-
There is a special toilet cleaner available in supermarkets. Buy rust remover in the supermarket with vinegar and water, pour it into a container with scale, let it stand for a few seconds, and then clean the inside with a brush to remove the scale tiles and floor joints on all sides of the bathroom. At this point, it can be removed with smokeless hydrochloric acid.
Spray smokeless hydrochloric acid on the wall, joints and floor, after one minute, it can penetrate into the cement surface, begin to bubble, separate the wall cancer and cement, and then brush it with a brush for a while, rinse it with water, it can completely remove the scale and wall cancer on the tile, and the tile can also restore its luster as new. Smokeless hydrochloric acid is generally available in supermarkets, and a 500-gram can (slightly more than an aluminum can of Coke) is about NT$6 to 10, which is very cheap. Anthracite hydrochloric acid is corrosive, avoid direct contact when spraying and brushing**, empty cans should be immediately locked and discarded, if not used, the cap should be locked and placed out of reach of children.
In case it gets **, there will be a stinging sensation, immediately rinse with plenty of water to avoid harm, and absolutely avoid getting it to your eyes!
-
Go to the chemical store to buy a bottle of strawberry acid, to scrub it on the rust, and bring leather gloves so as not to hurt your hands
-
To clean up stubborn water stains and rust on the toilet floor, you need to be prepared: a mop, clean water, a basin of water, baking soda.
1. First prepare a basin of water, pour an appropriate amount of baking soda into the water, as shown in the figure below.
2. Stir the water in the basin to fully dissolve the baking soda, as shown in the figure below.
4. Then use a washed mop to mop the floor of the toilet, as shown in the figure below.
-
There are a few common ways to try:
To deal with rust spots, mix salt and vinegar together, stir, dilute the salt in vinegar, heat, dip the liquid with an absorbent sponge or rag, put it on the rust spots, and cover for more than 20 minutes. Then use a coarse cloth dipped in a salt and vinegar mixture and scrub vigorously to remove.
Vinegar foam: To remove limescale from bathtubs, walls and faucets, soak a rag in vinegar and leave it on top of the dirt overnight. The next morning, mix the baking soda and vinegar into a paste, then use a toothbrush dipped in the paste to scrub the area and clean it.
To deal with limescale in the bathtub, use white vinegar: mix it with water in a ratio of 1 to 5 and you will easily remove limescale. The scale in the faucet and other places is more stubborn, you can remove it and soak it in white vinegar for 20 minutes, and the scale will disappear.
For limescale in the pool, you can pour the leftover Coke into it and flush it after an hour.
Stains and limescale on the glass door of the bathroom can be easily removed with a small glass of white wine.
If hydrochloric acid can be found, dilute hydrochloric acid is the best effect, and dilute sulfuric acid can also be used.
Scrub with a high degree of white vinegar (do not dilute with water), you can also wipe it clean.
-
Prepare the salt and vinegar, mix the salt and vinegar together, stir so that the salt is fully diluted in the vinegar, and then heat; After heating, use an absorbent sponge or rag to saturate the liquid, then put it on the rusty area and cover it for 20 to 30 minutes.
Rubbing a rough cloth with a mixture of salt and vinegar and scrubbing vigorously will make it easy to remove stubborn rust.
-
Buy a bottle of Green Umbrella descaling solution.
-
How to remove water stains on the bathroom floor.
-
Mr. Vermeer with steel wool balls, must steel wool balls,
-
Generally, when removing rust from the toilet, the family will use toilet cleaner, only need to put a little toilet cleaner on the brush, and then brush the stains on the toilet bowl, which can be removed quickly. If the rust in the hall is more serious, you can pour the toilet cleaner into it, and then soak it for about half an hour, and the effect will be more obvious.
01 You can use vinegar, which is a high-wax acidic substance, which is not harmful to the human body, and can also effectively remove the dirt on the toilet. You only need to pour vinegar into it, and then use a brush to remove the dirt immediately, and the effect is obvious.
