Sweater oblique shoulder knitting method, raglan shoulder sweater knitting method and steps

Usually see other people knit the slanted shoulder feels pretty good, when it is their turn to weave how not to look tight, weaving dismantling, dismantling the weaving, busy for a long time finally figured out, in fact, it is very simple to weave the first 6 needles and the last 6 needles of the needle place to weave a more back and forth. But sometimes you have to be busy for half a day to react. I sent it to tell my sisters who want to knit slanted shoulders like me to avoid detours, and my slanted shoulders of this cardigan are 3 stitches every 2 rows or so.

Knit the first needle of the right oblique shoulder without knitting Knit flat needles, the 7th and 4th needles and 1 needle, the 8th and 5th needles and 1 needle, the 9th and 6th needles and 1 needle These 3 needles are pressed in front of the 3 needles, the 6 needles are knitted back and forth (that is, 2 rows) after the 6 needles are knitted, and the left oblique shoulder is knitted when the remaining 9 needles are knitted, the 9th and 6th needles on the left are 1 needle, (the 9th needle is pressed on the 6th needle and 1 needle) the 8th needle is in front of the 5th needle and 1 needle, The 7th needle is in the front, the 4th needle is in the back and 1 needle, knit the last 3 needles, and then knit 6 needles back and forth (that is, 2 rows) Continue to weave the reverse row, repeat until you want to get the number of needles you want to receive.

The knitting method and steps of a raglan sweater are as follows:

1. Start 160 needles at the bottom and knit with 10 needles. The body is knitted with No. 8 needles, and no needles are added. Still 160 stitch knitting.

2. Knit to the armpits, and begin to weave the front and back pieces, with 8 stitches on each armpit.

3. Start weaving the back piece, and collect two stitches every four rows. Knit until the end of the back piece, the back collar is still empty 18 stitches.

4. Weave the front piece again, and collect two stitches every four rows on both sides and the back piece. When there are still inches from the back collar, the neckline begins to close, and the neckline is empty for 24 stitches. On both sides of the neckline is a stitch every two rows. The shoulders and neckline are knitted at the same time until there is 1 stitch left on each side.

5. Then prepare to weave the collar. The rear collar is 18 stitches, plus the front collar is empty 24 stitches, and the front piece is left with one stitch on each side, a total of 44 stitches. Six stitches were picked out on each side of the front neckline, and now there are 56 stitches in total.

Then put the back piece and the front piece together, and where the front and back pieces are closed, you need to pick out 10 on each side of the shoulder, and the collar has a total of 76 stitches. It's done.

6. Then start knitting the sleeves. When knitting the collar, start with 10 stitches from the shoulder, and then add one stitch back and forth, for a total of 69 stitches for the entire sleeve.

Then close two stitches in every few rows until the cuff reaches 40 stitches.

There are 3 ways to weave the shoulders of sweaters that I know, and I will introduce the one I am most familiar with here.

1 Calculate the width of your shoulders (the width of your shoulders is the width of one side), count how many stitches there are, divide by 2, and that's the number of stitches you want to take.

2 Generally, it is collected once every other row, and the length of these rows is measured according to the number of times it is collected.

3 The length of the cuff (armpit to shoulder), minus the length to be closed, is where the needle begins.

4 specific needle retraction: the beginning of the side of the three needles, normal weaving, from the 4th to 7th needle 4 stitches and 2 stitches, specifically 6 and 4 together, 5 and 7 and this method of stitching is the same as the raglan sleeve knitted from the bottom to the top of the needle) Finally, the remaining three or four stitches are knitted into one stitch

5 The front piece has the same collar as usual, until it is as long as the highest part of the back piece, and then the front and back pieces are closed

There are three ways to weave the shoulders of a sweater, and here's a look at one of them:

First of all, we have to start the needle, start 96 needles, the 96 needles here are calculated like this, 8 needles have four paths, each path has two needles, that is, eight needles; The shoulder is 14 stitches.

To have a single ribbed edge, the height is about one to two centimeters. After weaving, knit another circle of flat needles, and then start the minute hand, remembering that after dividing the number of stitches, add one stitch.

The first line: 1. Use one needle of jersey first and then add one needle.

2. Add one needle after knitting 30 needles, add one needle after knitting two needles, (here 30 needles are the number of needles in the front chest, two needles are the number of needles with oblique diameter, and the sleeve is after two needles).

3. After that, weave 14 needles, add one needle, weave two needles, and add another needle.

4. Add one needle after weaving 30 needles, and add one needle after knitting two needles.

5. After that, weave 14 needles, add one needle, weave one needle, and all the knitting will be completed in one circle. (Here 14 stitches is the number of stitches in the left sleeve, and the knitting stitch is still the oblique stitch number, because one stitch is knitted first in 1, so only one stitch is knitted here).

Repeat this until you have finished a circle on your shoulders.

Second row: All jersey.

The third line: that is, add one needle in front of the diameter and one needle at the back of the diameter, and add a total of eight needles in one circle.

Fourth row: Knitted flat needles.

At this point, the sweater shoulder is done.

The knitting methods and techniques of a slanted shoulder sweater are as follows:First, weaving methods and steps.

