions in soil solution, it is an important ecological factor, which has a significant impact on the distribution, growth and succession of natural vegetation.

1. The soil around the pine tree is now only a wax letter that plays a role in water permeability and ventilation, and has not yet reached the conditions for raising flowers.

2. Because the flowers are planted on it, on the one hand, the permeability is too good, and it does not retain water, on the other hand, the root system of the flower can not contact the soil well, because the gap is too large, so the soil permeability wheel next to the pine tree is good, and the permeability and acidity are good, but the potato Zen is not in contact with the root system, so it should be used after treatment.

3. The influence of soil on plants: most plants are at pH > or.

Growing flowers requires loose soil; Loosening soil can increase the void between the soils, which is convenient for the roots of plants to respirate and promote growth. Nowadays, most flower pots are made of resin or plastic, which is not conducive to the respiration of plant roots, so loosening the soil is particularly important.

Flower soil has nutrient soil, peat, pastoral soil, etc., in these soils the pastoral soil is easy to compact, that is, the surface of the flower soil forms a layer of hard shell, which seriously hinders the root respiration of plants.

Choose loose soil to pay attention to the timing, seedlings or just change the pot naturally do not need to loosen the soil, at least more than three months and then loosen the soil, combined with to observe the degree of potting soil compaction, the speed of each watering and seepage, each time the time used to water through. If it is a year or two of potting soil, then you can directly change the pot.