How to make good use of the drainage hole of the refrigerator so that there is no freezing and no fr

I've been talking to you about the way to deal with frosting, but it's used in refrigerators that frost often, and this sudden frosting may require other attention.

Generally speaking, the habit of using the refrigerator will not change, such as the food and vegetables that are placed, which will actually affect the frost very little in a short time, so it is necessary to find other problems.

First of all, pay attention to the drain outlet, the small round hole at the bottom of the refrigerator is the drain hole, in order to drain the stagnant water, and then slowly evaporate the water, but with use, this pipe may freeze because the temperature is too low, of course, it may also be because the food falls into it and clogs it, so you need to try to get through.

First prepare a slender wire, and then slowly extend into the drainage hole, if you feel the block, gently poke a few times, not too hard, so as not to poke the whole pipe off, if it is very hard and very firm, it is likely that there is ice, you need to take out the wire, pour a little warm water into it to melt the ice, if the wire goes down unimpeded, it is likely that there is no problem here.

If the drain pipe is fine, then you need to pay attention to the sealing gasket on the door, there is a magnet inside this mat, which can play a role in closing the door tightly and avoiding hot air from entering the refrigerator, but with the use, this rubber mat will become hard, and there will be some deformation, at this time, the sealing effect will be greatly affected, and the hot air will go in, and it will naturally be prone to big frost, so you should prepare a few notes, and then clip them in a few places in the door and refrigerator, and then gently pull out the note, If you feel that it can't be pumped or it is relatively tight, it means that the seal is good, and if it is easy to pull out, it means that the sealing strip in this position may have been deformed.

If the deformation of a small area of rubber mat can be restored to its original state after being blown soft with a hair dryer, if it is a large area of deformation, it is recommended to replace it with a new one, because even if you use a hair dryer, it may not last long. Or will it continue to deform.

Then you should also pay attention to the temperature, whether the temperature is adjusted too low, because some knobs adjust the temperature, usually do not pay attention when placing things, it is likely to push the knob to change the temperature, and when the temperature is too low, it will freeze.

First of all, pay attention to the drain outlet, the small round hole at the bottom of the refrigerator room is the drain hole, this pipe may freeze because the temperature is too low, of course, it may also be because the food has blocked it, so you need to try to get through.

As far as I know, the refrigerator freezes, and the reason for the frost is because the stagnant water in the refrigerator is not cleaned for a long time, and it is attached to the refrigerator before it forms ice, so it is recommended to clean the refrigerator regularly every week and drain the excess water inside with drainage holes, so as to avoid freezing and frosting.

Clean it regularly, use a straw or chopsticks, and if you don't block the drain hole after pouring hot water, it will not freeze or frost.

In the process of using a household refrigerator, if it is not used properly, then there is a possibility of ice formation. If the fridge leak freezes, it may be due to a blockage.

1. If the freeze in the refrigerator drain hole is caused by blockage, then de-icing can solve it after solving the blockage.

2. If the fruit is frozen due to insufficient foaming, first unplug the power supply of the refrigerator, find a thicker copper core wire, insert one end into the drainage hole, and wrap it around the high-pressure pipe at the other end, so that the temperature of the high-pressure pipe can be transmitted to the drainage hole, and the freezing is solved.

1. There is stagnant water inside the refrigerator, and the water is not drained in time. This phenomenon usually appears on the bottom plate of the refrigerator crisper. And the temperature in this position is very low, which causes the water outlet hole of the refrigerator to freeze, and after a long time, the drainage hole is blocked.

2. It may be that the temperature in our refrigerator is set too low. For example, if we set the temperature setting to the maximum in the summer, then the temperature will be very low. In this case, the inside of the refrigerator will freeze if there is not a small amount of water.

In particular, the location of the drain of our refrigerator is the lowest, so it is more likely to freeze.

3. The blockage of the drainage hole causes the water to flow out and the early high finger freezes. In other words, there is a blockage inside our drain hole itself. For example, the residue of food in the refrigerator enters the discharge hole, which makes it impossible to drain the water in time.

This can lead to freezing over time, which can lead to the drainage being blocked.

1. The temperature of the refrigerator is adjusted too low, causing the drainage hole to freeze. Solution: Turn up the temperature in the refrigerator compartment.

