-
In this case, it should be better to prune, if the temperature is a little higher, you can bring spontaneous germination and growth of the happy tree or a relatively easy plant, pay attention to the heat preservation in winter should not be lower than five or six degrees, and the happy tree maintenance and management.
1. Soil. The first thing to ensure is to use the soil that is suitable for its growth. If the soil is not suitable, no matter how carefully it is maintained, it will not grow well.
Specifically, the soil that raises it needs to have a certain degree of air permeability and have a certain amount of nutrients. For home maintenance, you can mix garden soil and humus soil in a ratio of 5:3, and then add a small amount of river sand to use it as cultivation soil.
2. Watering. It prefers moist growing conditions and needs to increase the frequency of watering during the growing season to help it grow better. In the summer, you should also water it more to help it replenish the evaporated water. Water less in winter to prevent the growth of foliage.
3. Fertilization. During the period of vigorous growth, fertilizer needs to be applied once a month to help its branches and leaves grow faster. When the temperature is above 32 and below 12, it grows slowly, so fertilization can be suspended.
Fourth, light. Although it has a certain shade tolerance, it is still a light-loving plant. Therefore, it is best to put it in a sunny place for maintenance, at least semi-shaded light conditions, otherwise it may grow poorly due to lack of light.
5. Temperature. Its optimal growing temperature is 20-30 . When the temperature is above 32 or below 12, its growth rate will be significantly slower. When the temperature is below 5, it is possible to suffer frostbite. So you need to take a way to keep it warm.
-
Frost damage to the tree of happiness is generally not good.
If all the leaves fall like this, it should be difficult to save them again.
The Happiness Tree is a southern plant that is afraid of cold and frost in winter.
You must pay attention to heat preservation in the day.
-
If the happy tree is slightly frozen, it is not necessary to prune it significantly, but only need to spray fertilizer on the surface of the leaves, and then prune and cut off the branches until the spring of the following year.
If the frost is severe, you can only choose to protect the roots, prune off all the dry leaves, branches, etc., and then water a lot to loosen the soil, but there can be no stagnant water.
1. Spray foliar fertilizer.
The method of spraying foliar fertilizer is suitable for the situation that the frost is not serious: in winter, the leaves are curled up and yellowed due to wind, cold dew or morning frost, etc., at this time, you can use a special antifreeze and an appropriate amount of urea to spray on the surface of the leaves. The concentration of fertilizer and the number of spraying can refer to the instructions for fertilizer use, and the concentration is rather light than thick.
If you prune a lot after a slight frost, it may cause secondary damage, and you can prune it when the new shoots germinate in the spring of the following year.
2. Root preservation. In winter, the leaves are severely dehydrated due to low temperatures or frosts, and their leaves cannot recover immediately, so it is necessary to preserve their root system. First of all, it should be watered a lot to loosen the soil, but there should be no water accumulation in the pot; If it is planted outdoors, it should be covered with straw on top of the soil, the thicker the better.
After that, all the dead branches and leaves should be cut off, and if the main trunk is also in a state of lack of water, it should also be cut off. Finally, ensure the water of the roots, so that the root system is not in a state of water shortage. Wait until the following spring to slowly sprout.
3. Increase nutrients.
Regardless of the type of frost, the plants will become very fragile at this time, and appropriate organic fertilizer needs to be applied.
1. Causes.
1.Normal metabolism. >>>More
1. Soil blending method.
Breeding happy trees should first ensure that the soil is suitable, choose loose and fertile, good drainage sandy soil for maintenance, you can use peat soil, pastoral soil, river sand soil mixed preparation. In addition, it needs to be replaced every 1 2 years to provide a better environment for the plants to grow. >>>More
Formaldehyde can be absorbed.
The potted tree of happiness can remove indoor odors, can effectively absorb formaldehyde and benzene, and is the preferred plant for the house after decoration. The Happiness Tree can be used as a "high-efficiency air purifier" in the new home. At the same time, the Happy Tree can also absorb carbon dioxide and release oxygen at night, increasing the content of negative ions in the air and increasing air humidity. >>>More
Here Xiaoyou will teach you the most classic four tricks, the first trick: the happy tree likes acidic soil; The second trick: ventilation is very important, and the happiness tree placed indoors must be frequently opened for ventilation; The third trick: temperature control; The fourth trick: rain is the best source of water for the tree of happiness.
Happy tree can germinate about a week after the completion of pruning, the pruning of the happy tree is recommended to be carried out in July every year, pruning is for stunted growth, long, diseased branches and leaves, as well as overgrown branches, after the completion of pruning need to strengthen the management of the plant, control the light, water, to ensure that the plant quickly resumes growth. >>>More