Where should I start to turn a corner?

First of all, the posture of holding the steering wheel should be held with both hands in the position of "9 o'clock 1 quarter", when turning the steering wheel, the two hands do not let go, you can turn 180 degrees to both sides, such a steering amplitude, in most cases, is enough.

How to learn to play the steering wheel and the correct posture:

1. Keep your body upright and actively turn, leaning on the back of the chair to backlight. At this point, the seat height can be adjusted back and forth to the correct state.

2. Look straight ahead, hold the steering wheel on the left side, hold the right hand above the steering wheel and relax the hands and hang down naturally, at this time, the thumbs of the left hand and the right hand should naturally be directly facing the upper part of the steering wheel, and the remaining four fingers should be held lightly from the outside to the inside.

3. The movements in the hands should be balanced with each other to avoid unnecessary shaking. If the steering wheel is affected by the uneven road surface, and the front wheel deflection impact vibration, the steering wheel should be tightly gripped, so that the vibration of the steering wheel of the vehicle rotates violently when the injured finger or wrist, when the left front (right) deviation, should be corrected to the right (left) direction, run back to the front line when you run back, and then gradually return the steering wheel to the right, then the correction should be directly deducted during the correction direction rarely come back to play, easy to make a lot of people staring at the problem in front of them, again before the obvious skew correction direction, at this time most of the late.

When you drive a right turn, you hit the steering wheel to the right. Hit the steering wheel in a clockwise direction.

What you need to pay attention to when cornering is:

1. The speed must be slow when the car turns, do not play the steering wheel too fast, so as not to cause the phenomenon of side skidding, if the car is sliding, you should immediately send the accelerator pedal, and then hit the steering wheel to the side of the rear wheel side slip, and then wait for the car to return to normal, and continue to drive in the right direction.

2. Avoid using the brake pedal when the car is turning, especially emergency braking.

3. When turning, the steering wheel should be controlled to echo the curve, and it should also match the speed of the vehicle, so that the angle of the turn should be appropriate. Do not take your hands off the steering wheel to avoid deviation and danger.

Precautions for turning:

When the car turns, the speed should be slow, and the steering wheel should not be too fast, so as not to cause the car to slide due to excessive centrifugal force. If the car skids, immediately relax the accelerator pedal, turn the steering wheel to the side of the rear wheel skidding, and return to the steering wheel to continue driving after the vehicle returns to the straight driving direction.

When the car turns, try to avoid using the brakes, especially emergency braking, to prevent sideslipping or accidents.

When the car turns, the steering wheel should be adapted to the curvature of the road and the driving speed, so that the steering angle is appropriate, the steering timing is appropriate, and the direction of rotation is timely. It is strictly forbidden to take your hands off the steering wheel to prevent danger caused by deviation from direction.

The direction of the turn is as follows:When the left turn road is narrow, the right corner of the front of the car is tangent to the side of the road; If the left turn is wide, you can hit it a little earlier. When the right turn road is narrow, the left corner of the front of the car is tangent to the side of the road; When the right turn road is wide, you can hit it a little earlier.

Or just look at the corner of the car biting the sideline, that is, drive all the way, the front of the car is biting the curb line, that is, when your car can't bite you have to start playing the direction, a word "bite".

Turn Signal Introduction:Turn signals are important indicators that turn on when a motor vehicle is turning to alert the attention of vehicles and pedestrians in front and behind, left and right. The turn signal tube adopts xenon lamp, single-chip microcomputer control circuit, and the left and right rotation strobe works uninterruptedly.

The turn signal uses a flasher to make the light flash. It can be mainly divided into three types: wire blocking type, capacitive type and electronic type.

The above content refers to Encyclopedia - Turn Signals.

The front of the car can be turned around, that is, after 90 degrees, you can return to the steering wheel.

Because the car is designed to understeer, you can make a quarter more turn when you turn right along the right side of the road at a higher speed, and only make a fifth to a sixth more direction when you make a left turn along the left side of the road, so as to compensate for the understeer.

Motor vehicles are not allowed to make a U-turn at a location where there are signs or markings prohibiting U-turns or left-turn markings, as well as at railway crossings, pedestrian crossings, bridges, sharp bends, steep slopes, tunnels or dangerous road sections.

