Will it be a problem to lay tiles in summer and now that winter is coming soon?

There is no problem with tiles laid in the summer in the winter, because the concrete in the summer can reach the standard strength. Unless you are laying the tiles in the winter, then the phenomenon of falling off will occur in the summer.

We need to know that when the tile is pasted, the material that can be selected is cement mortar, then the cement mortar actually needs to be modulated in advance, so in the process of modulation, we must pay attention to its adjustment ratio, if the adjustment ratio is not good, it may lead to its adhesion is not good, then in this way, then we will paste the tile, there will be a situation where the tile will slide off, or there will be a situation of tile bulging, Then the tile itself is a relatively fragile material, if these situations occur accidentally, it is inevitable that there will be cracking, then cracked, then we need to replace it in time.

When pasting tiles, the previous master will generally lay a thin layer of cement mortar on the ground, the master of this process is called leveling, which is to prevent us from pasting tiles in the later stage, the ground is uneven, and there may be a hollow situation, then there is a hollow situation, and there will be a series of problems with the tiles, so this early leveling work can never be omitted.

When you choose to lay cement mortar, you must pay attention to be sure to wipe it evenly, and then cover the tile on it, after covering it, in order to ensure that the tile can be more tightly bonded with the cement mortar, we need to use a small wooden boat to quietly knock, so that it can be pressed more tightly, and our tiles generally do not have any problems.

Then we are in the tile when we are pasting, we must pay attention to the tile and the tile, try to leave a certain gap, because we later, in the process of using the tile, the cement mortar at the bottom needs to breathe, if it is not possible to carry out a reasonable breathing effect, it is easy to appear bulging phenomenon, which is a very big injury for the tile, in order to avoid this situation, we must ensure that there is a certain gap to breathe. This requires us to pay attention to another point when decorating, that is, to ensure that the distance between these gaps is as much as possible, and there are no gaps that are too large or too small, so that it will look very unaesthetically pleasing.

In fact, you don't have to worry, the reason for this situation is due to thermal expansion and contraction or tile quality, under normal circumstances, as long as the tile is left with a crack will not appear cracking (cold shrinkage) and arching up (heat expansion) phenomenon. Cracking is generally a problem with tiles, and arching is generally due to the fact that the gap is too small.

In general, there will be no problem.

This general situation refers to the decoration workers according to the normal process: the tile is soaked in water for a few hours, the ground or wall is brushed with qualified cement to lay the bricks, and the tiles are gently beaten with a rubber hammer after the bricks are paved to make the tiles fully fit the ground or wall. As long as the decorator does this, there is no problem at all with the tiles laid in the summer to survive the winter.

As long as you are looking for a regular decoration company, workers will follow these procedures when laying bricks. So, there's no need to worry.

Unless the bricks were laid at that time, the bulge fell off. Usually no problem.

As long as it is not a sudden cold and heat, under normal temperatures, as long as the tiles are left with seams, there will be no cracking and arching phenomenon, it will be cold in winter, but the general tiles are no problem as long as they are not dozens of degrees below zero, I use Lesman tiles at home to pave in the summer, and it is okay to use a few degrees below zero in winter.

The main ground pavement materials commonly used in the family are floors and tiles, in terms of the thermal conductivity of the two, the thermal conductivity of the tiles is faster than the floor, if the ground temperature is too low in winter, people stand barefoot on the brick surface, the heat of the human body can be quickly transferred to the ground, as far as the floor and tiles are concerned, the tiles will feel colder. However, if you install heating or underfloor heating in the room, it will not feel cold. Whether it is flooring or tiling, it will be colder during the change of seasons in autumn and winter.

If you want to feel good on your feet, it is recommended to use Chuangrui tile satin glaze, the surface is very comfortable, and it feels great to the touch!

First, the performance ratio: the floor and ceramic tile compared with the wear resistance is not bad, as long as it has passed the national quality supervision and inspection of the floor wear resistance can reach 6000 rpm or higher, especially the popular relief surface of the floor. The wear resistance is better, and it can even reach more than 10,000 revolutions.

Tiles and floors will inevitably be scratched after a long period of time.

2. Comfort: Tiles feel cooler in summer, and there will be a cold feeling in winter, and the warmth of the floor is relatively worse than that of the family. Especially in families with small children or the elderly, the mainstream tiles are vitrified tiles, which are too slippery, the elderly and children are easy to slip, and the floor is not as slippery as tiles; Children generally love to play barefoot on the ground, sit on the ground, the advantage of the floor is more obvious, winter and summer are not cool, especially a group of buddies at home, can not sit, so that the floor can sit on the ground, tiles will not work.

