Where to add Buick Kaiyue 1 6 manual transmission oil?

The Buick Excelle manual transmission oil filling port is located at the position of the half shaft of the right gearbox, that is, the screw marked No. 14 can be loosened to fill the transmission oil.

The transmission oil in the manual transmission of Buick Kaiyue cars needs to be replaced regularly, because the transmission is dependent on the transmission oil to dissipate heat, lubrication and fluid transmission, if the manual transmission oil of Buick Kaiyue car is used for too long, it will definitely make the performance of the transmission greatly reduced, and when the transmission oil is seriously dirty, it will also lead to a series of failure problems in the transmission.

If the quality of the transmission oil does not meet the conditions required for the transmission, it will cause the automobile transmission to be continuously heated as it runs. Until the high temperature affects the continuous aging of the rubber material of the car, a large degree of wear and tear occurs, etc., which will affect the normal driving of the car.

The gearbox oil of this car is in the middle, which can be seen with a refueling screw. Loosen the screws and refuel directly, and add oil to the side trees when there is a flow out.

There is a 13 screw next to the inner cage on the right side of the gearbox!

Hello! For the Buick Excelle model, the manual transmission oil has a special filling port on the side of the gearbox, which needs to be filled with a special gear oil dispenser.

Add from the exhaust hole, or from the reverse switch.

1. Open the door on this side of the cab.

2. Pull the hood switch on the left side of the driver's leg.

3. Lift the hood of the engine upwards.

Fourth, use the support rod to support the hood to ensure that the support is firm and avoid danger.

Fifth, the position in the picture is this filler.

Precautions for operation:

1. Do not add excessive transmission oil to avoid overflow.

2. The added transmission oil should use the same specification.

The most ** model of Kaiyue manual transmission oil manufacturers is required to be inspected and replaced every 80,000 kilometers. Some older models require the transmission oil level and working condition to be checked every 5 years or 100,000 kilometers, and if it is abnormal, it needs to be replaced.

Manual transmission is a pure mechanical structure, in a long time of operation will produce a certain amount of debris, if you do not change the oil for a long time, there are more and more debris inside, it will accelerate the wear of the gearbox, and it is easy to have gear beating, out of gear, jumping, abnormal noise and other failures in the later stage.

Transmission oil for the gearbox has the role of cleaning, lubrication, heat dissipation and sealing, the transmission oil quality has a certain shelf life, the performance of the oil will decline, produce more impurities, and then lead to the accelerated wear of the gearbox parts, the failure time is advanced or the failure rate is high. Depending on the situation of the car, it is necessary to change the transmission oil in order to maintain the good performance of the car.

Hello, I'm a master with decades of experience! I've seen your problem! I'll get back to you within five minutes, and if you're satisfied, can you give me a thumbs up? Thank you!

Manual transmission oil is generally replaced once every 2 years or 6w kilometers: 1. Generally speaking, the calculation method of the replacement cycle of the transmission oil and the maintenance cycle of the vehicle is based on the mileage or use time. 2. If the transmission oil is not replaced for a long time, the transmission oil will deteriorate due to the long-term use of the transmission oil, and the lubrication effect will be reduced; 3. If the lubrication effect is not good, the wear of the gears in the gearbox will increase, which will shorten the service life of the transmission, and may also cause serious damage to the gear teeth in the gearbox.

Questions. How to change Chevrolet Cruze gear oil.

1. Cruze does not have oil drain screws, and the oil pan needs to be removed for oil change, and a liner needs to be replaced. 2. The position of the oil screw on the gearbox near the right half shaft, the screw has glue, and there is a fuel filler port when refueling, and it is good to know that it overflows, basically in 2L, not more than 2L.

The specific operation steps for changing the 13 SAIC-GM Buick Kaiyue automatic transmission oil are as follows:

1. Unscrew the oil drain nut of the bottom shell of the SAIC-GM Buick Kaiyue gearbox.

2. Use a basin to catch the transmission oil released by SAIC-GM Buick Kaiyue, and remember to tighten the oil drain nut of the gearbox bottom shell after it is cleaned.

3. Open the door of the cab side of the SAIC-GM Buick Excelle.

4. Pull the hood switch on the left side of the driver's leg of the SAIC-GM Buick Excelle.

Fifth, lift the hood of the engine of SAIC-GM Buick Excelle.

6. Use the support rod to support the engine hood of SAIC-GM Buick Kaiyue, and ensure that the support is firm to avoid danger during operation.

7. Unscrew the transmission oil cap of SAIC-GM Buick Kaiyue gearbox and add transmission oil.

8. The oil level of SAIC-GM Buick Kaiyue gearbox can be in the middle of the upper scale line and the lower scale line.

Summary. Buick Kaiyue automatic transmission, what oil is used for transmission oil, if you choose the best Buick Kaiyue car is equipped with a CVT gearbox, when replacing the transmission oil, you must use a special transmission oil, if you choose the old model, the configuration is a 6AT gearbox, and the transmission oil is replaced in the 4S shop, that is, about 600 yuan.

Buick Kaiyue automatic transmission, what oil is used for transmission oil If you choose the best Buick Kaiyue car is equipped with CVT gearbox, when changing the transmission oil in a worse way, you have to use a special transmission oil, if you choose the old model, the configuration is a 6at gearbox, and the gearbox imitation oil is replaced in the 4S shop, that is, about 600 yuan.

