How to make your own humidifier easily, how to make your own humidifier

The dry winter in the north, coupled with indoor heating, causes many people to wake up at night, nose bleeding, dry lips, sore throat, the solution of the average person is to buy an air humidifier in the supermarket, but an air humidifier is often hundreds of yuan, many salaried people are reluctant to buy, and the humidifier consumes electricity, in case the quality is not up to par, it is easy to cause accidents. Many people think of various "soil methods", such as putting a basin of water in the house, or putting a wet towel on the heating, but this only solves part of the problem: the evaporation rate of a basin of water is too slow, the air humidity is not improved much, and the wet towel can not store much water, often less than an hour has been almost dry, it is impossible to wet the towel all night, so these methods are not obvious to improve the air humidity.

Now advocating energy conservation, I will teach you an air humidifier without electricity today, the raw materials are very simple, but it is very effective, this is what I figured out myself: Materials: A large Coke bottle, A disposable infusion tube (it is recommended to use a new one, it is available in pharmacies, if it has been used at home, ensure that it can be reused after disinfection), a towel, a string; Method:

1. Pierce the hard end of the infusion tube through the cap of the cola bottle, pay attention to the tightness (if it is not too sealed, you can make the small hole appropriately larger, and first stuff a circle of bicycle inner tube rubber in the small hole, or several layers of soft plastic film, and then penetrate it to seal it), 2. Fill the cola bottle with tap water, hang it upside down with a string at an appropriate height above the radiator, put a towel on the radiator, and put the water outlet end of the infusion tube on the towel. 3. Adjust the infusion tube roller, Make the water flow rate roughly equal to the evaporation rate (i.e., the towel is wetted but no water drips) or adjust it to your needs. In this way, if you use a large 2-liter Coke bottle, you don't need to refill the water for at least the whole day. Pros:

Anyone can save electricity (contribute to the construction of a conservation-oriented society), save money, and make materials simple;

The simplest is to take local materials, fill a ready-made pot with water, and use a stove to boil it in a room that needs to be humidified, so that the water vapor can drift into the air.

Drink more water and radishes, and add some broad beans to brew, and if you feel that the air is dry at night, your stomach is almost uncomfortable at this time, you can put a few gases with high water content and unique taste, I believe the effect is significant.

Help to you, please click on the praise Oh, thank you, pro

Just put the water in the stainless steel basin on the electric heater. (Give people roses, hands have fragrance, good luck, help you please give a good review).

Homemade humidifiers need to prepare: plastic bottles, towels, water, soldering iron.

1. First take out a plastic bottle for later use, as shown in the figure below.

2. Then pour an appropriate amount of water into the plastic bottle, as shown in the figure below.

<>4. Finally, the plastic bottle can be turned upside down on a towel, and the water can evaporate naturally, so that the homemade humidifier is completed.

Prepare materials: plastic bottles, water, soldering iron, cotton cloth.

1. First prepare a plastic bottle, and then pour an appropriate amount of water into it.

2. Close the lid of the plastic bottle, and then drill a hole in the middle of the lid with an electric soldering iron, taking care not to drill the hole too big.

3. Plug the hole of the plastic bottle with your fingers, and then put the plastic bottle upside down on the cotton cloth.

4. Done. <>

Method 1: 1. When making an air humidifier, you must first prepare a large beverage bottle, a thin needle, and an old plastic bowl.

2. Make a few small holes in the prepared fine needle on the beverage bottle, and the needle hole should not be too large.

3. Put the beverage bottle in the prepared plastic bowl, so that the bottom of the beverage bottle is close to the plastic bowl.

4. Inject an appropriate amount of water into the beverage bottle, and the filled water does not spray out, which means that the water is added successfully.

5. Put the lid on the beverage bottle, the water in the beverage bottle is slowly flowing out, and the plastic bowl is filled with water, which means that your air humidifier has been successfully made.

A detailed explanation of the method of homemade air humidifier.

Method 2: 1. Buy an atomizer in the market and connect the atomizer and transformer.

2. After that, put the atomizer in the tray filled with water, and the water in the tray must not pass the atomizer to avoid dry boiling.

3. After the atomizer is placed in the water, the water will be sprayed upward, and a plastic bracket is also placed in the packaging box of the atomizer, which is used to place the glass that can hold water above the humidifier. It prevents the humidifier from splashing during the humidification process.

Note: Using this method of self-made air humidifier, its movement is not very firm, which is easy to cause the phenomenon of the movement out of the water and the loose position of the movement connected between the power cords, and it is best to fix it at one time when fixing.

