Is the reverse charge mature 20, is the reverse charge mature

The reason why the doctor will give you an inverted charge is usually because the infection at the root tip of the affected tooth is so severe that it has produced a cyst and it is difficult to apply medicine with a conventional root canal**. However, when the apex is removed, whether the cyst is completely removed and not omitted depends on the doctor's experience and skill level.

It is recommended that you go to the specialist of periapical disease in the dental hospital now**, there are not many small surgeries carried out in general hospitals and large clinics, and there may be some shortcomings.

After the tooth is removed, the incision heals and there is no more pain. Now the technique itself is very mature, but the key depends on the use of the technology and the doctor's own mastery.

It's like a small surgery in surgery, but there are also many complications that doctors do not grasp well.

First of all, there is a question, since I knew that I didn't do a root canal ** before, why didn't I do this root canal ** first, but directly did reverse filling? Kind of don't understand. Isn't it good to make a pile crown?

Ready to do an undercut now? I don't understand it even more, it is generally done with a root cut, and then the reverse charge is completed at the same time.

Generally speaking, after the tooth is extracted, as long as it is scraped well, the inflammation disappears, and the symptoms should disappear. But I've heard of cases where it still hurts after a tooth is extracted, but that case should have something else.

Hello! Inverted filling refers to the technique of filling the end of the root canal after opening a window at the apex when conventional root canal surgery cannot be performed due to the impassability of the root canal.

Hello, root canal filling is referred to as root canal**, which is a better **method for endodontic disease, and the film is to understand the length of the root canal and whether the root filling is in place.

Reverse charging generally refers to the discharge of the rechargeable battery to the charger when the charger is not powered on and the rechargeable battery is connected. Some rechargeable batteries and chargers will not, such as mobile phone batteries, etc., and there is a circuit board inside the battery to prevent backcharging; In the case of a rechargeable battery without a circuit board (such as nickel-metal hydride batteries, batteries, etc.), when the output of the charger has a light load resistor, it will discharge the charger. Generally, a diode will be added to the output end during the design to prevent backcharging.

It is the power to run back, which is equivalent to the power if you continue to charge.

Hello:1Shutdown charging test.

2.If conditions permit, replace the spare charger for testing.

3.When the phone is turned on and charged, if the mobile phone is equipped with a third-party plug-in such as a charging doctor, it is recommended to test it after uninstalling it.

4.Check whether there are foreign objects in the charging interface of the mobile phone, such as liquid ingress and debris that cause poor contact between the charging interface of the mobile phone and the charger, if this situation is recommended to be repaired as soon as possible.

5.Back up your phone data (**book, text messages, **, etc.), factory reset your phone.

Generally, it is a problem with the charger, you can try the following operations to eliminate them one by one:

1.Charge with a different data cable (most of the slow charging of mobile phones is due to the data cable, and the contact is not good);

2.Change the charging head, which excludes the above possibility, and you can try another charging head;

3.Finally, you can charge other devices that support this interface, and try to see if the charging time is normal.

That's because Xi Fuling has not designed this power bank protection board, and such a power bank is easy to damage our equipment, or choose a good power bank, Dopoda's good eyes.

It may be a problem with the battery information, and you can delete it with the re manager after obtaining the permission.

There is also a possibility of system failure, look for after-sales service.