1. Prepare wool and wool needles, and use 42 needles for demonstration.

2. Distribute 3 needles and start knitting the collar. Knit one needle on the needle, one needle down. Weave the bucket ruler to the height required by the collar.

3. Divide 14 stitches on the front chest and back, and 7 stitches on both shoulders.

4. Add one needle after the first needle and before the last needle on each needle. To weave a circle, add 8 stitches.

5. Repeat the weaving to the armpits. Then use thread to raise the base of the two sleeves.

6. Connect the front chest and back with 3 needles, and weave the needles without adding or subtracting.

7. Thread the loop of the sleeve on the needle and start knitting the needle to the armpit.

8. The other sleeve can be knitted in the same way.

Second, the weaving skills.

1. 36 stitches in the shoulder, plan to divide it into 6 times, 6 stitches each time. I am going to weave 6 sun, and the shoulder height 5 inches begins to slant. (How many times and how many needles each time should be calculated according to the height of the oblique shoulder, the total number of stitches, and the density of the stitches [1 inch per row]) for the first time to weave to the back of the remaining 6 stitches without weaving, and directly back to knit the left needle.

2. Start picking the needle: if the needle is not picked well, there will be holes, and if you pick the right one, it is the same as the normal weaving. Once it's different, it's definitely the wrong pin. (The skill of finding the stitch in the knitting process, generally see which needle is the loosest in front, and the longest stitch behind Chi Xiang is the needle.) ）

The sweater shoulder oblique shoulder knit is as follows:

1. Prepare the wool and wool needles, take 42 needles for demonstration, and then assign 3 needles to start knitting the collar. Knit a needle on the needle, a needle down, weave the calendar leather to the height required by the collar.

2. Next, start the minute hand, divide the front chest and back into 14 stitches, and each shoulder 7 stitches. In this way, a total of 42 needles are threaded separately with 4 needles, and then the knitting and adding needles begin. Needle method: add one needle after the first needle and before the last needle on each needle, and add 8 needles to knit a circle.

3. Repeat the knitting to the armpits, and then wear the two sleeves with thread, and then knit them later. Connect the front chest and back with 3 needles, weave the needle without adding or subtracting, knit to the required length and then change the knitting needle to the upper needle, and knit the edge of the sweater under the needle until the required length is completed.

4. Finally, start knitting the sleeves, thread the loops of the sleeves on the needle and start knitting the needle, knit it to the armpit, and collect the needle as needed. After the sleeves are knitted, the cuffs are knitted up and down, and the other sleeve is knitted in the same way, so that the sweater is knitted with the slanted shoulders.

The slanted shoulder knitting of the sweater is basically woven from top to bottom, and the oblique shoulder is mainly woven with 4 shoulder stems. This requires us to allocate the number of stitches on the front and back of the chest and back and on both shoulders in advance, so that we can weave beautiful oblique shoulders.

<>2. Connect to the above picture and knit two more needles.

3. In the small swallow, a total of 8 right 7 needles and right 5 needles right 8 needles and right 6 needles, so that 2 needles of small swallows can be formed.

3. The left side is woven from the right side, leave 8 stitches, wait and oblique shoulders.

4. On the left side, use left and 8 and left 6, left 7 and left 5

8. On the left side, knit 2 more needles under the bell on the left 2 and 1 on the left, that is, the collection and dial meter, so that the left side and the right side - have the same 1 small swallow.

9. This is the second small sock swallow, the same as the first one, specifically: the first circle side 2 and 1, 2 needles under the needle, in the 2 needles of the small swallow. The reverse side of the second circle remains unchanged and the upper needle, and the third circle side is 2 liters 1, which is this **.

Everything else remains the same. The fourth loop is knitted with needles on both sides, the fifth loop is repeated to the first to fourth turns, and so on.

10. This is the second circle of the left regret side, there is only the reception needle, with the left 2 and the left 1, and the harvest is 1 needle.

11. This is the appearance of completing a few small swallows, and I have also begun to dig the rear collar nest, divided into 2 parts, starting from the reverse side of the right side first. The last 3 small swallows are the beginning, because it is a 4-needle 4-row group, the average is 1 needle per row, and the remaining 3 small swallows are 12 rows.

12. Take this sweater as an example, the collar is 55 stitches = 28 on the right side + 27 on the left side, and the right side of the collar must be left with 3 stitches on the oblique shoulder, and you will know it when you knit it: 28-3 = 25, the order of receiving the needle is every 2 rows on the right side of the reverse side, 2-10-1, 2-5-1, 2-4-1, 2-3-1, 2-2-1, 2-1-1, this is the right side of the reverse side of the 10 stitches, the first needle is not woven slippery needle.

13. At the same time, the slanted shoulders were also dug into the collar socket, and the last three stitches were left.

14. Merge the 3 needles into 1 needle, the middle needle is on the top, and then lock the buckle to complete the right oblique shoulder and collar, <>

15, the left side of the collar is also in the most 5 small ions is the beginning, a total of 12 rows, the left collar is 27-3 = 24, every 2 lines of the order of the order, 2-9-1, 2-5-17, 2-4-1, 2-3-1, 2-1-1, 2-2-1, the last 3 stitches left, 3 into 1 stitch, the middle needle at the top, in the lock buckle.

16. This is what the finished look like.