If you want to punch an eye in the wall, do you know any tricks?

1. Use a punch machine, so that you can punch holes in the wall, 2. You can also use nails to smash out marks, and then use a hammer to punch out, very quickly, this is the trick I know.

You can use professional tools to drill holes, and then use a pen to draw down the places that need to be drilled, so that you can better drill holes, you can buy an electric drill, so that the holes are particularly fast.

It is necessary to grasp the height in advance, treat the wall in advance, fix it with sealing glue, change the mode of the electric hammer, and select the appropriate tool.

Prepare the wall plaster. The core thing that needs to be prepared is wall plaster. The cost is very low, and a scraper and a plaster spoon will be sent.

Generally, when you take it back, there will be some precipitation, and you need to stir it. Start filling the holes. Directly use a plaster spoon to fill the hole and wait until the plaster is dry.

After that, sandwork with sandpaper. If it is a colored wall, use a paintbrush to brush the color.

Wall hole repair:

Prepare the lid of a tinplate can as a liner with a diameter of at least about a centimeter longer than the hole in the drywall. Use a wire saw to cut horizontal narrow seams in the walls on either side of the hole. The length of the hole, plus the length of the slit on both sides, should be equal to the diameter of the lid so that you can insert the lid sideways into the hole.

Use an awl to drill two holes in the ** of the lid. Thread a wire of about 30 cm or a roller wire through both holes.

Hold the end of the wire and insert the lid into the slit. Still holding the wire, pull the lid in your direction until it sits flat against the inside of the wall. In order to keep the lid in that position, it is necessary to place a broken stick in the hole outside the wall with socks and twist the wire tightly around the stick.

The lid of the jar should fit snugly against the inside of the wall.

Use a putty knife to apply the pre-mixed drywall repair mixture to the drywall panels using a putty knife. (Don't use putty paste as it will shrink when it dries.) You can also mix plaster with water to make a sticky adhesive.

Apply the mixture or plaster to the liner of the hole and the back of the stick. Leave the mixture in the hole, cover the liner and fill the narrow slit, but don't let it spill onto the wall. You should make the patched area slightly less recessed and don't try to make it flush with the wall.

Allow the repaired area to dry until bright white, which usually takes at least 24 hours. When dry, cut off the thread or wire and remove the stick.

To complete the repair, you can fill in the repaired area with some plaster or drywall repair mixture so that the repaired area is flush with the wall. Let it dry, lightly sand the area with sandpaper, apply primer, and then paint again.

The answer is wall repairs that are suitable for most situations.

1. Fix the shelf on the wall to keep it stable, and the shelf can be fixed with wooden strips, cement steel nails, etc.

2. Make a groove on the wall, and use a percussion drill or coring machine with good quality to make a small hole.

3. Choose friends and use the wall drilling drill for drilling, the drilling time is ten to fifteen minutes, and the drill bit is not small to choose according to your needs.

4. Paint the eye-piercing area for aesthetic appearance to complete the eye-piercing work.