How to dredge the blockage of the drainage hole in the refrigerator fresh keeping room

1. Disconnect the power supply of the refrigerator, then open the door of the refrigerator and let it stand for a while to let the ice in the drain melt as soon as possible. 2. Find a pump to pump up your bike. Insert the air hose of the pump into the drain hole of the refrigerator, and then pump up the air to let the drain pipe of the refrigerator penetrate.

3. After that, use a long wire to insert it into the drainage hole for dredging. Related extended knowledge: 1. It should be noted that when performing the above operations, be sure to turn off the power and clean up the foreign objects in the refrigerator.

2. When installing the refrigerator, pay attention to placing it in a place with relatively low humidity, so as to avoid rust on the shell, compressor, condenser and other accessories of the freezer and affect the service life of the freezer. 3. Refrigerators are divided into absorption and compression refrigerators, because the working principle is different, the effect and scope of use are also different, because the absorption refrigerator has a relatively low use efficiency, and the cooling is relatively slow, and it is rarely used now, and most of the refrigerators we use now are compressed.

Hunan Jusheng Drilling Company can drill deep-water wells, Hunan Changde, Jishou No. 1:

1.If the drain hole of the refrigerator is blocked by ice accumulation and cannot drain water, disconnect the refrigerator from the power supply first when cleaning. After emptying the contents of the refrigerator compartment, open the door of the refrigerator compartment and let it sit for a period of time to allow the ice in the drain pipe to melt.

2.The drain pipe of the refrigerator was clogged with accumulated ice. Generally, the low temperature inside the refrigerator causes the refrigerator drain hole to be blocked by frost, or some food or vegetable residues that have not been cleaned up in time inside the refrigerator enter the drain pipe and block the pipe.

When cleaning, look for a bike pump. The diameter of the air tube of this pump can be close to the size of the refrigerator drain hole.

3.When using this pump, the upper fitting is removed to expose the trachea.

4.Insert the air pipe of the water pump into the drain hole of the refrigerator, then pump the water hard to make the drain pipe of the refrigerator through, then inject a small amount of clean water into the drain hole of the refrigerator, and then rinse the water pump repeatedly to pour out the water in the water supply tray of the refrigerator. Simply install the fridge's baffle.

II: 1When food debris enters the refrigerator and causes the refrigerator leak hole to be blocked, we need to cut off the power of the refrigerator first when cleaning.

2.After that, the long plastic plug is removed from the refrigerator drain hole, and then inserted into the refrigerator freezer drain hole with a long strip for unclogging.

3.After the above steps are completed, take a glass of water and pour it into the refrigerator drain hole. If water easily enters the drain hole of the refrigerator, the drain hole of the refrigerator has been unblocked.

A geothermal well was drilled on Fengcheng 5th Road before. Now most of them are digging wells in Inner Mongolia and northern Shaanxi. Like you said, there are certainly no plastic tube wells in Xi'an, not even in the whole country.

1. When found on the bottom plate of the refrigerator fresh-keeping cabinet, if water accumulates frequently, it may block the water outlet of the refrigerator; 2. You can use a dry rag to absorb the stagnant water in the refrigerator; 3. Generally speaking, the water outlet of the refrigerator is in the fresh-keeping cabinet on the top of the refrigerator. After the fresh-keeping cabinet is opened, look for it on the inside of the back of the middle layer; 4. There is a water outlet on the back of the fresh-keeping layer, and a water guide device is provided at the position of the water outlet. 5. First of all, take out the foreign matter at the entrance of the refrigerator drain hole, and pour a small amount of water into the cup mesh drain hole.

Check that the drainage is unblocked. If the drainage is not smooth, it proves that the drainage hole is blocked. Then use a cotton swab or chopsticks to slowly remove the blockage, and then wipe the hole clean so that the water outlet of the refrigerator is clogged.

The refrigerator fresh-keeping drainage hole is blocked, and the bridge can be disturbed to dredge it with a refrigerator dredger.

If you accidentally plug the drain hole of the refrigerator, you can effectively solve the problem with some special dredging tools. Professional tools will be more efficient, and will better help everyone, and deal with the problem of the refrigerator, too. There are many people on the market who sell dredge pants, and you can choose some convenient ones to buy and use.

