How to turn off the Sonata tire pressure monitoring light

Tire pressure. The fault light is usually caused by the following conditions: 1. The tire is punctured; 2. The tire pressure is too high; 3. The driving time of low tire pressure is too long; 4. The tire pressure that has not been inflated for a long time becomes low.

So what to do when the tire pressure light comes on? How to eliminate the tire pressure light? We can do this as follows.

1. Drive slowly, find a safe place to stop, then turn off the engine, start the vehicle again after 1-2 minutes, wait for the vehicle to run stably and check the tire pressure value displayed on the dashboard;

2. Insufficient tire pressure or high tire pressure may cause the tire pressure light to light up, we can slowly drive the car to the car repair shop or beauty shop to adjust the tire pressure, if there is a self-contained inflation device can be adjusted in situ;

3. In the process of inflating or deflating the tire pressure, observe the display of the tire pressure light on the dashboard of your vehicle, and wait for the tire pressure light to go out to remind you to stop inflating, and if you charge too much, release the excess gas (in the case of two people);

4. If the tire pressure light still does not go out after adjustment, it means that it needs to be turned off manually, and the setting button can be found in the central control instrument panel of the car to reset the tire pressure, usually by pressing the set button;

5. If the vehicle does not support manual operation, let the maintenance personnel use a special decoder to clear the fault code under the condition of ensuring that the tire pressure is normal.

Hello, may I ask whether the tire pressure monitoring light is always on or flashing bright, always on: if it is an air leak, it is recommended that after refueling the tire, the speed of 40 or more will disappear automatically after driving for 1 2 minutes. Twinkle and twinkle:

The main reason is that the data of the tire pressure monitoring computer and the tire pressure sensor are lost, and the computer needs to be matched!

There is a tire pressure reset switch next to the gear lever, press and hold for 3 seconds! It's time to reset.

Hello, the tire pressure of the four wheels is adjusted to the same, and it will be automatically eliminated after going out for a lap.

Add all to within 60 yards and run for 15 minutes.

In this case, the regular operation of the owner is: first find a safe place to pull over, if the naked eye can not observe the obvious tire air and other imbalance, then after ignition, press the tire pressure button to reset. Continue to drive for a while, if the monitoring light is on again, inflate and balance the vehicle's four tires to the standard value, and then press and hold to reset.

Tire pressure is the pressure of the air inside the tire, too high and too low will shorten the life of the tire. Sometimes the tire pressure test light is on, and it is possible that the tire has been punctured by a hard object such as nails, resulting in a slow tire leak and an unbalanced tire pressure, which can generally be observed by the naked eye. In this case, there is no need to panic, as long as you don't pull out the hard objects that have been punctured, the tires will only slowly bleloaf, and you can completely drive the car to a 4S shop or repair place.

If the tire is badly damaged, you need to replace the spare tire and drive it to a repair shop for inspection.

Modern SonataTire pressure monitoringThe light came on and lifted it

1. Press the brake pedal of the car firmly and prepare to turn on the power supply of the whole car.

2. Press the car's one-button start button.

3. The instrument lights up, and the power supply of the whole car is turned on.

4. Inflate the four tires of the vehicle to the standard air pressure.

5. Press the elimination button of the vehicle's tire pressure warning light for 3 seconds.

1. After the tire pressure indicator light of the eighth-generation Sonata of Beijing Hyundai is lit, there is no button for manual reset, and it will automatically turn off after driving the car for a certain distance.

2. Specifically, as long as the speed is greater than 20km h during driving and more than 4 minutes of continuous driving, it can be automatically extinguished.

3. The independent tire pressure monitoring system of Suoba is designed as follows: if the tire pressure is 25% lower than the specified tire pressure in one of the four tires, the system will light up the warning light to remind the driver and inflate the tire in time.

If you drive at a speed of 40 or more for 1 or 2 minutes, it will disappear automatically.

Flashing and shining: The main reason is that the data of the tire pressure monitoring computer and the tire pressure sensor are lost, and the computer needs to be matched.

