What to do if water seeps up under the bathroom tiles

Bathroom tile seepage This is a common problem in many homes, because of various reasons lead to wall tile water seepage, in addition to affecting the appearance of the bathroom, more affects the use of the bathroom, over time these seepage places may have the danger of tiles falling off.

1. Cause analysis:

Bathroom tile water seepage must first understand what causes water seepage, there are several reasons: first, the waterproofing of the bathroom is not in place; The second is that the water pipe in the wall is broken and leaks; There is also in the rainy weather, due to the humid air, resulting in water on the surface of the tile; Finally, the tile gaps are not good, and there is water seepage.

2. Solution:

If there is a problem with the waterproof layer, the tiles must be removed, the wall must be hit to the waterproof layer, and it is better to see the inner wall, and then scrape the putty again, re-make the waterproof layer for the wall, and then pave the tiles.

The second is that the water pipe rupture leads to water seepage, in this case, the water pipe needs to be tested to see if there is a water leakage, if it is indeed caused by the water pipe damage, to find out the leakage immediately, open the wall and replace the water pipe.

If the wall is only leaking because of moisture, you only need to pay more attention to the ventilation and cleaning of the bathroom in your daily life.

If the tile gap is not good, there is water seepage. First you need to use cement or caulk to fix the cracks, and then make a layer of waterproofing.

You don't need to find a master, you can use the brick-free waterproof glue. First block the drain, clean the ground, then mix a few in proportion, then sprinkle on the ground, wait until there is gel and clean up, after cleaning up you need to wait 12 hours before using water. You don't have to worry about yellowing and not being smooth, just choose a good one.

Even if you ask the master to get it, the master uses this material.

Water seepage in the bathroom floor tile joints generally has the following situations.

First, if the floor tiles have only been laid for a short time, this is due to the fact that the cement under the floor tiles has not dried, and the water seeps outward, and this situation will dry after a while.

The second is that the water pipe buried under the floor tiles leaks, resulting in water seepage, which can only be broken and repaired.

In addition, there is a hollow drum under the floor tiles, and water flows down the brick joints under the floor tiles during bathing, and after the ground dries, water seeps out of the brick joints.

If it is just after laying the bricks and seeping water up overnight, it may be that the sand and ash mixed when laying the bricks is too wet, the waterproof is done well, and the precipitated water bubbles up to the floor tiles, which is not too nervous, and it will be fine after the day. If it is a floor that has been used for a period of time, in order to determine whether it is a leak in the water pipe or something else, you can first close the main valve of the hot and cold water door in the bathroom, open the faucet to drain the pressure, and then observe for a day to see if the water continues to seep out. If there is no water seepage, then you have to raise bricks to check the leakage of the water pipe.

There is a leakage point in the tap water, because the leakage point is above the waterproof material, it can only flow along the void, and there is nowhere to flow down, it can only flow along the brick joint, and the lower part of the water will continue to flow from the bottom to the top (overflow) when the water is full.

Check if there is any water leakage, you can pressure test the water supply pipe.

1. If the tile is cracked, then replace the cracked tile with a new tile.

2. If the gap is caused by the wrong way of tile paving, you need to fill a layer of beauty glue at the gap.

3. If there is a gap on the edge of the toilet, you can brush the edge of the toilet with waterproof glass glue.

4. If the water pipe under the tile is leaking, the water pipe can be waterproofed or replaced.

5. You can also dismantle the porcelain lead bricks in the bathroom around the small Fan Huai Mausoleum, brush the waterproof paint and re-paste the tiles.

There are 4 main reasons:1Around the pipe, there was loosening, cracks, cracks.

2.Floor drain, loosening, cracks, cracks around the toilet in contact with the floor! 3.

Gaps, cracks appear in the joints between the floor tiles and the floor tiles. Bathroom and kitchen leakage Biyu pure regret water generally does not exceed the above three reasons.