Ingredients: A large Coke bottle, a thin needle, and an old plastic bowl.

Method: Use the fine needle we prepared to prick a few holes on the Coke bottle, be careful not to prick the eyes too big, and then put the Coke bottle in a plastic bowl, and the bottom of the bottle is close to the plastic bowl. Fill the Coke bottle with a certain amount of water, and if the water does not squirt out, it is considered a success.

After that, put the lid on the plastic bottle. As long as the water in the bottle slowly flows out and the bowl has water, then your air humidifier is considered a success.

Boil the water to cool down, put it in the tin box, and throw the tin box on the heater. The size is your own. If you use a humidifier, remember to boil cooled water and wash it 1 per week. Please give a good review!

Just buy one, it's not expensive.

Step 1: Prepare an empty plastic bottle, a thin needle, and an empty container.

Step 2: Use a needle to prick 3 small holes at the bottom third of the plastic bottle, 1-2 cm apart.

Step 3: Fill the bottle with water.

Step 4: Tighten the bottle finish.

Step 5: Place the bottom of the drink bottle against the bowl and place it in the place where you need to humidify it at home.

Put a basin on the ground, fill it with water, and then blow it with a fan without stopping, which is basically the principle.

You can take the small watering can that you use to water the flowers, you can also humidify, and it's very easy to use.

The easiest way to make your own humidifier: use a Coke bottle.

This method is more suitable for use in the north, mainly using the heating in the north to evaporate the water in the cola bottle, thereby increasing the humidity in the air. This method is very simple and easy to use, by cutting out a large hole in the Coke bottle, filling it with water, and hanging the water-filled Coke bottle upside down with wire above the radiator.

In this way, it can ensure that the water evaporates into water vapor as the air temperature rises, so that the moisture in the air increases, and the dry air is relieved.

The role of the humidifier:

1. The main function of the humidifier is to increase the indoor humidity, so that the human body's physiology and thinking are in a good state, and the work and rest have better effects, and the healthy humidity can not only inhibit the breeding and spread of germs, but also improve immunity.

2. The weather is dry in winter, and I often feel dry mouth and sore throat when I get up in the morning, and I feel peeling and other symptoms, which are all caused by dry air, and dryness can also cause a lot of harm. Humidifiers are mainly to prevent these problems.

Summary. Coke bottle humidifier We need to prepare the materials: a large Coke bottle, a plastic bowl, a thin needle.

First, prick a few small holes in the cap of the Coke bottle with a needle, and then fill the Coke bottle with an appropriate amount of water, but the water should not be sprayed out of the Coke bottle. At this time, put the bottle into the prepared plastic bowl, pay attention to the Coke bottle should be close to the flat bottom of the plastic bowl, and then close the lid so that the bottle lies flat so that the water can flow out slowly. If the plastic bowl is filled with water, it means that your air humidifier has been successfully made.

Coke bottle humidifier We need to prepare the materials: a large Coke bottle, a plastic bowl, a thin needle. First, prick a few small holes in the cap of the Coke bottle with a needle, and then fill the Coke bottle with an appropriate amount of water, but the water should not be sprayed out of the Coke bottle.

At this time, put the bottle into the prepared plastic bowl, pay attention to the Coke bottle should be close to the plastic bowl to block the flat bottom, and then close the lid so that the bottle lies flat, so that the water slowly flows out. If the plastic bowl is filled with water, it means that your air humidifier has been successfully made.

You've done a great job! Can you elaborate on that?

I also made my own Coke humidifier, first rolling the god to sell the Coke bottle cap with a few small holes with a needle, and then fill the Coke bottle with an appropriate amount of water, but the water can not be sprayed out of the Coke bottle. At this time, put the bottle into the prepared plastic bowl, pay attention to the Coke bottle should be close to the flat bottom of the plastic bowl, and then close the lid so that the bottle lies flat so that the water can flow out slowly. If you fill a plastic bowl with water, you will have succeeded in making your air humidifier.

Hello, happy to stop by and answer your questions. 1.Prepare the materials:

Water pipes, air fans, buckets, plastic pipes. 2.Assemble:

Pull the hose out of the front opening part of the bottom of the bucket, then connect the plastic pipe to the fan blade, connect the other end to the water pipe, and finally connect the fan to the socket. 3.Use:

Fill the bucket with water, then turn on the air fan, the water pipe will spray water mist, and finally the water mist on the fan blades will follow the air flow, increasing the humidity in the air.