How to fold a turtle with paper, how to fold a turtle with paper

The steps to fold a turtle with paper are as follows:

1. Take a square piece of paper and fold the diagonal of the square diagonally.

2. Fold one corner up, open, press it inward according to the crease, then flip the paper, fold the other corner up, and open.

3. Fold inward according to the creases, (forming a double square) fold both sides of a corner inward and open. Press the left and right sides inward according to the creases.

4. Fold the lower corner upwards again. Flip the paper over. Fold both sides of the other corner inward and open it.

5. Fold the left and right sides inward according to the creases. Fold the top corner down again. Cut along the line. Note that the two corners are cut apart, and the remaining corner is not cut.

6. Fold the two corners of the cut left and right, and fold the lower corners up. Then fold the other two corners outward. Fold the top corner down.

7. Twist the head and fold the tip of the triangle inward at the same time. Flip the paper over. Fold the sharp corners of one side inward. Fold the sharp corner of the other side inward. The tail is twisted and done.

1. If you have one, put the white side up.

2. Fold the paper diagonally to get a pyramidal structure.

3. Fold the lower right corner to the middle point, aligning with the top corner.

4. Fold the lower left corner as it is.

5. Fold the top corner of the right flap down to the bottom.

6. Fold down the left flap as well.

7. Fold the right corner of the bottom to the right.

8. Repeat on the left side.

9. Take a pair of scissors and cut the upper layer of the bottom corner in half from the bottom to the center.

11. Fold them so that they look like the top.

12. Fold the left and right corners inwards respectively.

13. Fold down vertices.

14. Fold the folded piece upwards again, leaving a little gap.

15. Turn the turtle over and you can fold it in half to get a three-dimensional look. You can even draw your eyes with a marker!

Here's how to fold a turtle with paper:

1. Prepare a square of colored paper, fold it in half once along the middle line, and align both sides. Then fold the rectangular origami in half on both sides towards the open edge, with one side folded forward and one side folded backwards. Then the folded triangular origami, stretched out from the bottom opening, and then compacted down into a square origami.

2. Then fold the front and back sides to the midline, the crease is the green dotted line fold, the top is folded downward, and finally the part of this step is used as an auxiliary line. Then prop up the inside and fold inward along the auxiliary line of the previous step to form a double triangle. Then cut the middle part to the green dotted line, and fold it along the green dotted line to fold out the two legs of the turtle.

This step then folds the head along the forward and reverse lines, respectively.

3. Then turn the origami paper over, and you can see the basic round outline of the turtle. Finally, draw the turtle's eyes, and fold the tail backwards and then forwards to fold the tail, and then fold the turtle out of paper.

Origami is an artistic activity in which paper is folded into various shapes. Origami is not limited to the use of paper. Origami enthusiasts around the world use a wide variety of materials such as: tin foil, napkins, acetate flakes, etc., while adhering to folding specifications.

The combination of origami and natural science not only became a teaching aid for the School of Architecture, but also developed origami geometry as a branch of modern geometry. Origami is both a toy and a mental activity; It is a symbol of peace and remembrance, as well as a form of pastime.

Method. 1 8 quasi or shout cavity prepare a square of colored paper.

2 8 First fold the square colored paper out of the crease of the word "rice".

3 8 Fold one of the corners to the center point along the crease, then turn it over, fold the remaining three corners towards the center point, and then aggregate the colored paper along the crease to form a triangle.

4 8 Fold the lower corners upwards to create creases, and then fold upwards again, and the creases and edges coincide.

5 8 Pull the right figure out of it, then press it downward, and fold the left side in the same way.

6 8 Fold the two sides of the figure in half, and then fold the two sides outward.

7 8 Turn it over and fold the corners of both sides inwards a little bit.

8 8 Fold the corners of both sides inward, and then fold inward along the middle of the fold to make the turtle more three-dimensional.

1 Fold out two diagonal lines of square paper, and fold two middle lines in the opposite direction, and the crease is in the shape of "m".

