What is going on with the aluminum alloy window inner side seal strip missing one end at both ends

Rubbing the glass with onions is brighter! Place the onion in half and use the cut surface to wipe the surface of the glass. While the scallion juice is still dry, quickly wipe it with a dry cloth, and the glass will be very bright, so try it quickly!

Wipe the glass with a clean chalkboard that is both clean and bright and quick and labor-saving.

Small mirrors or cabinet mirrors have dirt, you can use a soft cloth soaked in kerosene or dipped in wax to wipe, do not wipe with water, wipe with water, not only the mirror surface is blurred, and easy to corrode the glass.

The glass is full of water vapor, which brings many inconveniences to traffic, work and life, such as wiping the glass with a soft cloth dipped in dry soap, 90% alcohol or shampoo.

When painting, if you stain the door and window glass, you can use cotton dipped in some turpentine to moisten the paint spots, and then scrape it with a knife after it softens to restore the original luster.

Ink stains: Wipe clean with turpentine. Grease stains:

Stir and wipe with acetic acid and degreasing detergent and water. Tape smudges: Scrape the tape with a knife and then wipe with turpentine.

Pencil smudges: Can be wiped off with turpentine. Crayon smudge:

It can be wiped off with a dry cloth dipped in turpentine. Colored pencil smudges: Carefully wipe with an eraser first.

If you can't wipe it off, you can scrub it with laundry detergent.

Wipe the glass with a towel dipped in beer or warm vinegar to quickly remove dirt from the glass.

Apply some chalk ash or gypsum powder to the glass first, and wipe it with a cloth after drying.

Fill the basin with some water, pour a little shampoo and mix it, and use it to wipe the glass, it will look extra clean and bright.

In winter, the surface of the glass is easy to frost, and it can be wiped with a cloth dipped in concentrated salt water or liquor, and the effect is very good.

The dirt on the glass can be wiped clean and bright with a cloth or silk dipped in toothpaste.

Take two pieces of cloth, one dry and one wet, and wipe both sides of the glass with a damp cloth first; Then use a dry cloth dipped in a small amount of liquor and wipe the glass vigorously to make it clean and bright.

Eliminate factory defects that is, the aging of the vinyl strip can be bought to replace it by yourself, and in winter, you can buy a foam sealing strip to partially fill it in the warm weather and then replace it.

Go to a hardware store or online, buy 2 pieces, and put them on OK. Very simple.

Hello, the rubber sealing strip can not be pulled too tightly on the side, and the blanking length is 2o-3omm longer than the assembly length. When installing, it should be inlaid in place, the surface should be straight, and it should be in close contact with the glass and the glass notch, so that the force around the glass should be uniform. The rubber strip should be disconnected on an inclined plane at the corner slag, and the glue should be quietly injected at the disconnection place to bond firmly.

When fixing the glass with sealant caulking, the glass should be squeezed with rubber strips or rubber blocks first, leaving a gap for glue injection, and the glue injection depth should not be less than 5mm, and the glass should be kept from vibration before the glue cures.