What to do if the motorcycle water tank is leaking? How to make up for the leakage of the motorcycle

The water tank leakage can not be repaired, and the water tank fan can not be repaired because it is one, and it cannot be removed.

When driving, if the vehicle water tank leaks, it can be dealt with in the following ways:

1.When the leakage is relatively slight, add a bottle of water tank plugging agent to the water tank and start the car to run. After circulation, whether it is the water tank, rubber pipe and pads in the cooling system, the leakage will stop leaking, and there is no need to release it after the leakage is stopped, which will not affect the heat dissipation and blockage.

2.When there is no plugging agent, you can temporarily put loose tobacco into the water tank, and use the water circulation pressure to make the tobacco plug in the leakage of the heat pipe for temporary use.

3.When the water tank pipeline leaks, the leaking heat pipe can be cut from the leakage, and the cut heat pipe can be blocked with soap-coated cotton balls, and then the head of the cut heat pipe can be flattened with pliers and then rolled and pressed to stop the water leakage. If the rubber pipe joint is leaking, you can use a screwdriver to wrap the rubber pipe joint clip twice around the rubber pipe joint, and then tighten it with pliers.

If the rubber tube is damaged, you can use adhesive tape to wrap the cracked area and use it temporarily.

The above are all emergency measures, and the most important point is that the car must not be caused by lack of water and high temperature, otherwise it can bring great losses. You should go to the repair shop or 4S shop immediately to replace the water tank treatment.

How to make up for the leakage of the motorcycle water tankHow to make up for the leakage of the motorcycle water tank How to make up for the leakage of the car water tank Possible causes and solutions for the leakage of the car water tank: 1. The water tank cover is not tightened, and it can be tightened. Note that you should wait for the engine to cool down completely before checking, otherwise if you open the water tank cover at high temperature, the high temperature and high pressure antifreeze may pop out and hurt people; 2. When the water tank pipeline leaks, pay special attention to check the water inlet pipe and outlet pipe.

Stop the water leakage by tightening the water pipe clamp or adding the clamp, or you can choose the emergency bandaging method of water pipe leakage, and replace the faulty water pipe in time; 3. If the crack of the water tank leakage does not exceed 1mm, you can choose to add a strong plugging agent to the water tank, open the engine, and open the large cycle within 5-10 minutes, the cooling system whether it is the water tank or the rubber pipe and the whole cushion block, there will be a leakage phenomenon, and the leakage does not need to be released, which will not affect the heat dissipation and blockage, if the crack is very large, the water tank needs to be replaced. @2019

Above the water tank is the water inlet.

Most motorcycles are air-cooled and have no water tank. Only a very small number of motorcycles are water-cooled, and the water tank is in front of the engine, and the water pipe at the bottom of the water tank is removed and new antifreeze is added.

The natural air-cooled hair collapse motor is adopted, and the cylinder and cylinder head are cast with many heat sinks.

The heat dissipation area is increased, and the oncoming wind blowing in the car is used as the cooling medium to take away the engine heat. Inside, the oil is circulating to take away the heat. Generally, it is used in small displacement vehicles below 250, and the endurance and noise and vibration are greater than those of water cooling, but it is enough for these vehicles with low use intensity.

The natural air-cooled engine is adopted, and the cylinder and cylinder head are cast with a lot of heat sinks, which increases the heat dissipation area, and uses the wind blowing from Li Ru during the driving process of the car as the cooling medium to take away the engine heat. Inside, the oil is circulating to take away the heat. Generally, it is used in small displacement vehicles below 250, and the endurance and noise and vibration are greater than those of water cooling, but it is enough for these vehicles with low use intensity.

Motorcycle. Motorcycles, powered by gasoline engines.

Driven, two-wheeled or three-wheeled vehicles that rely on handlebars to steer the front wheels, are light and flexible, and travel quickly, and are widely used for patrolling, passenger and cargo transportation, etc., and are also used as sports equipment. In terms of general direction, motorcycles are divided into street bikes, road bikes, off-road bikes, cruisers, and station wagons.

Wait. In 1885, the German Gottlieber Daimler.

With one engine installed in a frame machine, the world's first motorcycle was born.

Motorcycle sports related to motorcycles is a kind of military sports, which is a kind of competitive sport with motorcycles as equipment, divided into two types of two-wheeled and three-wheeled models, and each model is divided into several grades according to the working capacity of the engine cylinder. According to the form of competition, it can be divided into cross-country race, multi-day race, road race, track race and travel race.

1. Consequences:

1. If the oil pump pumps to the water, the water will eventually pass through the fuel injector, spray into the intake manifold in the form of a mist, and then enter the cylinder, the amount of water is very small, that is, a few grams, at this time the water is sprayed in, the engine will naturally go out and stop running, after the engine stops, the oil pump will not continue to work.

2. The problem of the fuel tank sucking a small amount of water is not the biggest, there is a steam filter to filter, of course, too much is not good. will cause engine damage and start. If there is a lot of water, it will be damaged immediately, and there is a possibility that the cylinder will be stalled.

2. Solution:

1. If the fuel tank is a small amount of water inlet and the engine can start and run normally, the owner can add some fuel additives such as fuel tank water remover, fuel treasure, etc. to help the engine burn better.

2. If the fuel tank or oil duct enters a lot of water, which has affected the normal start and normal operation of the engine, and there is water in the car fuel tank, the engine is not easy to start, the power is insufficient, the vehicle shakes and other bad situations, this situation should be solved at the maintenance station.

When the engine is working, once the water enters the cylinder, it will cause the connecting rod in the engine to deform and twist, and the crankshaft, connecting rod and piston will be affected.

If the fuel tank is a small amount of water inlet and the engine can start and run normally, the owner can add some fuel additives, such as fuel tank water remover, etc., to help the engine burn better. If a lot of water enters the fuel tank or oil duct, which has affected the normal start and normal operation of the engine, and the engine is not easy to start when water enters the engine, the power is insufficient, the vehicle shakes and other bad situations, this situation will be dealt with at the maintenance station.