What to do if the tempered film can t be torn off, the toughened film can t be torn off

1. Use a knife to insert the tempered film, insert it in parallel to avoid damaging the mobile phone, and then pry it up slightly until it blisters, pry up the four corners, and then break the two corners with your fingers and pull it up, and the tempered film can be easily taken down.

2. After the tempered film is pry open and blistered, stick the transparent tape on the surface of the tempered film, and then pull it hard, and the tempered film can be easily removed.

3. Turn the hair dryer on the mid-range, heat the tempered film evenly with hot air, and then tear off the tempered film by hand, paying attention to the temperature not too high, so as not to damage the screen.

4. Insert the tempered film from below with an eyebrow scraper or a plastic seal, work card, etc., and then pull up in parallel to remove the tempered film.

5. If it really doesn't work, you can only break the tempered film, and then tear it down slowly, and finally wipe the residual offset with alcohol or an eraser.

Method 1: 1. First of all, you can't scratch the mobile phone screen with a sharp blade;

2. Prepare tools, hot water above 80 degrees, a piece of cloth, alcohol (2 yuan for 1 small bottle in the pharmacy), and a little scotch tape;

3. Then start the action and use scotch tape to paste off the speaker and microphone to prevent water from entering.

4. Start to warm the screen with hot water 7-10 times, you can tear it off by hand, if it is not thorough, repeat it, wipe off the screen glue with alcohol, tear off the speaker microphone hole tape, and paste a new film.

Method 2: When taking the tempered film, use the wide tape to stick to the top first, and then use your fingernails to scratch it in little by little, and lift the tape to remove the whole tempered glass film.

Method 3: 1. As long as you gently pick the corners of the toughened glass protective film of the mobile phone with your fingernails, it will appear a little blister;

2. Then tear off the tempered glass protective film directly, and there will be no glue on it, which is very easy and convenient. If it is a very ordinary protective film, you can use the tip of the knife to carefully remove a corner at the corner of the protective film, or keep picking it out with your hand.

Tempered film. If you can't tear it off, you can do it like this:

1.Use a knife to insert the ground of the tempered film, in parallel to avoid damaging the phone, and then slightly upturn until it blisters;

2.All four corners.

To warp up, and then the fingers break the two corners and pull up, and the tempered film can be easily removed;

3.If the toughened film is sticky and can't be broken with your fingers, you can use transparent tape to stick it to the surface of the toughened film after prying open the blistering, and then pull it hard, and the toughened film can be easily removed;

4.If it still doesn't work, then you have to use a hot hair dryer, use a hot hair dryer to evenly heat the tempered film, don't bake too high, and then you can tear it off directly by hand;

5.There is no hair dryer.

If you can, you can use hot water instead, apply a hot towel to the tempered film, and then use your fingers to tear off the film;

6.If it doesn't work anymore, you can only tear it off destructively, break the tempered film little by little, and then tear it down slowly, so that it can be done.

The tempered film cannot be torn off because the quality of AB glue is not good.

Not only does it destroy the screen, but it can also cause potential danger. You can only gently and little by little, and then carefully wipe the screen with alcohol (wet wipes). During the process, don't use too much force, on the one hand, to prevent scratching the screen, and on the other hand, to prevent the tempered film from scratching yourself.

What should I do if the tempered film sticks too tightly? 5 methods to teach you how to easily remove the tempered film!

The hair dryer didn't work, there was no better tool than a kitchen knife, so I used a kitchen knife to cut off the tempered film.

Due to the limitations of the network platform, it is impossible to view the specific situation of the mobile phone, it is recommended that you bring the purchase invoice and the three-guarantee certificate to send the mobile phone to your nearest after-sales service center, so that the engineer can help you detect and deal with it.

Just blow a hair dryer on the area where you can't tear it off.

Summary. Apply a hot towel to the tempered film and use your fingers to peel the film off.

Can you show me?

It's sticky. Use scotch tape to stick to the surface of the tempered film and pull firmly on it.

If it doesn't work, is there any other way?

Yes. What's the solution?

Apply a hot towel to the tempered film and use your fingers to peel the film off.

That's how I came down last time.

Yes. I'm in the classroom now, I'll try it when I go back to the dorm, thank you.

Mmmmmm

Tempered film. And mobile phones have become a must-have combination. But when the mobile phone uses an inferior tempered film, the tempered film is very strong and sticks to the mobile phone after a few months, and it can't be torn off at all. It's okay, I'll tell you the ultimate solution.

1. The tools that need to be prepared are really very daily: a pair of scissors and a pair of gloves. The scissors used must be relatively sharp, and the best thing is that the scissors have sharp heads, not right angles, but sharp angles.

What is the purpose of the glove, which is to protect the hand from getting hurt. After all, if the tempered film is destroyed, it will be separated into flakes and granules, which is often referred to as glass ballast. The function of scissors is very simple and clear, that is, to use scissors as a tool to pry open the tempered film.

2. Scissors can protect the mobile phone screen well because of their own special structure. However, be sure to pay attention to the technique, the use of scissors in the vertical direction will greatly increase the risk of scratching the screen. After putting on the gloves, make sure the scissors do not hurt your hands.

At this time, you need to separate the scissors, use one end of the scissors as the starting point and support point, and start to pry up from one corner of the phone. In this process, you can start with a complete tempered film first, and don't pick the tempered film that has been broken.

3. Be sure to use a slow speed. Be sure to do it slowly and patiently. Use a little force to pry open a small corner of the toughened film of the mobile phone, and after that, the tempered film will crack, and there will be a lot of glass ballast.

At this time, in addition to paying attention to the safety of your hands, you also need to pay attention to your eyes not to be injured by the glass ballast that appears, and you can close your eyes slightly. It should be noted that at this time, you should not give up the scissors and pull them directly by hand because there is a little gap. So when can you use your hands?

That is, when one-third or more of the tempered film is warped, you can start to gently pull it. After a slow, patient operation, the tempered film will detach from the phone screen.

4. If it is difficult for the tempered film to be separated from the mobile phone, at this time, you can use some water-like products such as cleaning water and disinfectant to spray between the tempered film and the mobile phone to help the tempered film detach from the mobile phone. After a complete detachment, you can also use wipes to wipe the screen of your phone.

The above is the method that I shared with you that the tempered film cannot be torn off alive or dead, and you must protect your hands when tearing the tempered film, you can wear gloves or use cloth strips. Otherwise, the hand will be prone to minor wounds.