The happy tree is cut after the repot, and it always does not sprout, how to solve it?

Updated on home 2024-07-07
7 answers
  1. Anonymous users2024-02-12

    After about a week of maintenance in the shade, it is cured in the sun. Good luck.

  2. Anonymous users2024-02-11

    1. If you find that the leaves are wilted and dry, immediately check whether the root system is damaged.

    2. If you find that the leaves are wilted and dry, immediately remove the wilted and dry leaves.

    3. If you find that the leaves are wilted and dry, immediately check the watering situation (dry and wet on the surface of the potting soil).

    4. If you find that the leaves are wilted and dry, immediately move to a cool and ventilated place.

  3. Anonymous users2024-02-10

    Happiness tree leaves wilting? Change the watering method, and the problem will be solved.

  4. Anonymous users2024-02-09

    The Tree of Happiness does not start growing directly after the change. Instead, it will take a while to get used to the new soil. During this time, it grows slowly, and the rate at which it absorbs nutrients and water from the soil decreases.

    Therefore, it may have the problem of wilting due to the lack of water and nutrients.

    After changing the pot, it needs to be placed in an environment with no bright light, about 20. Stop fertilizing for a while, and don't water too much. Unless the soil is very dry, you don't need to water it, just spray some water around it.

    This will prevent it from waterlogging because it can't absorb water in time. After about 7 days, it will be able to regain its growth.

    If it is left in a suitable environment and it does not recover within 10-15 days, it may be because its roots have been damaged during the repotting process. At this time, it should be taken out of the soil again, cut the rotten roots, disinfect and replant it back into the soil, and slowly maintain.

  5. Anonymous users2024-02-08

    Hello, after the happy tree is repotted, the leaves are dry and wilted, and it should be placed in an environment where there is no direct sunlight and air circulation in the empty state. At this time, do not water it and apply bucket fertilizer, because it has not been completely potted, and it is easy to cause fertilizer damage and root burning. When there is a shortage of water, just spray some water on the plant and its surroundings, and usually wait for a week or so for the plant to return to its normal growth state.

  6. Anonymous users2024-02-07

    1. Causes of wilting.

    Just after the change, the tree of happiness will not start to grow directly. It takes a while to get used to the new flower landscape. During this time, it will grow slowly and absorb nutrients and water from the soil at a slower rate.

    Therefore, there may be wilting problems due to insufficient water and nutrients**.

    Second, the treatment method.

    After changing the pot, it needs to be placed in an environment without strong light for about 20 years. Stop fertilizing for a while and don't water too much. Unless the soil is very dry, don't water it, just spray a little water around.

    This will prevent it from getting wet because it doesn't absorb water in time. After about 7 days, it will grow again.

    3. Precautions.

    If it is placed in a suitable environment and does not recover for 10-15 days, it may be that the roots and tendrils of the stove are injured in the process of repotting. At this time, it should be removed from the soil, cut off the rotten roots, disinfected and then planted in the soil, and slowly matured.

  7. Anonymous users2024-02-06

    The leaves of the happy tree are evergreen in all seasons, and they like a warm and moist growing environment, so it is best to choose spring and autumn to repot the happy tree, because the air temperature is suitable for repotting in these two seasons.

    Repot the Happiness Tree needs to be noted:

    When taking out the happy tree from the original potting soil, be careful not to damage the roots, if there are dead branches and dead roots, you can prune them off, dry them a little and then plant them in a new pot, the new soil must be loose and breathable, but do not put down the bottom fertilizer for the time being, so as not to burn the roots.

    The soil can be garden soil, nutrient soil or humus soil, add a part of the river sand pearl and so on. After planting, it is necessary to water thoroughly, and then the branches are placed in a cool and ventilated place for maintenance, this slow seedling stage is more important, neither too much watering, nor long-term non-watering, but also can not be in a high temperature or lack of water environment, as long as the root system is not damaged, the temperature is suitable, and the sun is not basked, its slow seedling period will be shorter.

    If the leaves are wilted and dry, check whether it is caused by excessive drying of the potting soil, if so, water it in time, and do not bask in the sun, not in the sun for the time being, so as not to wilt the leaves.

    The happy tree is more drought-tolerant, usually can not be watered too often, it likes to tell the warm place, so it can not be frozen in winter, to be placed in the file nucleus warm and sunny position.

Related questions
8 answers2024-07-07

The happiness tree you just bought should be repotted in time, otherwise the branches will break.

4 answers2024-07-07

1. Soil blending method.

Breeding happy trees should first ensure that the soil is suitable, choose loose and fertile, good drainage sandy soil for maintenance, you can use peat soil, pastoral soil, river sand soil mixed preparation. In addition, it needs to be replaced every 1 2 years to provide a better environment for the plants to grow. >>>More

16 answers2024-07-07

Happy tree repotting for a month is not good, it may be the season of changing the pot is not right, it may also be the breeding method is wrong, change the pot in spring or autumn, the environment should pay attention to ventilation, immediately move to a sunny environment for ventilation, pay attention to proper watering, do not dry and do not water, watering should be watered thoroughly. The specific method of the happiness tree: >>>More

7 answers2024-07-07

Formaldehyde can be absorbed.

The potted tree of happiness can remove indoor odors, can effectively absorb formaldehyde and benzene, and is the preferred plant for the house after decoration. The Happiness Tree can be used as a "high-efficiency air purifier" in the new home. At the same time, the Happy Tree can also absorb carbon dioxide and release oxygen at night, increasing the content of negative ions in the air and increasing air humidity. >>>More

5 answers2024-07-07

Here Xiaoyou will teach you the most classic four tricks, the first trick: the happy tree likes acidic soil; The second trick: ventilation is very important, and the happiness tree placed indoors must be frequently opened for ventilation; The third trick: temperature control; The fourth trick: rain is the best source of water for the tree of happiness.