The lower layer of the refrigerator began to melt ice, is it the tube of the refrigerator that is wo

Updated on home 2024-07-17
14 answers
  1. Anonymous users2024-02-12

    The lower layer of the refrigerator begins to melt ice, it may be a problem with the motor, or it may be that the refrigeration pipe of the lower layer is damaged, in this case, it is recommended to ask a professional master for maintenance.

  2. Anonymous users2024-02-11

    Like the lower layer of the refrigerator, if there is ice, it is not necessarily that the refrigerator tube is worn, but it may also be caused by the reduction of the refrigerator's refrigeration function.

  3. Anonymous users2024-02-10

    The lower layer of the refrigerator starts and begins to draw, it may be caused by ice, the tube of the refrigerator is blocked, if the pipe leaks, the upper and lower layers will not be able to impress the refrigeration.

  4. Anonymous users2024-02-09

    The lower layer of the refrigerator starts to skate, not because the tube of the refrigerator is worn, it may be caused by the high temperature set by your refrigerator, or too little frozen products in the refrigerator.

  5. Anonymous users2024-02-08

    The lower layer of the refrigerator began to melt ice, it may be that the compressor is not working, uh, it may also be a lack of refrigerant, this needs to be checked to know that there is a specific problem, and it may also be a problem with temperature control.

  6. Anonymous users2024-02-07

    If this happens, it is not necessarily that the refrigerator tube is worn, but perhaps the seal of the door below is not tightly sealed.

  7. Anonymous users2024-02-06

    The use of the refrigerator is a bit too long, it is best to replace it with a new one, anything will have a service life, like you, the refrigerator is not refrigerated, you had better take it to repair, it is best to replace it with a new refrigerator.

  8. Anonymous users2024-02-05

    Your refrigerator has been used for more than ten years, and the pipes inside have been rusted and hollowed.

    And the old refrigerator for more than ten years consumes a lot of electricity, so it is not recommended that you repair it again.

    It's better to buy a new one, the refrigerator is very cheap now.

  9. Anonymous users2024-02-04

    First of all, check whether there is electricity, and whether the refrigerator door is closed tightly, if it is no problem, you should find a professional master to see what is the cause.

  10. Anonymous users2024-02-03

    It may be because it affects the temperature you set, and it doesn't reach the need, so there is this problem, or it's the power supply.

  11. Anonymous users2024-02-02

    Okay, the refrigerator sank and started skating, and it was the tube of the ice wire that broke.

  12. Anonymous users2024-02-01

    Is it possible that there is a problem with the inside of the refrigerator when the refrigerator is opened, it is possible that the tube is aging, or it is possible.

  13. Anonymous users2024-01-31

    1. The refrigerator door is opened for a long time; 2. Every corner of the refrigerator is stuffed full; 3. The freezing of the refrigerator tube is related to the relatively low temperature setting.

    Suggested workaround:

    1. The freezing of the refrigerator drain pipe is also related to the refrigerator door being opened for a long time, this reason is very easy to understand, because if the refrigerator door is left open for a long time, the cold air in the refrigerator and the hot air outside will be combined, and frost will occur at this time.

    2. In addition to the reason for temperature setting, the freezing of the refrigerator drain pipe is also related to our usage habits, if you are used to stuffing every corner of the refrigerator, the refrigerator will not be able to breathe, and if you like to stuff some food that is not cooled into the refrigerator, the water vapor in the refrigerator will become more, and the drain pipe will be easy to freeze.

    3. When setting the temperature of the refrigerator, most people think that the lower the temperature is set, the better the effect, but in fact, it is not the case, if the temperature of the refrigerator is set too low, it will lead to too much frost, and the frost in the refrigerator with very low temperature can not be turned into water, it can only be discharged through the drainage hole of the refrigerator, and once there is too much frost, the drain pipe will naturally freeze.

  14. Anonymous users2024-01-30

    Common causes: 1. It may be icing caused by the temperature being adjusted too low. 2. It may be the icing caused by the poor foaming quality of the insulation layer.

    3. It may be caused by the deformation and convexity of the back wall of the refrigeration room, which is separated from the evaporator and affects the temperature conduction. Suggested solutions: 1. If the temperature is too low and the temperature is too low to cause freezing, you can turn the temperature of the refrigerator up to the highest.

    Cold rooms should generally be set up between four and eight degrees Celsius. Although the preservation effect is good at low temperature, it consumes electricity relatively speaking, and although the preservation effect is relatively poor at high temperature, the power consumption is still relatively small. 2. If the temperature of the refrigerator is not very low, but there is still freezing, it means that the foaming quality of the insulation layer is poor.

    If it is within the warranty period, you can ask the manufacturer to return it. If the warranty period has expired, the refrigerator can also be modified and re-foamed. You can also find a power cord, wrap one end around the compressor high-pressure pipe, take out the compressor water box, insert the other end of the power cord into the drain in the refrigerator, and then bend the power cord well, and install the water box smoothly.

    3. If the evaporator in the refrigeration room is built-in, and the back wall shell is deformed and convex, which is separated from the evaporator, resulting in the extension of the compressor work, it is enough to contact the deformed back wall with the evaporator.

Related questions
13 answers2024-07-17

How to de-ice your refrigerator.

Method Step 1: >>>More

28 answers2024-07-17

1. Use a hot towel to de-ice.

Ice cubes will melt when exposed to heat, which is common knowledge that everyone knows, so we should also build on this common sense when we remove ice. First, soak the towel in hot water, then wring it out until it is semi-dry, then cover the towel on the ice surface, and repeat this operation a few times before the frost will come off. >>>More

8 answers2024-07-17

1. Hot towel compress.

Hot towels are a relatively easy way to apply ice, and you can use warm wipes to wipe the inside of the refrigerator to accelerate the melting of ice cubes, but because the temperature is low, remember to wear gloves when de-icing. >>>More

13 answers2024-07-17

Your refrigerator temperature compensation is turned on, if the home is not cold, adjust the switch to the usual time. If this is still the case, and it does not stop, I regret to inform you that the refrigerator refrigerant has leaked. Let's get it repaired.

19 answers2024-07-17

Automatic ice after the refrigerator freezes is not a fault, it is the function of the temperature control and defroster, which is normal: >>>More