4 ways to solve the problem of tire pressure monitoring light on?

There are four main situations when the tire pressure monitoring light is on:

1. The tire pressure monitoring light is on due to the tire being punctured.

This situation is usually very slow air leakage, for a while can not find out which tire is the tire, at this time you can use the tire pressure gauge to measure, front, rear, if there is a lack of air, make up, and then observe the tire pressure warning light, if a few days later and on, may have to pick the tire to check. The usual way for the maintenance staff in the 4S shop is to adjust the pressure of the two front tires to, adjust the pressure of the rear tires, and then cut off the tire pressure alarm, and let us run another day to see, if you don't call the police again, it will be no problem, and then the police may have a tire that has been punctured, and you need to go to the 4S shop again, so that they can help check and check.

2. The tire pressure monitoring light is on, sometimes the tire pressure is too high.

Generally, the international GBT 2978-2008 standard stipulates that the inflation pressure of car tires meets the requirements of Table 1-Table 15

Standard tires:; Reinforced tires:; Maximum air pressure: should not be greater than. Therefore, when there are tires that exceed them, the tire pressure monitoring light will also be triggered, and 3. The tire pressure monitoring light will be on due to low tire pressure driving time for too long.

This situation usually occurs when the tire pressure is too low, and the tire temperature rises due to high-speed operation, which causes the tire pressure to rise, and then the tire pressure rises, so you should stop and rest or replace the spare tire in time.

4. The tire pressure monitoring light is on due to the low tire pressure that has not been refilled for a long time.

When the air pressure is lower than the bottom, the tire pressure monitoring light is on, so you should usually do a check to see if the tire pressure detector is normal. When the car is in trouble, if the tire pressure monitor does not alarm in time, it is a problem with the tire pressure monitor; If the ignition switch is on start, and the indicator point and the TPMS indicator light are on at the same time for 2s and then go off, then this situation is either that the original receiver of the vehicle has not been learned to bind, or the receiver controller has been replaced, and the receiver controller has not been learned to bind. You can go to the 4S store and ask professionals to use handheld learning tools to re-obtain all tire sensor IDs and bind the receiving controllers.

The tire pressure warning light is on to indicate that the tire pressure of the four tires is not in the normal range, generally the tire is out of air due to slow air leakage or nails, or the tire pressure is too high, which will cause the tire pressure alarm.

It is recommended that you get out of the car to see the 4 wheels, which lack of air should be able to be seen directly, if you can't see it, drive the car to the auto repair shop to measure the air pressure, if which tire is low, it is the tire that is flat, it is recommended to repair it, if the tire pressure is too high, you can deflate and other tires to maintain balance.

The standard air pressure of the tyres is indicated on the driver's side of the door or on the side of the door (this standard value can also be found on the fuel tank cap and on the instruction manual). It should be noted that there are different standard units for the expression of air pressure, generally there are 3 or 4 types.

Just as the weight is expressed in kilograms, there are also 3 4 units on the barometer, such as kg m2, bar, psi and kpa, and the conversion relationship between them is as follows: 1 bar =.

Baiye Auto Parts Network suggests that the owner does not care how to calculate, just look at the position of the pointer on the barometer, what unit is used to mark this position, and then see what is the standard value of the corresponding air pressure unit of the vehicle. See how much difference there is between the measured value and the standard value, if it's too high, let off some air, if it's low, and make up the air until the tire pressure matches the standard pressure.

Insufficient or too high tire pressure may cause the tire pressure light to illuminate. We can slowly drive the car to a garage or beauty shop to adjust the tire pressure. If you have a built-in pump, you can adjust it on the spot.

If the tire is punctured, the tire pressure is too high, the driving time at low tire pressure is too long, and the tire pressure light is not inflated for a long time, the tire pressure light will be on. If you want to turn off the tire pressure light, you need to manually adjust the tire pressure to the appropriate value. If the tire pressure is normal, the maintenance personnel should use a professional decoder to clear the tire pressure light fault code.

Start by looking for the tire pressure reset button. In general, the buttons are near the gear lever or on the left side of the steering wheel, or above the brake pedal and inside the glove box. If you can't find the button, look at the center display for vehicle settings. If you have a vehicle setting, reset it in the settings.

The tire pressure monitoring system can be said to be a very useful on-board device, which can immediately feedback to the owner whether the tire pressure is normal, and then eliminate potential safety hazards. When the tire pressure monitoring light of the car is on, it means that the tire pressure of the four tires of the current car is deviated, and the tire pressure needs to be checked.

When driving a tire with significantly insufficient inflation pressure, the tire can overheat, leading to tire failure. In addition, underinflation can reduce fuel economy, shorten tread life, and can affect the vehicle's handling and braking performance.

Generally, the tire pressure value of a car is between and normal. Tire pressure standards are available next to the cab door, and some labels also include air pressure in both no-load and heavy-duty situations. Car owners can refer to the above standards to control tire pressure.

Since factors such as road conditions, seasons, and loads will affect tire pressure, car owners can make appropriate adjustments according to these changes.

There is a storage compartment opposite the driver's seat. This storage box has a tire pressure monitoring switch button and a tire pressure monitoring icon above the tire pressure monitoring switch button. If the tire pressure warning light on the dashboard is on, you can press and hold the tire pressure monitoring button in the storage compartment until the alarm light on the dashboard disappears.