2. Insufficient foaming of the insulation material at the drainage hole of the refrigerator leads to freezing. Solution: Find a thicker copper core wire or aluminum core wire, peel off the skin at both ends, insert one end of the wire from the drainage hole above the compressor to the drainage hole of the refrigerator room, and tightly wrap the other end on the high-pressure pipe on the right side of the compressor for about 10 turns, so that the water box can be installed and taken out normally.

In this way, the wire conducts the temperature of the high-pressure pipe to the drain hole of the refrigerator room, and it does not freeze.

Cleaning and maintenance: Check the drain pipes. If the drain is clogged, the water will leak into the refrigerator.

Poke the drain pipe with wire to remove the build-up on the drain. Do not neglect to clean the door seal, dilute the bleach with 10 times the water, moisten it with a toothbrush, and finally rinse the bleach with water. The rubber strip is dirty and easy to age, which will affect the sealing of the refrigerator and increase power consumption.

Check vibration, noise, and compressor temperature. When touching the compressor shell during operation, there should be no obvious vibration, and the sound of the compressor starting should not be heard during the day. Pay attention to check whether there are cracks in the power cord to prevent leakage.

Wash and dry the inside and outside of the refrigerator with warm water or mild detergent, and leave the refrigerator door open to air and dry for a day.

1.This situation is likely to be due to the high humidity of the air, so the temperature of the evaporator in the refrigerator is relatively low, which will lead to excessive condensation, resulting in the problem that the drainage holes of the refrigerator are not blocked and frozen. 2.

When the temperature of the refrigerator drops, the ice on the back wall will melt into water and flow out through the drain holes. 3.When the sealing of the refrigerator is not particularly good, it may lead to the refrigerator not being closed tightly, and in this case, there will be the problem that the refrigerator drain Sun Xinkong is not blocked and the old ice is frozen.

It could be ice formation caused by a clogged drain hole. You can take out the food in the refrigerator first and let the refrigerator sit for an hour. If the ice doesn't melt, you can inject warm water into the drain hole to make it melt faster.

After the ice melts, use a professional dredge refrigerator, and poke the pipe of the drainage hole down from the top of the drainage hole, and then you can dredge the refrigerator drainage hole.

The precautions for using the refrigerator are: 1. When placing the refrigerator, it is necessary to stay away from the open flame, otherwise it is easy to happen, and it is best not to put microwave ovens, rice cookers and other electrical appliances around, because these electrical appliances will produce magnetic induction, and the refrigeration system will be disturbed in the process of use, and in serious cases, the thermostat will be damaged. X000B 2. Avoid placing carbonated beverages in the freezer compartment of the refrigerator, as these liquids may pose a danger after being placed in the freezer.

3. Regularly maintain and maintain the refrigerator, especially the inspection of the line, as long as the refrigerator is found to be faulty, it should be overhauled, such as the common problem of freezing of the refrigerator drainage hole. 4. If the refrigerator is not refrigerated or the sound is relatively loud, we must pay attention to it, contact professional maintenance personnel in time to check it, and deal with the problem as soon as possible, so as not to affect the normal use.

1. Causes of blockage of refrigerator drain holes:

The temperature of the refrigerator is too low, because the temperature of the refrigerator is too low or the thermostat is faulty, the compressor has been working, resulting in the temperature of the refrigerator is getting lower and lower, because the drainage hole is connected with the outside world, so there will be condensate at the drain outlet, when the temperature of the refrigerator is below 0 degrees, the condensate will freeze in the drain hole, and eventually block the drain outlet.

Second, the method of removing ice cubes from drainage holes:

First unplug the refrigerator, open the refrigerator door to take out the food inside, let the ice slowly melt in the natural environment, find a wire to poke down from the drain, and pour some warm water from the drain hole to help melt the ice. Until all the ice in the drain hole has melted and drained.

How to solve the problem that the refrigerator drain hole often freezes? The reason for the freezing of the refrigerator is that after the temperature of the refrigerator drops, the ice on the back wall of the refrigerator will melt into water and flow out through the drainage hole. However, if the drainage hole of the ice silver box is blocked or the setting mode is incorrect, the water flow is not smooth or the ice is not completely melted, and the refrigerator freezes in the refrigerator.

Poor closure of the refrigerator leads to condensation of water vapor in the air. I hope I can help you! If my answer is helpful to you, please give a thumbs up (comment in the lower left corner), look forward to your like, your efforts are very important to me, your support is also the motivation for my progress, and finally I wish you good health and a happy mood!