-
1. Hair dryer de-icing.
If the refrigerator has a thick layer of ice, it can be solved with a hair dryer, and the effect is very good. First cut off the power of the refrigerator, then turn on the power of the hair dryer, use it to blow the thick part of the ice, and wait for all the ice inside to melt by the hot air, and then clean the inside of the refrigerator to be used normally. Also, when using a hair dryer to melt the ice, you can put a highly absorbent rag at the bottom of the refrigerator so that the water doesn't get everywhere.
2. Hot water de-icing.
For refrigerators with too thick ice, there are also many people who use hot water to de-ice. This method is not only simple but also very convenient, but before removing the ice, you must cut off the power of the refrigerator and empty its contents. Then put a few bowls of hot water in it, close the refrigerator door, wait for about half an hour to open it, then you can see the ice cubes falling off inside, just clean it up.
-
To de-ice, first disconnect the power of the refrigerator and take out the food in the box; Then, depending on the size of the freezer, put one or two aluminum lunch boxes with boiling water and put them in the freezer; After a few minutes, the frost on the wall of the freezer begins to fall off in one piece (for those that have not yet fallen off, you can use your hand to pull it off). If there is no metal evaporation plate on the top of the freezer, the lunch box containing boiling water should be covered to prevent the plastic inner wall from deforming due to the sudden increase in temperature at low temperatures. With this method, it is much less time-consuming than heating and defrosting on its own in a power outage.
Be careful not to hit the frost layer with a wooden rod or metal device to prevent accidental hitting the ring evaporator and causing unnecessary trouble.
-
When it is necessary to defrost (de-ice) the refrigerator, first cut off the power of the refrigerator, and then use an electric fan or hair dryer to open the freezer to the maximum, after the wind blows, the frost layer will melt very quickly, so that it is easier to remove again. The refrigerator is used for a week or half a month, it is best to turn off the power and open the refrigerator door, and wait for the ice to melt before turning on the power, which will be better.
-
If the ice is thick, it should be de-iced in time, first cut off the power supply, then open the freezer door, take out the food, and clean it up after it melts naturally. It can also be cleaned with special cleaning tools, but not with metal products to avoid damaging the pipeline, or you can add a glass of boiling water to speed up the melting speed.
-
After the power is off, soak it in a soft cloth and wipe it again, then use dish soap and vinegar to add warm water to make half a basin, soak a soft cloth and clean one side, and finally scrub it with a clean soft cloth two or three times until there is no dish soap; In addition, the plastic frame of those doors is removed and soaked in homemade warm water to soak and scrub, and the stain is easier to remove.
-
Turn off the power before cleaning, then boil a pot of hot water and prepare a hair dryer, take out all kinds of drawers, pour hot water into the plate and put it into each compartment of the freezer, you will hear the sound of the ice melting in the freezer room during the cleaning process of the refrigerator, here you use a hair dryer to blow, the ice is easier to fall, pay attention to the lower layer of a towel to absorb water.
-
It is the drainage outlet of the refrigerator room that is blocked, resulting in poor drainage, too much water in the box leads to freezing, you need to check it first, there is a drainage hole in the middle and lower middle of the back wall of the refrigerator, if it is blocked, you can use a soft wire barrel to open it, and the drainage should be good.
-
Before putting in the frozen food, the wall of the freezer is covered with a plastic film, which is easily applied quickly with the help of the cold air in the freezer, and then the food is frozen. When it is necessary to defrost, quickly move the frozen food into the refrigerator for temporary storage, as long as the plastic film in the freezer is removed, the frost will be removed quickly, and then the shaken film is applied to continue to freeze the food. It takes time before and after.
One or two minutes, very time-saving, trouble-saving, and power-saving.
-
After each defrosting (de-icing) of the refrigerator, wipe the freezer with a towel, and then apply a layer of vegetable oil to the inner wall around it, and when the next frost is formed, the suction between the frost and the refrigerator wall is greatly reduced due to the attachment to the refrigerator wall containing oil, so it is easy to peel off the lumps without much effort.