2. Fold according to the crease, take the corner of the paper opening as the fixed point, fold the paper edges on both sides inward, leave the creases and then open, fold the two sides inward according to the creases, and operate the same on the other side, and finally obtain a basic type of paper crane.

3. Cut the top layer of paper along the middle line, and the highest point should not exceed the intersection of the two diagonals of the plane. Then fold the two corners of the cut diagonally upward, and then fold the two corners of the paper layer below from the inside to the outside of the dress, and the angle is the same as the two corners of the upper cross. Both sides of the reed stove should always be symmetrical.

4 Fold the corners of the shorter end inward, leaving some distance before folding outward.

5 Fold the corner of the longer end inward as well, leave a distance and fold it outwards to keep a longer distance than the previous one.

6. Change the angle up and down for easy operation. Fold the two sides of the twisted paper corner to connect the two dots as shown in the figure, and fold the extra paper upwards onto the paper corner. Then fold the tip of the corner of the paper inward, turn it over, draw the eyes, and the little turtle will be folded.

1. Prepare a square of colored paper, fold it in half once along the middle line, and align both sides.

2. Fold the rectangular origami in half on both sides towards the open edge, fold one side forward, and fold one side backwards.

3. Folded triangular origami, stretch it out from the bottom opening, and then press it down into a square origami.

4. Fold the front and back sides in half to the midline, and fold the top downward, and then get the crease as an auxiliary line.

5. Prop up the inside, fold it inward along the auxiliary line of the previous step, and fold it out to form a double triangle.

6. Cut the middle part to the green dotted line, fold it along the green dotted line, and fold out the two legs of the turtle.

7. The middle layer of origami is folded backwards along the dotted line to fold out the front legs.

8. Fold the head along the forward and reverse lines.

9. Turn the origami over to see the basic outline of the turtle.

10. Draw the eyes of the turtle, fold the tail backwards first and then fold the tail forward, and fold the turtle out with paper.

The steps of the paper folding turtle before the empty forest are as follows:Material preparation: a square piece of paper.

1. Fold the colored paper diagonally.

2. Then fold into a triangle.

3. Fold one side over.

4. Slowly fold out the horns of the turtle, turn over the other side and repeat steps 3 and 4.

5. Then slowly stretch it out.

6. A paper turtle completes the Hui mu.

1. Material preparation: a square piece of paper.

1. Fold the colored paper diagonally.

2. Then fold it into a three-branch beard horn shape.

3. Fold one side over.

4. Slowly fold out the horns of the turtle, turn over the other side and repeat steps 3 and 4.

5. Then slowly stretch it out.

6. A paper turtle is done.

2. Tools: a square of paper, a pair of scissors, and a pen.

1. Fold the square colored paper into the rice crease.

2. Fold the rice crease into a double-layer square.

3. Fold the two sides on both sides of the opening parallel to the middle line to make creases, compact, and then open.

4. Fold the edges of both sides inward along the crease in the picture above.

5. Cut the cutting line in the above picture with scissors, pay attention to only cut one layer, and divide the two triangles, one of which is folded in half to the left front, and everyone should pay attention to the position of the triangle crease.

6. The other side is folded in half to the right front in the same position, forming the effect shown in the picture above, these 2 triangles are the hind limbs of the turtle.

7. The two triangular areas in the middle of the origami are folded along the solid line creases drawn in Figure 6, and the two small triangles folded here are the forelimbs of the turtle.

8. Fold the head and tail according to the solid line dotted line crease drawn in the figure above, the dotted line valley fold, and the solid line mountain fold.

9. Pay attention to the corner pointed with a pencil in the above picture, open this corner and fold it downward, this step is to make the line of the turtle's head and neck, the folding method of the two corners is the same.

10. Fold the sharp corners and valleys, and the head will be folded.

11. Finally, use a pen to draw a pattern on the turtle shell, eyes, etc., and it's OK.