The refrigerator dredge sold online is generally made of a slender steel wire, so if conditions permit, you can also use steel wire to make it yourself, but if you buy it online, there will be a fine brush on the steel wire, which can clean the drainage hole more cleanly. The method of use is very simple, just put the refrigerator unclog into the drain hole, and then press down to dredge it.

Precautions for using the refrigerator

1. Control the temperature.

If the temperature of the refrigerator is too high, there is no way to store food better, and the temperature is too low, which increases the power consumption of the refrigerator. Generally, the refrigerator room is controlled at 0-5 °C, and the freezer room is about minus 18 degrees Celsius to minus 25 degrees Celsius. It can also be adjusted appropriately according to needs.

2. Clean regularly.

Clean the inside of the refrigerator regularly, and wipe the refrigerator door seal to ensure that the seal is airtight and clean. It is recommended to wash the surface and interior of the refrigerator with a mild detergent every 1-2 weeks.

3. Arrange food reasonably.

Store different types of food in separate areas to avoid food smell transfer and better ensure that the smell inside the refrigerator is clean.

4. Defrost regularly.

Check the back of the refrigerator and freezer compartment regularly, and defrost manually when there is a lot of frost. Generally, refrigerators are equipped with automatic defrost function, but it is necessary to choose the defrosting time according to the type of food, which may not be suitable for all foods, and may need to be cleaned by hand.

When the refrigerator fresh-keeping drain hole is blocked, it is recommended to follow the steps below to unclog:

1.Unplug the refrigerator first. For safety reasons, when unclogging is carried out, the power plug should be unplugged first.

2.Find the location of the drain hole. Depending on the model and brand of refrigerator, the location of the drain holes is also different. In general, these drain holes are located at the bottom of the freezer or cold compartment.

3.Use a professional drain needle. There are some tools on the market that are specifically used to clean the drain holes in your refrigerator, known as drain needles. You can buy them at a home repair tool shop or appliance repair shop.

4.Start unblocking. Insert the drain needle into the drain hole and move it up and down several times to remove any ice or debris that has accumulated in the drain.

5.Wash with warm water. If the drainage hole has not been cleaned for a long time, it can be rinsed with warm water or wiped with a soft brush after cleaning, and rinsed or wiped again at the drainage hole and drainage pipe.

6.Connect the power supply. After completing the dredging, plug the power plug back into the socket, and turn on the refrigerator switch to restore the power supply.

Finally, it should be noted that if the drain pipe problem cannot be solved, it is recommended to consult a professional home appliance maintenance personnel to deal with it to avoid unnecessary losses and troubles.

A clogged drain hole in a refrigerator is usually caused by the accumulation of debris such as food debris, grease or dust on the drain hole, resulting in poor water flow. Here's how to deal with it:

1.First, turn off the power of the refrigerator and unplug it, open the drawers of the refrigerator fresh-keeping layer and freezer layer, take out the back panel of the refrigerator and clean up the clutter inside.

2.Find the location of the drain hole and clean it with a small tool such as a hook or straw. You can pour in some warm water or white vinegar to soften and dissolve the debris before cleaning it up with a tool.

3.After cleaning, rinse the drainage holes and pipes with clean water to ensure smooth drainage.

It should be noted that when cleaning the drainage hole, be careful not to damage the drain pipe or drainage basin to avoid causing water leakage. In addition, clean the inside of the refrigerator regularly and keep it dry, and do not store expired or spoiled food in the fresh-keeping or frozen layer to avoid causing the drain hole to clog.

1.Use a needle or a thin stick to clean the drain hole: Insert the needle or thin stick into the drain hole and gently rotate and move it to remove any blockages.

2.Use a straw to suck out the blockage: Insert the straw into the drain hole and suck out any blockage firmly.

3.Use hot water to flush the drain holes: Pour hot water into the drain holes and let it run through the blockages to soften and flush them.

4.Use vinegar and baking soda to clean the drain holes: Pour the baking soda into the drain holes and pour in the vinegar.

This will create a chemical reaction that creates bubbles and foam to remove any blockages with local beats. 5.Use a professional drain cleaner:

If none of the above methods can clear the blockage, you can use a professional drain cleaner. Use as directed on the instructions.