-
The film should not only choose regular products, but also pay attention to the construction process of the car film. Because the effect of the film depends largely on the application process.
1. In order to avoid dust and impurities affecting the effect of the film, the body glass should be cleaned first before the car film.
2. The parts that may be damaged during the car film should be covered in advance to prevent scratching the car paint, interior and other parts; Accessories that may affect construction also need to be disassembled in advance.
3. After the overall treatment of the car body, it is necessary to start cutting the car film, and the car film should be preliminarily cut according to the size of the glass.
4. Paste the roughly cut car film on the car glass, and then the front and rear gears need to bake the film according to the amplitude of the car glass, and the effect is to make the amplitude of the car film close to the glass, so that the car film will be flat and free of water marks.
5. After baking, the film will be very obediently attached to the glass, and then it is necessary to make further corrections, that is, according to the shape of the glass, the corresponding shape will be finely cut.
6. The glass film is pasted inside, so the key step is to put on the film, and the requirement of the upper mold is to clean the inside of the glass, which is fast and accurate, and pushes out the moisture as soon as possible.
7. After all the work is done, the last need to do an inspection work, after the whole vehicle is pasted, the situation of each window should be checked, especially the corners, and the blistering phenomenon should be dealt with immediately.
Reminder: After the film, it is required that the window cannot be opened for 2-5 days, the rear gear cannot use the defogging function, and the front windshield cannot use the air conditioner to blow the air; Do not use toothed objects to scratch the glass; After the construction is completed, the warranty application form must be filled in, so that the after-sales service in the future can be guaranteed; After 3 days of car film, it is best to go back to the store for a re-inspection, and if there is any quality problem, it should be repaired in time.
-
It is recommended to paste light colors, good vision, Weigu, MZJJ, 3M these.
-
Different brands and different models of films** are very different, you can go to the official website to check the ** of each model**.
-
If you want to be more transparent for privacy, you can stick it, and if you want to be more transparent, you can not stick it.
-
Hello owner, Geely Annihilation Borui this car has a fashionable appearance, there is nothing to modify, if you need to modify it, it is generally sold vertically is the appearance modification, I hope it can help you, if you have any questions, you can continue to consult, I wish you a happy life! Happy family! [If you have a problem with the car, ask the car master.]
4S shop professional technician, 10 minutes to solve. 】
-
Hello, the whole leather car rolling ridge paste color grinding, green, purple can be, the entire roof paste bright black, the wheel hub is enlarged, the shock absorber is changed to twisted tooth suspension, the lowest body height, the large surround replacement set, the exhaust pipe is changed to a double row [there is a problem with the car fuel preparation car, ask the car master. 4S shop professional technician, 10 minutes to solve. 】
-
Geely Borui has a strong sense of science and technology, rich configuration, and is a famous brand that has entered the mid-to-high-end market, which is very stable.
The interior can be regarded as luxurious, and it is determined that most of the seat materials are leather, which is more comfortable, and the central control shape also has the feeling of a high-end car, which is known as the most beautiful domestic car.
-
No one imitated it, independently developed.
with Volvo's technology.
A little confident, okay.
-
I really want to spray you, the car made in China is imitation?
-
The servile nature of the people who ask this question is too heavy, the four major inventions are Chinese, how can it not be said that the whole world is imitating China.
-
The appearance I think is an imitation of Mercedes S63AMG
-
The long one is a bit like the BMW 3 Series GT
-
The composition of car paint depends on what brand of paint is used, and each manufacturer has a different formula for the same color.
The basic components of each manufacturer are almost the same, but due to the problem of production and art, there will be a gap in the composition of the paint, and there will be a gap in the composition of each batch of manufacturers in the same batch, and the stability of foreign paint will be better in general.
Generally, the factory paint is sprayed at a high temperature by the original factory, which needs to be dried at more than 100 degrees, and such a technology cannot be realized after the actual car paint is damaged. Later, the repair paint was used, and the repair paint used by Kuaimei Automobile was the repair paint of PPG, the original paint manufacturer of Mercedes-Benz.
It doesn't make sense to ask what car paint is, and it is serious to find a good construction unit.
-
Your friend told you not to buy it, which means that there are more small problems with this car, if you can accept it, then buy it.
I don't think it's a big problem.
-
Makes sense. The joint venture car has been tested by the market and has a good reputation.
-
First of all, with BAI's current technology, there is no obvious quality distinction between joint venture DU cars and domestic cars, and the concept should not stay in the past version;
Secondly, one.
The right car, just like a mobile phone, you won't use it for decades, maybe five or six years you will have the urge to change the car, and then your economic strength can also change the car.
Thirdly, there may also be problems with the joint venture car, and the joint venture car is obviously tens of thousands more expensive for the same model.
No matter which one you buy, as long as you like it, everyone's lover is different, don't regret picking it.
-
Borui is a very good car, insist on your own views and choices, and any car can be driven for many years, not to mention that as a high-end Borui, why not reduce the price**.
-
Damn, buy it if you like it, the joint venture car must be good?
-
The durability problem is not necessarily worse than that of a joint venture car.
In terms of driving, there is basically no comparative significance, dynamic return force, fuel consumption, driving quality, body limit, etc., there are obvious gaps.
This car, in addition to its large size and high configuration, can create a so-called sense of luxury, in terms of mechanical quality, compared with models in the same price range, there is no advantage.
-
You can wait, ** Borui GT is going to come out, the manufacturer will improve the previous problem, you can wait and see, there has been a real car before, let's take a look at the appearance first.
-
I like Geely Borui a lot, I don't like to buy a joint venture car, just want a domestic car.
-
Anyway, I bought it, and I don't know if you buy it or not.
-
It must be a good joint venture car, and the domestic car is definitely not as good as the joint venture, and there is extra money to buy an imported car.
-
Let's go directly to the joint venture, I have also sold cars. Never buy domestic.
-
After Geely acquired Volvo, the car-making process has improved a lot, in general, as long as the maintenance is in place, there will be no major problems within 300,000 kilometers, you can buy, and the boss of Geely sits in this car.
-
The question is, who needs durability now? Are you ready to drive 1 million kilometers?
-
The joint venture car is high, and your friend's commission will definitely be much higher, and China has a lot of talents like your friend who has not been able to develop.
-
What do you mean by liking the appearance! The appearance of BMW Mercedes-Benz is not as good as Borui? It's not that it's cheap, what is cheap and good in China now? At the end of the day, you get what you pay for.
If you can see the color of the underlying primer if you can see the color of the underlying primer, please look at the scar again. Generally speaking, the bumpers, mirrors and wheel arches of some cars are made of engineering plastic and will not rust. Other than being ugly, there is no big problem. >>>More
The black primer of the white car is serious. If the body paint is white, then the scratches have been exposed black, indicating that the scratches have damaged the primer. Don't let go at this time. Over time, the scratches will rust. >>>More
White car paint rust spots can be removed by car washing mud, polishing, etc. >>>More
Lujia electric car is OK, but the body is easy to rust, the tram is expensive, the main reason is that the electricity price is more economical than the oil price, the manufacturer sees the opportunity to come, and it is strange that the price is not high!
People who have a car know that maintaining a car is a hard thing, because in addition to daily refueling, there are maintenance, repairs and other things that need to be done, so many people who have a car sigh: "It's easy to buy a car and it's hard to maintain a car." Maintenance is the most headache for many people, because this thing has been continuing, as long as the car is still driving, it needs regular maintenance, and the cost of maintenance is not low, so the cost of a year is not small. >>>More