The transmission oil of this car can be used in Mobil, Chevron and other brands, and the quality is relatively reliable and stable, and the effect is also relatively good. 2. When replacing the transmission oil in the later stage of the Buick Kaiyue automatic transmission model, it is recommended that it is best to go to the Youfan 4S shop to replace the original transmission oil, after all, the quality is better, and the effect is clearer and better for the gearbox.

Original ACDELCO red gearbox oil can be used. Xingzhi tank oil is the oil that keeps the gear system clean, which plays a role in lubricating and prolonging the service life of the transmission. Low-temperature resistant car belt beam, which can be effectively lubricated at low temperature and reduce oil loss under harsh working conditions.

Basically, transmission fluid can be applied to automatic transmissions in the market. Each automatic transmission has different technical requirements in terms of design. Even if the same model of transmission is arranged in different models, their torque, weight, speed and construction will be different, so the original factory has its own dedicated transmission oil.

1. Hezheng Buick Kaiyue gearbox should be added, and it is best to look at the use and maintenance instructions again.

2. Observe the amount of oil by checking the oil holes, as well as the turbidity and brightness of the oil color.

3. Generally speaking, 4 60,000 kilometers are replaced, and there is no need to replace them according to the suggestions given by the manufacturer, because the gearbox is a sealed working environment.

4. It is only necessary to check whether it is an oil leakage defect regularly, and if there is a need, it does not need to be replaced. However, in actual use, there will be wear between the gears, and all the iron foam worn out is at the bottom of the gearbox, which will aggravate the wear of the gears and the wear of the gearbox.

5. For the overhaul need to dismantle the oil pan, a little troublesome, put down the oil black and black, but also with iron foam, in short, you remember that there is no car that does not need to change the oil, including the dry double clutch of the Da La, in addition to the oil tanker Xiao recommends using AC Derk's automatic transmission oil, which is relatively thin and good to hang the gear.

Like the old Kaiyue, the transmission oil of this model needs to be frank, and about three liters are enough. This transmission oil is also relatively simple when adding, as long as the oil is cleaned, refueling from the side of the oil filler, as long as there is overflow from the oil filler when refueling, it means that your oil is bright enough. Completely clean the oil, and then add a new transmission oil to Zheng Sansheng is enough, normal like this transmission oil needs to be replaced every two years or 40,000 kilometers, if not replaced for a long time, it will lead to abnormal wear and tear inside the gearbox.

Frame the car first, and then find a large utensil to pad under the car for waste oil. Use a suitable screwdriver to remove the gearbox and housing, at this time there will be some gearbox oil outflow, pay attention to dodge.

After a few minutes, when some of the oil is almost dry, remove the last oil tank, taking care to hold it carefully with your hands, there is still a large amount of waste oil here. When you take it off, you will see that there is a lot of stain left on the bottom of the sump.

Carefully remove the transmission oil filter, and you will be able to clearly see the solenoid valve used to control the gear changeover.

Remove the oil bottom gasket to remove the surrounding stains, or use a tool if the gap is not clean. Due to the long time, the rubber on the oil gasket sticks to the edge of the machine and is not easy to clean, and a small scraper is needed to remove it, and at the same time spray some carburetor cleaner, which will save some effort, and the cleaning will be more thorough, wipe all the cleaned transmission oil filter devices with cotton silk, and then install them one by one. Remind everyone that the filter is generally used once, and when the oil is changed, the new filter and oil gasket should be replaced.

Wipe the surface of the replacement parts clean, and there should be no water and oil stains, otherwise it is easy to cause oil leakage; Install a clean oil sink and oil gasket together, and be sure to fit it tightly to avoid oil leakage. Clean and wipe the oil filter casing, install the cleaned casing, secure the two diagonal corners first, and then tighten them all.

There are gravity method and circulation machine method for transmission oil change, and the traditional gravity replacement automatic transmission oil can only replace about half of the waste oil, and the method is to remove the oil drain screw, because the gravity transmission oil will automatically flow out, and then fill the transmission oil at the oil filler. The second is the oil change of the circulating machine, this method realizes the full intelligent equal amount of oil change, and the transmission oil is replaced in the state of the car start, at this time the oil flows inside, which can take away the dirt in the gearbox, and the oil change rate can reach more than 90%.

Manual oil change method for transmission oil:

1. Start the engine to preheat the transmission to reach the working temperature.

2. Disassemble the oil bolts.

3. Put the old oil back into the bolts after putting it away.

4. Add a new ATF solution.

5. Start and P gear to N, D, L1, L2 and other back and forth operation gears, and stay in each gear for at least 5 seconds.

6. Check whether the fluid level of the automatic transmission is normal.

ATF switch oil change method:

1. Disassemble one of the cooling oil pipes of the automatic transmission.

2. Connect the inlet and outlet oil pipes and high-pressure gas pipes of the ATF switch in the correct way.

3. Fill the switch with enough new ATF fluid.

4. Start the engine and idle it.

5. Turn on the switch adjustment knob to make the new oil flow into the automatic gearbox and the old oil into the waste oil drum.

6. Observe the cleanliness of the oil in the oil inlet pipe of the switch, and stop changing the oil after it is relatively clear.