Why do two people need to work at the same time, and can one person do it?

Most epoxy sealants on the market.

The construction can be done by one master, while the quick seams are done by two people at the same time. Some owners can't help but wonder if this is necessary? Today, I'm going to tell you why you need two people to build.

<> is a pure polyurea, unlike most seams on the market.

The joint agent product is a high-performance joint agent product produced by him with asparta polyurea resin as raw material, the performance of this product is significantly better than the traditional epoxy joint agent in all aspects, especially the yellowing resistance, it is directly killed, and the curing speed of polyurea beauty joint is very fast, it can be completely cured within two hours in summer, and it can be cured for about three to four hours even if the temperature is relatively low in winter, which greatly improves the construction efficiency of beautiful joints.

We did a comparative experiment and applied Mr. Speed joints and normal sealant on two tiles, without pressing, and after an hour, the epoxy sealant could still be easily pressed. The gentleman is basically solidified and there is little pressure to put on it. Therefore, in the daily construction process, the master will adopt the construction mode of two people, one person glue, and one person to press the seam to avoid the problem of poor joint pressing effect caused by too fast maintenance speed.

So if you also choose to make polyurea sealant, the two masters are more reliable. Many American sewing workers have this habit when working with materials and seams: one person is working and they are using the materials and seams themselves.

In order to improve the efficiency of construction, they usually start pressing seams after completing a piece of American sewing machine. This habit is good, but it doesn't work with polyurea fittings. It takes a certain amount of time to finish a beautiful seam material, which is not enough to cure a normal epoxy beautiful seam and has no effect on the subsequent pressure seams.

But at this time, the seam surface of the champion master polyurea can start to cure, the seam begins to solidify, and then it is difficult to press the seam, even if the press is successful, the seam surface is not smooth.

The correct construction method is to construct two people at the same time, one person to lay the material, and one person to press the joint. If you're building with only one person, it's better to divide the material into areas and press the seams than because it's a hassle to finish the material and press the seams. If you have never used a polyurea fitting construction before, it is recommended to replace the polyurea fitting.

Some common epoxy joint construction habits are not suitable for polyurea joints. At the same time, it is also recommended that the owner should not easily try to use polyurea joint construction to avoid joint flipping.

Personally, I think one person can't do it, which has a certain impact on the overall aesthetic quality, two people at the same time, which is more beneficial to the United States, and the beauty of the sewing is also better.

It is because this work is more complicated, and it is more efficient, so it requires two people to work at the same time, and one person can also do it.

This is because it is faster for two people to work at the same time, and it is possible for one person, but the speed is very slow.

The construction of polyurea seams is not good, it has been two or three years ago. Polyurea is divided into pure polyurea and hemipolyurea, and hemiurea can not be pressed for about 15 minutes. The sewing of Xiaobai pure polyurea is the first in the industry to break through the free seam within 30, and completely solve the pain point of poor construction of polyurea joint.

One person is enough.