-
The film should not only choose regular products, but also pay attention to the construction process of the car film. Because the effect of the film depends largely on the application process.
1. In order to avoid dust and impurities affecting the effect of the film, the body glass should be cleaned first before the car film.
2. The parts that may be damaged during the car film should be covered in advance to prevent scratching the car paint, interior and other parts; Accessories that may affect construction also need to be disassembled in advance.
3. After the overall treatment of the car body, it is necessary to start cutting the car film, and the car film should be preliminarily cut according to the size of the glass.
4. Paste the roughly cut car film on the car glass, and then the front and rear gears need to bake the film according to the amplitude of the car glass, and the effect is to make the amplitude of the car film close to the glass, so that the car film will be flat and free of water marks.
5. After baking, the film will be very obediently attached to the glass, and then it is necessary to make further corrections, that is, according to the shape of the glass, the corresponding shape will be finely cut.
6. The glass film is pasted inside, so the key step is to put on the film, and the requirement of the upper mold is to clean the inside of the glass, which is fast and accurate, and pushes out the moisture as soon as possible.
7. After all the work is done, the last need to do an inspection work, after the whole vehicle is pasted, the situation of each window should be checked, especially the corners, and the blistering phenomenon should be dealt with immediately.
Reminder: After the film, it is required that the window cannot be opened for 2-5 days, the rear gear cannot use the defogging function, and the front windshield cannot use the air conditioner to blow the air; Do not use toothed objects to scratch the glass; After the construction is completed, the warranty application form must be filled in, so that the after-sales service in the future can be guaranteed; After 3 days of car film, it is best to go back to the store for a re-inspection, and if there is any quality problem, it should be repaired in time.
-
Hello, it may be that the module has entered the water, it is recommended to use the car computer to detect it.
-
After the film is set and the excess is cut, we can officially paste the car film on the car glass. Peel off the protective film on the back of the car film, spray water on the inner glass and the car film, and laminate the car film with the glass with water, carefully repair the edge of the car film, so that it can better blend with the glass edge to prevent flash. 5. Catch water.
Finally, we don't forget to catch water on the car film, spray the protective film on the back of the torn car film and stick it on the car film again, and scrape the surface of the car film with a scraper, so that the excess water between the car film and the car window is discharged, so that its adhesion is tighter. The protective film on the back of the car film can effectively avoid the damage of the scraper to the car film.
What to do if the car key locks the trunk.
There are generally three ways for rats to get into the car: from the car door, hidden in the belongings to be brought into the car, and the air conditioning intake. >>>More
Dear, I suggest you tear it off and buy a new film.
If the water pipe bursts at home, it can be repaired according to the following methods: >>>More
You can use a spare key, generally when buying a car, there will be a spare key in the car's manual and common tools, when using the spare key, first find a square or round lattice on the door handle on the driver's side of the car and buckle open this grid. After picking the car lock cover, it is the hole of the mechanical key, and then use the spare key to open the car door. >>>More