Should I apply the brakes at the beginning of subject 3, or just step on the clutch?

If you start on an uphill road, you have to keep stepping on the brakes until the clutch is released to the semi-linkage when the front of the car is tilted upward, then release the brakes, lightly step on the accelerator, and the car will go.

If you start on flat ground, you don't need to apply the brakes, the car moves and prepares the brakes, and then apply the brakes when there is a situation (such as a car or pedestrian in front of you who needs to adjust the speed and need to stop). You won't slip when you start on flat ground.

The content and passing standards of the examination subjects are unified across the country, and the order of the examination is according to the subjects.

1. Subjects. 2. Subjects.

3. Subject 4 will be carried out in turn, and only after passing the examination of the previous subject will you be allowed to participate in the examination of the latter subject, and the examination subjects are divided into:

Subject 1: Road traffic safety laws, regulations and related knowledge test subjects, the structure and basic question types of the test question bank are formulated by the Ministry of Public Security, and the traffic management department of the provincial public security organ shall establish the test question bank of the province (autonomous region and municipality directly under the Central Government) in combination with the actual local situation.

Subject 2: Field driving skills test subjects, the test items include: reversing into the garage, ramp fixed-point parking and starting, right-angle turning, curve driving, side parking.

Shanghai and other cities have nine compulsory subjects in the second subject: reversing into the garage, right-angle turning, side parking, tunnel driving, parking and card pick-up, curve driving, narrow road U-turn, emergency stop, ramp fixed-point parking and starting.

Subject 3: Road driving skills test subjects, the basic items of the test include: preparation for getting on the bus (go around the car counterclockwise, wear a seat belt when getting on the car, turn on the left turn signal, put the gear, release the handbrake, honk) start, drive in a straight line, change lanes, pass the intersection, pull over, pass the crosswalk line, pass the school area, pass the bus stop, meet the car, overtake, make a U-turn, and drive at night.

Eligibility Criteria. 1) Traffic Laws and Related Knowledge (Subject 1) - Written test, 100 test questions, 100 points out of 100, 90 points or more for passing (including 90 points).

2) Field Driving (Subject 2) - On-site, Real Vehicle. Only pass and fail are divided. Reversing into the garage, side parking, S bend, right-angle turn, ramp fixed-point start and stop, these five items must be tested and carried out in turn.

100 points out of 100 points, 80 points or more for qualified (including 80 points) for large buses, medium-sized buses, large trucks 90 points or more for qualified (including 90 points).

3) Road Driving (Module 3) – Highway or Simulated Field, Real Vehicle. A score of 100 is out of 100, and a score of 90 or more is considered a pass (including 90 points).

4) Safe and civilized driving related knowledge (subject 4) - written test, 50 test questions, 100 points full score, more than 90 points for passing (including 90 points).

The new student Ke 3 will not step on the clutch, should he brake or clutch first? You'll know after reading it.

OK. Kesan can start without stepping on the brakes and directly lift the clutch slowly. Immediately lift the clutch slowly, which can easily cause the vehicle to slip backwards.

Stepping on the brake pedal development is to prevent your vehicle from slipping backwards or rushing forward, you don't want to step on the brake pedal to develop, but you are worried that the car will stop the fire, after all, the novice is very bad for the clutch work ability, but remember to be forced to step on the brake pedal to develop.

If you start on an uphill road, you have to keep pressing the brakes until the clutch is loose to the semi-linkage, and then keep the clutch when the front of the car is tilted upward, and then release the brakes, lightly press the accelerator, and the car will walk up and will not slip.

Subject 3 Skills:

1. Pay attention to the process when preparing for the car, first report to the examiner, and then request a car inspection, and then pay attention to the action, because there may be a camera, if the action is not in place, you may be directly judged to be unqualified, so pay attention to the action in place, and get on the car at the end of the inspection.

2. When starting, follow the light gear brake smoothly, so that you will not forget the smooth, slightly lift the clutch when starting, and prevent the motor vehicle from turning off directly, so remember to lift it slightly, and then hang a gear, and start smoothly.

3. When passing through the crosswalk, bus stop, or school area, pay attention to deceleration and downshift in advance, and then bring three to five seconds of braking when you get to the place you say, and then add some throttle to continue to complete the next test.

To apply the brakes.

The throttle and clutch cooperation are required for starting. Before starting, the clutch is stepped on, and it is still necessary to lift the clutch slowly, and feel the semi-linkage of the engine.

State. When the semi-linkage state is reached, don't panic and release it all first, and then release the clutch when you are sure that the vehicle can move forward. Then you can step on the accelerator and accelerate. When stepping on the accelerator, remember to press lightly, because this is the gear.

Still in first gear, be careful not to mismatch the gear speed.

Decelerate. When crossing a pedestrian crossing or passing through a school area, the accelerator and brake are required. In order to prevent the vehicle from stalling when braking too hard, you can accelerate appropriately before reaching the designated area, release the accelerator pedal and gently press the brake when you reach the designated area, and adjust the speed by stepping on the accelerator after passing the designated area.

Together, step on the accelerator again to accelerate.

When downshifting, the clutch and throttle are required. Before downshifting, release the accelerator, press the clutch and then shift, then lift the clutch and lightly press the accelerator to keep the vehicle moving at a constant speed.

Subject 3: Don't step on the clutch when you step on the brake, start and step on the clutch, hit the left turn signal, honk the horn, hang the first gear, and release the handbrake.

Slow stage clutch.

When the car moves, prepare the brakes, and then apply the brakes when there is a car or pedestrian in front of you who needs to adjust the speed and need to stop. You won't slip when you start on flat ground.

Subject 3 Exam Notes:

1. After the candidate's fingerprint verification fails, please get off the bus and re-collect the fingerprint before queuing up again for the test;

2. During the test, if the candidate's score is lower than the passing score, the system will automatically prompt the candidate to pull over.

After the pullover action is completed, the system will prompt you to take the next test;

3. After the candidate completes all the required items as required and the driving distance is greater than 3 kilometers, the system will automatically prompt him to pull over. After hearing the sound of pulling over, students should choose a clear curbstone or a solid line on the edge of the road on the test route, and complete the pullover action after confirming that it is safe. After the pullover is completed, the system will broadcast the test result by voice;

4. When observing the appearance of the vehicle and the surrounding environment around the car, in order to ensure the accuracy of radar signal detection, please keep the distance between the person and the body within 1 meter.

Hello, subject three can step on the clutch when you step on the brakes.

Subject 3: When you step on the brakes, you must step on the clutch, otherwise the engine will turn off.

Subject 3 includes the road driving skills test and the safe and civilized driving knowledge test, which is a part of the motor vehicle driving license assessment, and is the abbreviation of the road driving skills and safe and civilized driving knowledge test subjects in the motor vehicle driver test. The content of the road driving skills test is different for different types of prospective vehicles.

Not necessarily, decelerate first and step on the brakes, and when the vehicle is underpowered, you must step on the gear with a lower clutch speed; If you pull over, you can step on the clutch first and then step on the brake, and pull the handbrake to hang neutral after the car stops steadily.