How to start the third subject wrong, start the third subject, always do not do well, what should I

Subject 3 Explanation, Mistakes and Correction Methods at the Beginning, Coach: Have You Mastered It?

Subject 3: Always turn off at the beginning? Come in and learn!

To tell you an easy way: Clutch stomp to death, then hang up the first gear and give the foot an empty throttle. Then the clutch slowly lifts up half of the clutch and then slowly lifts it to the throttle, the speedometer to 10 miles to step on the clutch Shift two, I basically start driving with one foot clutch Other gear shifts do not need to step on the clutch, and you will know later.

1. Cut off the clutch: Press the clutch pedal to the end with your left foot to completely separate the clutch. If the clutch pedal is not pressed to the end, the clutch can not be completely separated, and the power output of the engine is semi-linked with the transmission.

2. Transmission into gear: put the transmission shift lever into the starting gear (first or second gear), if the first shift is not smooth, you can pull the shift lever back to the neutral position, and then carry out the second shift until it is successfully completed.

3. Turn the left turn signal and honk the horn with the right hand.

4. Relax the hand brake lever: first pull the hand brake lever up a little to release the safety lock, and then push the manual brake lever forward and downward, all the way to the end, so that the brake is completely relaxed. At this time, it is necessary to observe the indication of the hand brake indicator on the instrument panel, if the indicator light is on, the hand brake is not completely relaxed, and the hand brake lever should be pushed forward further until the hand brake indicator is off.

If the manual brake is not fully relaxed, it will produce brake lag, so that the car can not start smoothly, that is, it can barely start, and the speed can not be increased due to the delay of the manual brake during driving, and the manual brake will also be damaged.

5. Observe the surrounding situation of the car: Before the car starts, you must observe the surrounding situation to further determine whether it is safe. The front of the car can be observed from the front window, which is clear at a glance, and the side and rear of the car can be observed through the rearview mirror, or the window glass can be lowered to stick your head out of the window.

6. Try to step on the throttle (throttle) pedal: continue to press the clutch pedal with your left foot to maintain the clutch disengagement. Press the accelerator pedal with the right toe, and pay attention to the change of the engine running sound, after the accelerator pedal is pressed, the engine speed should rise accordingly, verify that the accelerator pedal control can be gradually lifted up until the clutch pedal free travel is completely eliminated, the car is slightly shaky, proving that the clutch begins to engage, at this time I want to press the accelerator pedal down, and then, the left and right feet move in opposite directions, the left foot continues to slowly relax the clutch pedal upwards, and the right foot cooperates with the slow downward pedal pedal, and the action should be slowIt should not be too hasty to prevent the car from shaking at start.

7. Treatment after starting: After the car starts steadily, the left foot should be moved down from the clutch pedal to make the clutch pedal completely relaxed, and do not idle the foot on the clutch pedal, because the left foot sometimes involuntarily slightly downward force, it is easy to cause the clutch semi-linkage, and in the long run, the clutch friction plate will soon be worn out.

If you can't pass the test, you can continue to train in order to fight again. In a sense, driving a motor vehicle is a journeyman. Learn more and practice more to succeed.

If you can't pass any of the subjects, you can't continue to the next subject, and I'm really helping you look forward to it

Maybe it was because after the second exam, it took too long to get into the third subject, and I forgot how to start. Especially, after the coach taught the start of subject three, for a while, I completely forgot about it, and I didn't even know when to step on the clutch and when to loosen it.

The first time I practiced driving, I started to turn off the engine several times on the road, and turned off the engine, which made me doubt my life. The more you go wrong, the more you panic, the more you panic, the more you make mistakes. I'm starting to question what they say, it's easier to have three than two. Could it be that I don't have the comprehension of subject 2 when I practice the third subject?

Start: Start in first gear.

Manner. First, the old driver starts: when the clutch is loosened by one-third, release the brake, put the accelerator, wait 2 seconds when the clutch is lifted to the semi-clutch, refuel, step on the clutch to change 2 gears, accelerate, wait 5 seconds, step on the clutch to change 3 gears.

Manner. 2. Start on flat ground: release the brake directly and lift the clutch slowly.

Manner. 3. Ramp start: step on the brakes, slowly lift the clutch to the semi-clutch state for 2 seconds, slowly release the brakes, and then continue to slowly lift the clutch.

Method 2 is mainly used in Method 2, Method 3 is an examination item in Subject 2, and Method 3 is newly learned in Section 3. When practicing on the road in the third section, choose the second and third methods according to the road conditions. If the first method is mastered well, the third purpose of the subject can also be used.

After finishing it, my thinking is much clearer, and I don't feel so panicked. I hope I can perform better next time I go to practice.

The third branch needs to step on the merge and hang a gear.