3. Maintenance: The current composite flooring basically does not need special maintenance. Just use the mop to drizzle a little, don't drip water, you can wash it first and hang it for half an hour to control the water before using it.

Compared with the floor and the tile, there is a misunderstanding of many people: the general people think that the tile is not easy to get dirty, and the dirty thing will not seep in, and the floor will seep in and cannot be wiped off. In fact, on the contrary, the surface of the floor is a wear-resistant layer that will never seep water.

And now the vitrified tile, although the merchant showed you when you buy the ink can not seep in, but that is because the surface of the brick is covered with a layer of wax when leaving the factory, if you do not wax after you shop at home, it will definitely penetrate, and I am the most greasy, that is, the tile joint, can never be cleaned, saying that the tile is easy to take care of, the home is dirty, buddies dare to play cigarette ash everywhere. The floor can be changed to these bad things about them.

Fourth, environmental protection: the main pollutant of the floor is formaldehyde, as long as the formaldehyde content of the floor that has passed the national quality supervision and inspection and quarantine is below, several well-known brands have also reached the following, which is lower than the European standard. The main hazard of ceramic tiles is radioactivity, which is not visible and should not be identified.

Fifth, the space problem: the floor only occupies the height, while the tile should occupy at least 3-5cm in height. The floor is simply a layer of mat on top of the original floor to cushion and protect against moisture, while the tiles are covered with at least three millimeters of sand and plaster.

In order to be able to move into a new house before the year, many friends are still grasping the winter decoration construction, but due to the relatively low temperature in winter, there will inevitably be many questions in the decoration, such as does indoor tiling have an impact in winter? How to prevent freezing with tiles in winter, let's popularize science for everyone today.

1. Does indoor tiling have an impact in winter?

Does indoor tiling have an impact in winter? Indoor tiles in winter have some influence, and the main reasons are several aspects:

1. The indoor temperature should not be lower than 8 degrees to prevent the viscosity of cement mortar from decreasing.

2. In the fine sand used, antifreeze should be added, and the stirring temperature should be controlled below 80 degrees.

3. In winter, tiles should be left with a certain gap to prevent cracks due to low temperature.

Second, how to prevent freezing when tiling in winter.

1. How to prevent freezing of tiles in winter, because the weather is cold in winter, especially the outdoor temperature, if it has dropped below zero, we need to keep the indoor temperature higher than 5, otherwise it will affect the adhesion of tiles. And the purchased tiles can be left indoors for two or three days to adapt to the indoor temperature.

2. If the indoor temperature is relatively low, close the doors and windows of the mold hole to increase the indoor temperature. If possible, you can turn on the heating and air conditioning in the room, and the tiling will have no effect.

3. If cement mortar or tile adhesive is used, antifreeze can be added appropriately to avoid the problem of freezing of the adhesive material. However, when mixing the mortar, the temperature of adding water should not be too high, not more than 80. Before pasting tiles, the tiles can be soaked in water to reach a saturated state, which can make the cement mortar bonding effect better, and there will be no hollowing and falling off.

Tips for tiling in winter:

1. Tile tiling is closely related to temperature, so when tiling indoors, the temperature should be above 5 degrees. If you choose to paste the tiles with cement mortar, choose fine sand as sand, which cannot be frozen, and you can add antifreeze appropriately.

2. The weather is relatively dry in winter, and some materials are easy to crack. When storing, care should be taken to avoid placing it in places with low climatic temperatures. If the water temperature is relatively low, the indoor temperature can be adjusted appropriately, and the tiles must be soaked in water first, which is not easy to fall off.

3. In winter, the temperature may be high or low. Try to lay tiles when the weather is clear and the temperature is high, the effect will be better.

The above is about the winter indoor tile has an impact, how to prevent freezing in winter, I hope to help you understand the winter tile, more decoration knowledge, decoration company evaluation, decoration cases, please continue to pay attention!

Summary. It is okay to lay tiles and tiles in the summer, no problem at all. Saying that the summer is not good for decoration means that the rainy season is not good for stucco and wall paint, and the use of wood is not good, because the wood may absorb moisture, or the paint wall paint is not thorough once over, and it is easy to fall off after being brushed with a new one.

Is it good to lay floor tiles and tiles in summer? Isn't it a bad effect?

It is okay to lay tiles and tiles in the summer, no problem at all. Saying that the summer is not good for decoration means that the rainy season is not good for stucco and wall paint, and the use of wood is not good, because the wood may absorb moisture, or the paint wall paint is not thorough once over, and it is easy to fall off after being brushed with a new one.

Do you need to fetch water when the temperature is high?

You can get some water properly.

Does pumping water affect the structure.

It won't affect you if you pump water in moderation, and if you don't control the amount well, it won't affect you if you don't pump water.