-
If the temperature of the refrigerator is set too low, and the melted water cannot be discharged during the normal shutdown of the refrigerator to cause freezing, you can check that there is a drainage hole in the back wall of the refrigerator refrigerator, and the melted water can be discharged from here during normal shutdown.
-
In case the stains that can't be wiped off with dish soap, you can use a damp cloth dipped in some oil to wipe them clean, the effect is very good, and you can ensure that you can wipe it off.
-
Here's how to clean up thick ice in your refrigerator:
1. Blow the defrost into the refrigerator with a small electric fan to open the door, let the ice melt and fall naturally, and do not use external force to knock and shovel the ice.
2. Place a large cup (bowl) of hot water on the shelf, close the freezer door back for 1-2 hours, see if the ice has melted, and finally use the matching ice shovel to clear the ice.
3. You can also use a hair dryer hot air stall to blow back and forth (you must not stay in a certain place for a long time), the ice melts faster, but it is more laborious.
4. After cleaning the refrigerator, you can apply a layer of vegetable oil to the inner wall of the refrigerator, so that it will be much easier to clean the refrigerator next time.
-
The methods to quickly remove thick ice from the refrigerator are: refrigerator temperature adjustment, disconnecting the power supply, hair dryer, manual defrosting, and using a de-icing shovel.
1. Ice search box temperature adjustment.
Turn down the temperature of the freezer compartment of the refrigerator and the thick ice in the freezer will melt automatically after about 2-3 hours. Then apply cooking oil to the inside of the freezer compartment of the refrigerator, and there will be no frost in the freezer compartment of the refrigerator in the future.
2. Disconnect the power supply.
You can disconnect the power of the refrigerator and take out the food in the refrigerator and put an aluminum lunch box with two hot water in the freezer compartment of the refrigerator. Wait a few minutes and you're good to go.
3. Hair dryer blowing.
When defrosting the refrigerator, we should first cut off the power supply, and we can use a hair dryer or an electric fan to blow the refrigerator freezer. After blowing the air on a large setting, the frost in the refrigerator will melt quickly, saving time and effort.
4. Artificial defrosting.
According to the size of the refrigerator, you can do this according to the size of the refrigerator, and stick a thicker plastic film to the inner wall of the freezer compartment of the refrigerator. After removing the food from the refrigerator and shaking the plastic film attached to the freezer compartment of the refrigerator, the frost will automatically fall off.
5. Use a de-icing shovel.
De-icing shovel Many refrigerators have pants leaky acre, which is mainly used for de-icing, but it can also be used to defrost. Usually, the frost is not very hard, shovel it with an ice shovel and it will come off. However, it is physically demanding.
1. Hot towel compress.
Hot towels are a relatively easy way to apply ice, and you can use warm wipes to wipe the inside of the refrigerator to accelerate the melting of ice cubes, but because the temperature is low, remember to wear gloves when de-icing. >>>More
1. Hair dryer de-icing.
If the refrigerator has a thick layer of ice, it can be solved with a hair dryer, and the effect is very good. First cut off the power of the refrigerator, then turn on the power of the hair dryer, use it to blow the thick part of the ice, and wait for all the ice inside to melt by the hot air, and then clean the inside of the refrigerator to be used normally. Also, when using a hair dryer to melt the ice, you can put a highly absorbent rag at the bottom of the refrigerator so that the water doesn't get everywhere. >>>More
How to de-ice your refrigerator.
Method Step 1: >>>More
Direct cooling refrigerator freezer defrosting method:
First of all, temporarily put the food in the freezer drawer into the refrigerator or insulated box, take out the drawer, clean it, dry it and let it cool. >>>More
First, disconnect the power of the refrigerator and take out the food in the box. Then, depending on the size of the freezer, put one or two aluminum lunch boxes with boiling water and put them in the freezer; After a few minutes, the frost on the wall of the freezer begins to fall off in one piece (for those that have not yet fallen off, you can use your hand to pull it off). If there is no metal evaporation plate on the top of the freezer, the lunch box containing boiling water should be covered to prevent the plastic inner wall from deforming due to the sudden increase in temperature at low temperatures. With this method, it is much less time-consuming than heating and defrosting on its own in a power outage. >>>More