1. Observe road traffic conditions. Observe through the left and right rearview mirrors to see if there are any vehicles or pedestrians coming from the left and right lanes, and turn your head back to observe whether there are vehicles to ensure road traffic safety.

2. Turn the left turn signal and press the horn. We need to get into the left lane to start, so we need to put on the left turn signal, and in order to alert the vehicles behind me, I am about to start, and I press the horn to warn.

3. Step away from merging and hang a gear. Hang up the first gear to start, remember to start in one gear every time you start, because the strength of the first gear is relatively large, you can drive the car up, every time you need to step on the clutch, you can't hang up if you don't step on the clutch.

4. Release the handbrake. Although this action is simple, many people will forget, especially when they are nervous, it is easy to forget to let go of the handbrake.

5. Observe the road traffic conditions again. After ensuring safety, slowly release the clutch and start semi-linkage.

6. After the start is completed, remember the scoring criteria: After the start is completed, you can start to drive according to the prescribed test route. It is best to memorize the scoring criteria, deeply imprinted in your mind, even if you can't memorize them, it is good to read them several times to have an impression.

Section 3 Steps to get on the bus:

1. Go around the car counterclockwise before getting on the car, pass through the right rear and left front of the car, observe the surrounding car conditions, and get on the car after no problem.

2. Get into the car from the driver's seat, open the door half-way first, and turn back to observe the rear car condition.

3. After getting into the car, first adjust the height and distance of the seat according to the usual driving habits, adjust the left and right rearview mirrors and ** rearview mirrors, and then fasten the seat belt.

4. Insert the key to ignite and start the vehicle, step on the clutch and brake to the end with the left and right feet respectively, release the handbrake, hang a gear on the right hand, hit the left turn signal, honk the horn, look back to observe the rear car condition, confirm the safety, slowly release the clutch and brake to start slowly, and release the clutch and brake after the vehicle travels a certain distance.

Here are the steps to get started in Subject 3:

1.When you hear "Please start", press the pedal with your left foot and hang in first gear.

2.Turn the left turn signal, hold it for more than 3 seconds, look in the left rearview mirror, and sound the horn after confirming safety.

The following are the precautions for getting started in subject 3:

2.Remember not to slip, if you slip more than 30 cm during the exam, you must fail.

3.Before letting go of the handbrake, observe the road ahead, and if it is uphill or downhill, press the brake with your right foot and release the clutch slowly.

4.When the body starts to shake violently, the left foot holds the clutch pedal still, the right foot slowly releases the brake, and when the car moves, release the brake completely.

Subject 3: Start with attention.

2. You must remember not to slip, if you slip more than 30 centimeters during the exam, you must have failed. So before letting go of the handbrake, it is best to observe the road conditions ahead, if it is uphill or downhill, it is best to step on the brake with the right foot, slowly release the clutch, when the body begins to shake more violently, the left foot stabilizes the clutch pedal and does not move, the right foot slowly releases the brake, when the car moves, and then completely release the brake.

Or postpone the handbrake, put the right hand on the handbrake when starting, gently lift the clutch with the left foot, slightly add some oil to the right foot, and gently lift the clutch with the left foot to the semi-linkage state, keep the clutch still, and then make up some oil a little, and then immediately release the handbrake.

The starting steps for Subject 3 are as follows:

1. Before starting, the test requires you to hit the left turn signal, and then start normally after observing whether there is a vehicle passing through the rearview mirror;

2. Gently lift the clutch to the semi-linkage point, and then hold still, when the car is moving forward, you can slowly release the clutch and start lightly on the accelerator;

3. Shifting gears is not difficult to master, the timing of shifting gears is different for each car, and it is necessary to shift gears according to the specific situation, that is, speed and road conditions. The starting steps for Subject 3 are as follows:

1. Before starting, the test requires you to hit the left turn signal, and then start normally after observing whether there is a vehicle passing through the rearview mirror;

2. Gently lift the clutch to the semi-linkage point, and then hold still, when the car is moving forward, you can slowly release the clutch and start lightly on the accelerator;

3. Shifting gears is not difficult to master, the timing of shifting gears is different for each car, and it is necessary to shift gears according to the specific situation, that is, speed and road conditions.

In this different place, different coaches may not necessarily say the same.

The mantra we taught at the time was (at the end of the roundabout, after getting in the car, adjusting the seats, mirrors, and fastening the seat belt).

Pedal (brakes and clutch).

Hang (hang a gear).

Hit (left direction light).

Release (handbrake) press (horn).

Confirm safety, and start in a semi-linkage state.

After hanging the first gear, step on the clutch with your left foot, and then slowly lift the clutch until the body walks, and then add a little throttle to the right foot and the car starts!