This is a way to reset the tire pressure monitoring system. That's why the tire pressure monitoring light is on.

The amount of tire pressure monitoring is actually to remind the owner that the tire pressure is abnormal, and a comprehensive performance test of the tire is required. Once the tire pressure is normal, the light will go off.

After the tire pressure is insufficient, it is replenished to the left and right. Then drive the car and run for a while to see if the tire pressure alarm will be lifted.

Turn off the engine, then let out some air from the car tires, find the car's dashboard and press the button to reset the car tire pressure, you can eliminate it.

First of all, we should check the tires, and we should also go to the 4S shop for repairs several times, or to correct them, so that an important fault light can be extinguished.

If the tire pressure monitoring light is on, then it has a lot to do with the abnormal tire pressure of your car, and we can restore the factory settings.

If you are driving on the highway, if the tire pressure monitoring light is on, you don't have to be too nervous, you can turn the turn signal to slow down and park the car in the emergency lane, get out of the car to see if there is a tire with obvious insufficient air pressure, if there is a tire with obvious insufficient air pressure, then it is best to replace the spare tire. My SUV long-term tire pressure is too high, the tire pressure alarm is always on, has lasted for more than a year, during the high-speed nearly 5,000 kilometers, nearly 5,000 kilometers in the urban area, recently the tire pressure may have slowly dropped a little, and the warning light is not on.

Reasons and solutions for the tire pressure light: (1) The tire pressure monitoring light is on due to the tire being punctured: this situation is usually very slow air leakage, and it is impossible to find out which tire is the tire for a while, at this time, you can use the tire pressure gauge to measure, front and rear, if there is no air, the tire pressure warning light is on, and the first thing to suspect is that the tire has an accident (sometimes because of the driving computer).

If the attitude and direction of the perceived vehicle are controllable, the emergency lane should be changed to the emergency lane and stop slowly, and the tire condition should be checked after the safety warning signs are set.

But you can't ignore this situation, you should stabilize the steering wheel, slow down, hit the right turn signal, slowly park in the emergency parking strip, turn on the double flash, and place the warning sign about 100 meters behind the car. During maintenance, the air pressure is higher than the standard air pressure, the temperature rises at high speed for a long time, and the gas has the physical properties of thermal expansion and cold contraction, and the tire pressure will trigger the system's high pressure alarm.

If the tire pressure indicator lights up on the highway, it's best to find the nearest service area for repairs. If you have your own inflating device, you can check which tire is not full of air pressure, and then inflate it until the tire pressure indicator goes off. If the tire pressure monitoring system warning light is on during driving, stay calm, don't panic, immediately reduce your speed and avoid hitting the steering wheel and braking hard, and check your tires immediately.

First of all, it is not that it is completely impossible to drive, come down and check the tires, and if it can still be driven, then go to the nearby service area for maintenance as soon as possible. If it really doesn't work, then you can only pull over and change the spare tire.

In this case, the regular operation of the owner is: first find a safe place to pull over, if the naked eye can not observe the obvious tire air and other imbalance, then after ignition, press the tire pressure button to reset. Continue to drive for a while, if the monitoring light is on again, inflate and balance the vehicle's four tires to the standard value, and then press and hold to reset.

Tire pressure is the pressure of the air inside the tire, too high and too low will shorten the life of the tire. Sometimes the tire pressure test light is on, and it is possible that the tire has been punctured by a hard object such as nails, resulting in a slow tire leak and an unbalanced tire pressure, which can generally be observed by the naked eye. In this case, there is no need to panic, as long as you don't pull out the hard objects that have been punctured, the tires will only slowly bleloaf, and you can completely drive the car to a 4S shop or repair place.

If the tire is badly damaged, you need to replace the spare tire and drive it to a repair shop for inspection.

First of all, turn on the double flash to pull over and find the tire pressure alarm, first turn on the double flash to slow down, observe the front and rear safety, and then pull over to the right side of the road. First turn on the power of the instrument, and press and hold the reset button until the tire pressure is low and the alarm light goes out. Press and hold the reset button again until the tire pressure is low and the warning light flashes three times and goes out.

After 15 minutes of driving at a speed of 30 km/h, the initial completion returned to normal.

It should be solved by going to the repair shop, and the repair shop will solve the problem of tire pressure by dealing with it, so that its light will not come on.

At this time, it is very likely that there is a problem with the circuit, and we need to go to a 4S shop or a special maintenance place to overhaul it.

1. Drive slowly, find a safe place to park, then turn off the engine, start the vehicle again after 1-2 minutes, wait for the vehicle to run stably and check the tire pressure value displayed on the dashboard.

2. Insufficient tire pressure or high tire pressure may cause the tire pressure light to light up, we can slowly drive the car to the car repair shop or beauty shop to adjust the tire pressure, if there is a self-contained car gas pin device can be adjusted in situ.

3. In the process of inflating or deflating the tire pressure, observe the display of the tire pressure light on the dashboard of your vehicle, and wait for the tire pressure light to go out to remind you to stop inflating.

4. If the tire pressure light still does not go out after adjustment, it means that it needs to be turned off manually, and you can find the setting button on the central control instrument panel of the car to reset the tire pressure, usually by pressing the set button.

5. If the vehicle does not support manual operation, let the maintenance personnel use a special decoder to clear the fault code under the condition of ensuring that the tire pressure is normal.