When emergency avoidance, ESP intervenes to increase the rotational force of the driving wheel; When there is a tendency to flick, the ESP brakes the other wheel to reduce rotation, helping the vehicle to comply with the driver's steering intention.

Hello, I am helping you to inquire about the relevant information and will reply to you immediately.

The tire pressure failure light is usually caused by the following conditions: 1. The tire is punctured; 2. The tire pressure is too high; 3. The driving time of low tire pressure is too long; 4. The tire pressure that has not been inflated for a long time becomes low. So what to do when the tire pressure light comes on?

How to eliminate the tire pressure light? We can do this as follows. 1. Drive slowly, find a safe place to stop, then turn off the engine, start the vehicle again after 1-2 minutes, wait for the vehicle to run stably and check the tire pressure value displayed on the dashboard; 2. Insufficient tire pressure or high tire pressure may cause the tire pressure light to light up, we can slowly drive the car to the car repair shop or beauty shop to adjust the tire pressure, if there is a self-contained inflation device can be adjusted in situ; 3. In the process of inflating or deflating the tire pressure, observe the display of the tire pressure light on the dashboard of your vehicle, and wait for the tire pressure light to go out to remind you to stop inflating, and if you charge too much, release the excess gas (in the case of two people); 4. If the tire pressure light still does not go out after adjustment, it means that it needs to be turned off manually, and the setting button can be found in the central control instrument panel of the car to reset the tire pressure, usually by pressing the set button; 5. If the vehicle does not support manual operation, let the maintenance personnel use a special decoder to clear the fault code under the condition of ensuring that the tire pressure is normal.

The eighth-generation Sonata tire pressure reset method:

1. The tire pressure monitoring function on the on-board intelligent system is only set when the vehicle is stopped;

2. Turn on the ignition switch, enter the instrument cluster menu through the steering column switch or the switch button on the multi-function steering wheel, select "Comfort System Settings", and click the "Tire Pressure" option;

3. Select "Pressure Monitoring", at this time, the instrument displays the tire pressure monitoring status, we select the storage wheel pressure in the settings, and click to confirm;

4. After the inflation pressure is stored, the tire pressure is set and the alarm light is extinguished;

5. The operation method of tire pressure monitoring reset is: turn on the start ignition switch, press and hold the tire pressure monitoring reset button, and let go after hearing the sound of "knock", at this time, the tire pressure monitoring system will store the normal tire pressure data at this time, and then automatically clear the original data, and finally the fault light of the dashboard is extinguished. This method is only available on certain vehicle models, as described in the vehicle's owner's manual.

This can be reset directly in the car operating system. Select the car operating system in the center of the car, drag it to the back and you can see that there is a maintenance and maintenance. Go in and select the tire pressure mode, then click Save Data so you can reset it.

Press the tire pressure monitoring button for two seconds, hear the sound of "dang", the tire pressure monitoring warning light will go off, and the initialization of tire pressure monitoring will be completed after two or three kilometers of driving.

It's very convenient to go to 4s to clear.

It's simple to have a manual lift tool;

Modern SonataTire pressure monitoringThe light came on and lifted it

1. Press the brake pedal of the car firmly and prepare to turn on the power supply of the whole car.

2. Press the car's one-button start button.

3. The instrument lights up, and the power supply of the whole car is turned on.

4. Inflate the four tires of the vehicle to the standard air pressure.

5. Press the vehicle's tire pressure warning bureau leakage light to eliminate the Zhengzhou button for 3 seconds to shout the wax mask.

The elimination of the tire pressure monitoring light of the car can be eliminated by the SET button on the car, and the specific operation steps are as follows:

1. Press the brake pedal of the car firmly and prepare to turn on the power supply of the whole car.

2. Press the car's one-button start button.

3. The instrument lights up, and the power supply of the whole car is turned on.

4. Inflate the four tires of the vehicle to the standard air pressure.

5. Press the elimination button of the vehicle's tire pressure warning light for 3 seconds.