The first step of the U-turn step, turn around in front of the left, be sure to hit the left direction light first, step on the clutch, step on the brake, reduce the speed to below 20 yards, immediately release the brake, hang gear, reduce to 2nd gear, loosen the clutch in the second step, observe the left U-turn object over the shoulder, immediately turn to the left to turn the steering wheel (the steering wheel is one and a half circles), the head must be observed to the right, and then slowly hit back to the steering wheel, how many times to hit. After turning back, turn off the turn signal.

When the vehicle returns to a straight line, it must return to the steering wheel. Don't be rigid when driving, don't always think about what the coach said: "one and a half circles to the left, two circles to the right", that is only useful when taking subject 2, and throwing away subject 2 after taking subject 2.

The key is to practice more, feel more, and be proficient.

If the U-turn is full of wheels and the speed is high, observe that the front of the car is about to drive in a straight line, and the steering wheel should be corrected in advance, otherwise it is easy to overturn and there is a danger.

The location where you start to turn a corner depends on the vehicle and driving habits.

1. Basic principles

Before this question is asked, some basic principles need to be clarified. First and foremost, safety is the primary consideration to ensure stability and control during driving. Secondly, according to the driving habits, use the appropriate speed and angle to steer to make the turning process smooth and smooth.

2. Play the direction in advance

In general, it is reasonable to start the direction well in advance of the approaching corner. This gives the vehicle enough time and space to adjust the steering and reduces the risk of sharp turns. The exact amount of lead can be adjusted based on factors such as road conditions, vehicle speed, and turning angle.

3. Follow the recommendations of the driver's manual

We can get more specific guidance based on the driver's manual for the specific vehicle or the recommendations of the driving school. Steering performance and steering mechanisms may vary from vehicle to vehicle, so the driver's manual provides vehicle-specific driving tips and recommendations. Following these guidelines can help us better grasp the timing and method of turning.

4. The speed and angle of the excavation

In addition to hitting the direction in advance, proper revs and corners are also the key to a smooth turn. The rpm speed should match the radius of the turn and the speed of the vehicle, too high or too low can affect the stability of the vehicle. Corners should be moderate, too large a corner may cause the vehicle to lose control or roll over, and a corner that is too small may not complete the turn.

5. Practice paranuclear and experience

Mastering the right position also needs to be cultivated through practice and experience. Everyone gradually develops their own sensations and skills during driving. With the accumulation of actual driving, we can better judge and control the timing and strength of the steering.

The position where the turn starts to hit the direction depends on the vehicle and driving habits. In general, it is reasonable to start the direction well in advance and follow the recommendations of the driver's manual.

At the same time, the speed and angle of the turn are also important factors to ensure a smooth turn. Through the accumulation of practice and experience, we can better grasp the timing and method of steering to ensure the safety and stability of driving. In actual driving, it can be flexibly adjusted according to road conditions and specific conditions to achieve safe, smooth and accurate cornering.

There are two ways to look at the highlights, one is to look at the front of the car, and when the front of the car is about to reach the opposite sideline, immediately fill the direction in the direction of the turn. The other is to look at the corner position, when you feel that your driver's position or rearview mirror position is about to be equal to the corner, immediately fill up in the direction of the turn.

Pay attention to the strength of turning the steering wheel, don't be too anxious to hit, it is best to turn the steering wheel just to the limit position when the right rear wheel is level with the inner corner. When the body turns at a right angle, it feels like the car is almost right, and then it returns to the steering wheel. You can also look in the rearview mirror, and when the rear wheel crosses the corner, it will properly return to the steering wheel so that the body is parallel to the edge of the lane and drive out of the right-angle corner.

The right-angle turn is a subject 2 item in the driving test, which requires students to correctly control the steering, accurately judge the difference between the inner and outer wheels of the vehicle, and successfully pass the right-angle corner, mainly to test the students' ability to control the vehicle. First, stop the vehicle at the initial position of the right-angle turn, and then move slowly, if it is a right-angle left turn, then the body should lean to the right; If you make a right-right turn, lean to the left.

Photo by Q&A) Xpeng P7 Model Y AION V Ideal One NIO EC6 Model X 2019