02 Baking soda can also effectively remove stains, pour baking soda directly on the stain, then let it stand for a period of time, and then scrub it with a brush, you can effectively remove the dirt on the surface and restore it to its original whiteness.
03 You can pour Coke into the toilet, and then use Coke to remove the stains, it is recommended to use gloves in advance, after pouring the Coke into it, the acid in the Coke will gradually decompose the stains, after pouring, let the Coke soak in the toilet for a period of time, soak it for one night as much as possible, and then rinse it with water.
04 There are also some people who may directly use decontamination powder, which will contain chemicals, and only need to pour it into the toilet, and then brush it vigorously to effectively remove the rust in the toilet, which is also a common operation at present.
-
The detailed steps to clean up toilet rust are as follows:
1. Toilet cleaning method: first soak the toilet bowl with water, then evenly drip the toilet bowl cleaner from the upper edge of the toilet, soak for about 10 minutes, then scrub with a brush, and then rinse with water.
2. Vinegar cleaning method: Mix vinegar and water in a ratio of 10:1 and pour it into the toilet. Soak for 3-5 hours, and then drop the soil with one brush. After flushing the toilet, spray white vinegar on the inside of the toilet bowl and flush the toilet together next time to disinfect and deodorize.
3. Baking soda cleaning method: Sprinkle an appropriate amount of baking soda in the toilet, soak it in hot water for half an hour, and then use the toilet brush to remove the dirt.
4. Shampoo cleaning method: If you are worried about the safety hazards of toilet bowl cleaner, you can use shampoo to clean the toilet. In this way, children can sit on the toilet without feeling the smell.
5. Coke method: Coke contains a kind of citric acid, which is poured into the toilet. After soaking for about an hour, the dirt can be removed by brushing the toilet.
6. Detergent cleaning method: first put an appropriate amount of water into the toilet, rinse it with the toilet, then pour in 5-10 ml of detergent, apply it evenly with a brush, and then rinse it to achieve the cleaning effect.
-
Here'<> how to remove rust from the toilet bowl:
Use vinegar and soda: Pour an appropriate amount of vinegar into the toilet, pour in some more soda, and then gently brush the surface of the toilet bowl with a toilet brush to allow the vinegar and baking soda to react on the surface of the toilet bowl and remove rust. It should be noted that if there is detergent residue on the toilet, do not mix it with vinegar to avoid harmful gases.
Use citric acid: Pour an appropriate amount of citric acid into the toilet bowl, let it sit for a while, and then gently brush the surface of the toilet bowl with a toilet brush to remove rust. Citric acid has a good rust removal effect, but you need to pay attention to eye protection and ** when using it.
Use laundry detergent: You can put an appropriate amount of laundry detergent into the toilet, let it stand for a while, and then gently brush the surface of the toilet bowl with a toilet brush to remove the rust. It should be noted that when using laundry detergent, it is necessary to control the amount of use to avoid damage to the toilet.
Use toilet bowl cleaners: There are some specialized toilet bowl cleaners on the market that can remove rust from the surface of the toilet bowl. Follow the instructions when using to avoid damage to the toilet.
It should be noted that it is important to pay attention to safety when removing toilet rust to avoid chemical damage to ** and eyes. At the same time, when using detergents, follow the instructions to avoid damage to the toilet.
How can the bathroom be non-slip?
The slope of the bathroom is a problem that needs to be paid attention to at the beginning, the best way is to rework, of course, it is recommended to do a little more if you can't rework now, and the following are a few treatment measures. >>>More
How to quickly clean the water on the floor after showering in the bathroom? Any tips? >>>More
If there is water seeping at the bottom of the toilet toilet, check whether it is a leak in the toilet flush, or a leak caused by a blockage under the toilet, or the toilet is permanently loose, or the toilet is not installed properly and there are gaps, or it is caused by uneven floors, etc. >>>More
It can be used, but you need to make a caulk first, and now there is a kind of Nano Ceramic Clay material of Chengbang, which is even better than the effect of the beautiful sewing agent! Waterproof performance and aesthetics are classy! Many hardcover families use this kind of home.