How do you tear off a mobile phone film? How to tear off the cell phone film

On one corner of the phone, find the tempered film.

and the gap between the mobile phone, the fingernails are inserted in it, and gently pick up.

If your fingernails aren't long enough, you can use a blade instead to pick at the light-colored bubbles that appear between the screen and the tempered film.

Using the same method, the same bubble is cut out on the other corner of the tempered film.

At this time, both hands work together to remove the tempered film. In this process, be sure to operate gently and carefully.

After removing the tempered film, remember to wipe it with a wet paper towel first, and then wipe it with a dry paper towel to absorb the dust and keep the screen tidy.

1. First of all, use tape to seal the amplifier, charging port, and other places that may enter the water with tape.

2. Prepare hot water above 70 degrees, and use a clean glasses cloth dipped in hot water to repeatedly wipe the mobile phone screen with the old film.

3. After a few minutes, the film on the screen will be a little loose, and then slowly tear it off with your fingers.

Mobile phone film is a consumable product, and it will be damaged if you don't pay attention to it, so how to tear off the mobile phone film? Let's take a look at a small method below. Tear off the old film, first find a sharp tool and pry up the corner.

Pry the other corner up, hold the tempered film at this time, and then slowly tear it off. If the toughened film is sticky and cannot be broken with your fingers, you need to use a hair dryer. Use a hot blow dryer to evenly heat the mobile phone film, the temperature is not too high, and you can tear it off directly by hand.

1.Tear off the old film, first find a sharp tool and pry up the corner.

2.Pry the other corner up, hold the tempered film at this time, and then slowly tear it off.

3.If the toughened film is sticky, you can't break it with your fingers, you need to use a hair dryer, use a hot hair dryer to evenly heat the mobile phone film, the temperature is not too high, and you can tear it off directly by hand.

1.Prepare some wide tape and stick it in the middle of the toughened film of your phone, leaving a long section at both ends.

2.Pull the tape up at one end and the toughened film can be removed.

Place your phone on a clean table and gently lift the phone wrap from the edge with your fingernails.

Then tear off the mobile phone film in slow motion along the lines of the phone.

The phone film can be torn off with a kick that is sharp, like a needle, or something.

Gently warp a corner along the side, and then grasp the corner and slowly tear it off.

Mainly buckle it from the edge, and then slowly tear it off.

The factory film is torn directly, or when the mobile phone film is replaced, the merchant is called.

This is a difficult question, first take out the phone, and then tear off the membrane with your hands.

They will give you detailed answers. Precautions: 1. In order to protect your legitimate rights and interests, when booking air tickets online, you must pay attention to check whether there is an online electronic logo issued by the Industrial and Commercial Bureau, an ICP certificate number issued by the telecommunications department, and an international aviation SSSSS

Just pry one of the edges with your fingernail and remove it when bubbles appear on the screen.

1. Put your phone on a stable desktop. The phone case, or phone buckle, should be removed from the phone. 2. Along the edge of the phone, gently buckle the corner of the tempered film with your fingernails.

If you don't have nails, you can use a toothpick, or a corner of plastic scissors instead. When the corner of the tempered film is lifted, the tempered film can be broken down along the direction of the paste. 4. It cannot be deducted.

Summary. Hello! The method of tearing off the mobile phone film, method one:

First of all, you should not scratch the screen of your phone with a sharp blade. Prepare tools, hot water above 80 degrees, a piece of cloth, alcohol (2 yuan for 1 bottle in the drugstore), a little scotch tape. Then start the action and use scotch tape to paste off the horn and microphone to prevent water from entering.

Start to warm the screen with hot water 7-10 times, you can tear it off by hand, if it is not thorough, repeat it, wipe off the screen glue with alcohol, tear off the speaker microphone hole tape, and paste a new film. Of course, it is better to find a more professional person to replace it, which is more secure. Method 2:

When taking the tempered film, use the wide tape to stick to the top first, and then use your fingernails to scratch it in little by little, and lift the tape to remove the whole tempered glass film. Method 3: As long as you gently pick the corners of the toughened protective film of the mobile phone with your fingernails, it will appear a little blister.

Then the protection can be torn off directly, and there will be no glue on it, which is very easy and convenient. If it is a very common and cheap protective film, you can take off the forehead by carefully picking out a corner at the corner of the protective film with the tip of a very sharp knife, or constantly picking it out by hand.

Hello! The method of tearing off the mobile phone film, method 1: First of all, you should not scratch the mobile phone screen with a sharp blade.

Prepare tools, hot water above 80 degrees, a piece of cloth, alcohol (2 yuan for 1 bottle in the drugstore), a little scotch tape. Then start the action and use scotch tape to paste off the horn and microphone to prevent water from entering. Start to warm the screen with hot water 7-10 times, you can tear it off by hand, if it is not thorough, repeat it, wipe off the screen glue with alcohol, tear off the tape of the microphone hole of the vertical horn, and paste a new film.

Of course, it is better to find a more professional person to replace it, which is more secure. Method 2: When taking the tempered film, use the wide tape to first stick the top of the spine finch to sell, and then use your fingernails to scratch it a little bit of cherry blossoms, and lift the tape to remove the whole piece of tempered glass film.

Method 3: As long as you gently pick the corners of the toughened protective film of the mobile phone with your fingernails, it will appear a little blister. Then the protection can be torn off directly, and there will be no glue on it, which is very easy and convenient.

If it is a very common and cheap protective film, you can take off the forehead by carefully picking out a corner at the corner of the protective film with the tip of a very sharp knife, or constantly picking it out by hand.

Hello! The above is how to tear off the mobile phone film.

If you are using a vivo mobile phone, you can use a fingernail or toothpick, gently a corner along the corner of the film, and then lift the whole piece with a little force in the direction of the film.

Attach the tape to the phone screen, press it tightly, and tear it off along one corner.

Tool Material: Adhesive tape.

1. First of all, attach the tape to the phone screen.

2. Then press the tape tightly.

3. After that, set off a corner.

4. Then along the side of the phone, lift it up.

5. Finally, the mobile phone film was successfully torn off.

Notes:After the tape is attached to the phone screen, be sure to press it tightly before it can be completely removed.

Summary. 1. When you want to replace or tear off the tempered film directly, you only need to pull it hard along the corners and gaps where the tempered film is in contact with the mobile phone. Because the tempered film itself is a whole, as long as the tempered film is not particularly broken, and the mobile phone screen itself is not damaged, it will be torn off directly.

2. If the plastic scraper is too firmly glued to the screen, the shape of the tempered film is too close to the mobile phone screen, and it cannot be "manually" torn off through the gap between the tempered film and the mobile phone screen.

1. When you want to replace or tear off the tempered film directly, you only need to pull it hard along the corners and gaps where the tempered film is in contact with the mobile phone. Because the tempered film itself is a whole, as long as the tempered film is not particularly broken, and the mobile phone screen itself is not damaged, it will be torn off directly. 2. If the plastic scraper is too firmly glued to the screen, the shape of the tempered film is too close to the mobile phone screen, and it cannot be "manually" torn off through the gap between the tempered film and the mobile phone screen.

Can you tell us more about that?

If the film is relatively hard and tight, you can use a hard object spatula.