CS1 6 jump acceleration problem, how to cancel CS1 5 acceleration

The difficulty of lj is the synchronization of the mouse and the keyboard There is nothing else to say, basically everyone is practiced all day long.

It is recommended that you start with a small number of acceleration times, and gradually increase the synchronization rate and then increase the number of times, so that the practice foundation is stable.

Jumping more diagrams, especially continuous jump diagrams, will be of great help to the coordination of the two hands.

The requirements upstairs are a bit low Three times stable green You can directly connect five times Five times you have to ask for 250+ As for six times, you can become popular The first time it is very important to accelerate It is also necessary to cooperate with the ground speed At least you have to run 273+ It is not a large amplitude It is mainly synchronous Some people have a large amplitude The synchronization rate is high The number of units added is the same as many Some units are also a lot 50+ Airspeed 320+ Even 250 is not out Red is more difficult It is more difficult to experience it slowly for yourself The first time must be added.

It is recommended to start with 2 accelerations and practice 2 accelerations to 230-235 to pass (I can do it up to 2 times 243).

This will allow you to practice your ground speed and amplitude

When you can pass, do 3 or 4 more speedups (because some people can use 3 but not 4 and some people can use 4 but not 3).

3 or 4 times must reach 237

You must get 242+ 5 times to pass.

You don't need to accelerate left and right with too much or too little, it's basically 30 degrees.

1.If it's an XP system. In the Control Panel, put the mouse in Properties"Improve mouse precision"Closed. That's it.

2. In the properties of the shortcut of cs,-noforcemaccel -noforcemparms -noforcemspd

Add the above ** after the target. There's a space at the front. The effect is obvious. As shown in Figure 10.

Let's talk about the meaning of those parameters:

noforcemaccel??Revert to the desktop mouse acceleration setting. In many cases (when entering a game and requiring sufficient precision), the acceleration of the mouse is fluctuating.

This parameter will make it impossible for half-life to try or control mouse speed when you turn off mouse acceleration on Windows.

When should I use it? Used when the mouse acceleration is off under the desktop, and you want the acceleration to be off in your game as well.

noforcemparms??Revert to the mouse button settings under the desktop. What does this mean?

Normally, when you enter Half-Life (and this also applies to Counter-Strike), your mouse configuration will switch to application mode, allowing the call key to be adjusted to desktop mode (e.g. mouse3). This variable will turn off some special effects. This mode is really detrimental to operation, and there are some strange errors at times.

When should I use it? When you're annoyed by the key assignment. Some actions that are prone to errors should be avoided anyway, regardless of how popular these key settings are.

noforcemspd??Use the desktop mouse speed settings. noforcemspd will force half-life to use the same mouse speed as your desktop.

However, no matter how you set it up, Half-Life will still be based on the mouse speed in the game.

When should I use it? Use when you want to lock the mouse speed under Windows and the speed in the game. The effect is that the mouse speed will be increased (or reduced).