How to remove stubborn yellow stains from the induction cooktop panel

Which is formed by frequent water stains! It's hard to get!! Try it with toothpaste!!

Induction cookers, like other electrical appliances, should pay attention to waterproof and moisture-proof and avoid contact with harmful liquids during use. Do not put the induction cooker in water for cleaning and rinse directly with water, nor can you use solvent or gasoline to clean the stove surface or furnace body. Also, do not use a metal brush, abrasive cloth or other hard tools to wipe the oil stains and dirt on the stove surface.

To remove dirt, wipe off with a soft cloth dampened with water. If it is oily, you can use a soft cloth dipped in a little low-concentration laundry detergent water to wipe it. Do not wipe the stove surface with cold water immediately after using it or just after use.

In order to avoid oil staining the stove surface or furnace body, and reduce the workload of cleaning the induction cooker, when using the induction cooker, you can put a piece of paper such as waste newspaper on the stove surface that is slightly larger than the stove surface, so as to absorb the water, oil and other dirt that jumps in the pot and spills, and the paper can be thrown away after use.

With dish soap + steel wool! Just rub it hard!

Kung fu doesn't pay the heart, that's how it works!

There is no better way!

When cooking, the water and soup that accidentally splashed on the panel when it was hot formed dirt and were difficult to clean, so I tried to scrape with a knife, but the efficiency was low and it could not be cleaned thoroughly, is there any better way? The following is the panel I have compiled for you on how to clean the induction cooker, welcome to refer to it

1. The induction cooker panel is dirty, which will affect the overall appearance of the induction cooker, so the cleaning of the induction cooker panel is also very important.

2. The induction cooker panel can be effectively wiped with a soft wet rag, but the rag must be squeezed dry, and household appliances are very afraid of moisture.

3. If the above'If the oil stain is more severe, you can wash it with a toothbrush dipped in some toothpaste, and then wipe it off with some dry towels.

4. However, it should be noted that we should not wipe the panel of the induction cooker with steel wool balls, which will cause damage to the panel of the induction cooker.

Use detergent to scrub, we can clean it with a sponge or rag, if it doesn't work, you can use toothpaste to clean, wipe with a soft damp rag until there are no traces.

If there is no way to remove the scorch marks on the toothpaste, we can try to use dish soap with vinegar to clean up, because vinegar also has a strong decontamination ability.

Note: Disconnect the power supply of the induction cooker before wiping.

What are the precautions for cleaning the induction cooker?

1. Before cleaning the induction cooker, disconnect its power supply, and wait until the induction cooker is completely cooled before cleaning.

The scorched induction cooker must be scrubbed inside and out, and attention should be paid to the collapse fan and vent inside, which can ensure smooth ventilation of the induction cooker.

2. If a lot of money and dust fall from the vent of the induction cooker, we can clean it with a soft toothbrush or cotton swab, and it is forbidden to use water to rinse. When wiping the surface of the heating plate, it is best to wait until the panel has cooled down before scrubbing it with cold water, otherwise if it is too hot just after use, it will cause the hot and cold to collide and the panel to crack.

3. Don't put newspapers and other items on the induction cooker, which will cause the induction cooker to burn out, and in serious cases, it will cause disasters.

Here's how to remove dirt from your induction cooker:

In the case of a power outage with a difference of several trillions, you can use a rag dipped in dish soap and scrub the induction cooker from the middle to the four sides. Be careful not to get water into the cooker, the cloth should be soft and not allow water to flow into the notches around the cooker. You can also put a few drops of detergent on the cleaning ball, taking care to clean it only with a small amount of water.

In addition, it is necessary to clean the ventilation holes on the underside of foreign objects and oil stains, which can be treated with a low-concentration laundry detergent solution. Stubborn stains can be sprayed with a kitchen stain remover, gently wiped with a wire wipe and then dried with a rag.

When cleaning, you can first put a few drops of detergent on the ball, note that you can only wash it with a little water. Secondly, it is necessary to clean the bottom ventilation holes of foreign objects and oil stains, which can be treated with a low-concentration laundry detergent solution.

If the above methods do not completely remove the dirt, it is recommended to seek professional help.

1.First, unplug the power cord from the socket and allow the flat tray on the stovetop to cool.

2.Use a soft rag, do not get wet first, and do a rough cleaning of the surface of the spine induction cooker, so that there are no vegetables, food, obvious oil stains, etc. on the surface.

3.Clean the air inlet and outlet of the induction cooker, which generally gathers more oil and dust than the induction cooker. Gently wipe off any dirt from the surface with a rag, then use a brush to dip a mild detergent and clean at the vent.

4.Use a evenly smeared rag to carefully wash and clean the surface of the induction cooker, and if it is difficult to clean, you can use a brush to gently scrub the cherry blossoms until the oil stains are removed.

The dirt on the induction cooker can be dipped in detergent with an iron sand ball. After brushing to scrape off the oil, you can wipe it clean with a damp cloth. Be sure to unplug the power supply when brushing. Returnees.

1. Before cleaning, please unplug the power cord from the socket and clean it after the flat plate of the stove surface cools. If it is a ceramic plane: when the flat dish is dirty, please wipe it with a damp rag, or you can wipe it with a stain remover powder or gloss powder, and then wipe it with a damp rag.

2. If it is the body and control panel: wipe with a soft wet rag, and wipe the oil stain that is not easy to wipe with a neutral cleaning ruler sail agent, and then wipe it with a soft wet rag until no residue remains.

3. If it is a suction tomb and hail loss on the surface of the exhaust hole: you can use a cotton swab to remove the dust, such as oil stains, you can use a toothbrush and a little detergent that does not damage the utensils to remove it carefully. In addition, you can also use toothpaste, but some of the above cleaning can only make the blackened area lighter, and cannot completely remove the black dirt.